- 您現在的位置：買賣IC網 > PDF目錄19497 > DSP56321VL275 (Freescale Semiconductor)IC DSP 24BIT 275MHZ 196-MAPBGA PDF資料下載
參數資料
| 型號： | DSP56321VL275 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 60/84頁 |
| 文件大小： | 0K |
| 描述： | IC DSP 24BIT 275MHZ 196-MAPBGA |
| 標準包裝： | 126 |
| 系列： | DSP56K/Symphony |
| 類型： | 定點 |
| 接口： | 主機接口，SSI，SCI |
| 時鐘速率： | 275MHz |
| 非易失內存： | ROM（576 B） |
| 芯片上RAM： | 576kB |
| 電壓 - 輸入/輸出： | 3.30V |
| 電壓 - 核心： | 1.60V |
| 工作溫度： | -40°C ~ 100°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 196-FBGA |
| 供應商設備封裝： | 196-MAPBGA（15x15） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁當前第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁
Power Consumption Considerations
DSP56321 Technical Data, Rev. 11
Freescale Semiconductor
4-3
Consider all device loads as well as parasitic capacitance due to PCB traces when you calculate
capacitance. This is especially critical in systems with higher capacitive loads that could create higher
transient currents in the VCC and GND circuits.
All inputs must be terminated (that is, not allowed to float) by CMOS levels except for the three pins with
internal pull-up resistors (TRST, TMS, DE).
The following pins must be asserted during the power-up sequence: RESET and TRST. A stable EXTAL
signal should be supplied before deassertion of RESET. If the VCC reaches the required level before
EXTAL is stable or other “required RESET duration” conditions are met (see Table 2-7), the device
circuitry can be in an uninitialized state that may result in significant power consumption and heat-up.
Designs should minimize this condition to the shortest possible duration.
Ensure that during power-up, and throughout the DSP56321 operation, VCCQH is always higher or equal to
the VCCQL voltage level.
If multiple DSP devices are on the same board, check for cross-talk or excessive spikes on the supplies due
to synchronous operation of the devices.
The Port A data bus (D[0–23]), HI08, ESSI0, ESSI1, SCI, and timers all use internal keepers to maintain the
last output value even when the internal signal is tri-stated. Typically, no pull-up or pull-down resistors
should be used with these signal lines. However, if the DSP is connected to a device that requires pull-up
resistors (such as an MPC8260), the recommended resistor value is 10 K
or less. If more than one DSP
must be connected in parallel to the other device, the pull-up resistor value requirement changes as
follows:
—2 DSPs = 5 K
(mask sets 0K91M and 1K91M)/7 K (mask set 0K93M) or less
—3 DSPs = 3 K
(mask sets 0K91M and 1K91M)/4 K (mask set 0K93M) or less
—4 DSPs = 2 K
(mask sets 0K91M and 1K91M)/3 K (mask set 0K93M) or less
—5 DSPs = 1.5 K
(mask sets 0K91M and 1K91M)/2 K (mask set 0K93M) or less
—6 DSPs = 1 K
(mask sets 0K91M and 1K91M)/1.5 K (mask set 0K93M) or less
Note:
Refer to EB610/D DSP56321/DSP56321T Power-Up Sequencing Guidelines for detailed information
about minimizing power consumption during startup.
4.3 Power Consumption Considerations
Power dissipation is a key issue in portable DSP applications. Some of the factors affecting current consumption
are described in this section. Most of the current consumed by CMOS devices is alternating current (ac), which is
charging and discharging the capacitances of the pins and internal nodes.
Current consumption is described by this formula:
Equation 3:
Where:
C
=
node/pin capacitance
V
=
voltage swing
f
=
frequency of node/pin toggle
Example 4-1. Current Consumption
For a Port A address pin loaded with 50 pF capacitance, operating at 3.3 V, with a 66 MHz clock, toggling at its maximum possible rate (33
MHz), the current consumption is expressed in Equation 4.
IC
V
f
×
=
相關PDF資料 |
PDF描述 |
|---|---|
| HCM03DSUN | CONN EDGECARD 6POS .156 DIP SLD |
| GMA50DRST-S288 | CONN EDGECARD 100POS .125 EXTEND |
| ABM36DRST-S288 | CONN EDGECARD EXTEND 72POS .156 |
| ACM28DTAH-S189 | CONN EDGECARD 56POS R/A .156 SLD |
| DSP56321VL240 | IC DSP 24BIT 240MHZ 196-MAPBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSP56321VL275 | 制造商:Freescale Semiconductor 功能描述:Digital Signal Processor (DSP) IC |
| DSP56362 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:24-Bit Audio Digital Signal Processor |
| DSP56362AD | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:24-Bit Audio Digital Signal Processor |
| DSP56362D | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:24-Bit Audio Digital Signal Processor |
| DSP56362EVMUPUM | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP56362EVMUPUM DPSD56362EVM Upgrade Manual Revision 3.1 |
發布緊急采購，3分鐘左右您將得到回復。