參數資料
型號： FMS7401LEN14
廠商： FAIRCHILD SEMICONDUCTOR CORP
元件分類： 微控制器/微處理器
英文描述： Digital Power Controller
中文描述： 8-BIT, EEPROM, 2.04 MHz, MICROCONTROLLER, PDIP14
封裝： PLASTIC, DIP-14
文件頁數： 10/80頁
文件大小： 1535K
代理商： FMS7401LEN14
FMS7401/7401L
PRODUCT SPECIFICATION
10
REV. 1.0.2 6/23/04
2
Clock Circuit
The FMS7401/7401L may be clocked using its internal oscillator circuit or using an external digital clock signal. The desired
clock source is selectable by the CMODE bit of the Initialization Register 1.
updated and the desired clock source (also called the device reference clock or F
are defaulted from the factory to use the internal oscillator as their main system instruction clock source. After power-up, the
internal oscillator runs continuously unless entering Halt Mode or using an external clock source.
1
During the reset sequence, the CMODE bit is
) takes control of the device. All devices
RCLK1
Table 2. CMODE Bit Definition
The internal oscillator signal is factory trimmed to yield the F
of the datasheet. If the external digital clock is selected, the input signal must have a 50/50 duty cycle, can range from DC to
the F
OSC
, and must be available upon power-up. When the device is driven using an external clock source, the clock input to the
device should be provided through the AIN3/G1 input.
OSC
frequency as specified in the
Electrical Characteristics
section
Once the source of F
the Programmable Comparator circuit, and is divided-by-2 to be used as the main system instruction clock (F
(see
Figure 3
and
Figure 4
).
RCLK1
is selected, the clock is then used as the reference clock for the PLL, the clock to the digital filter in
ICLK
) of the device
2.1
The FMS7401/7401L has an internal digital clock multiplier (PLL) that steps-up the F
tor of 32. The multiplied PLL output is then divided by a factor of 1, 2, 4, and 8 in order to generate its programmable output
frequencies that may be used as the main system instruction clock or by the PWM Timer 1 circuit. The PLL provides the ability
to run the PWM Timer 1 circuit at a frequency as high as 64MHz while the rest of the device operates at a much slower fre-
quency keeping the total current consumption low.
PLL
RCLK1
frequency by a multiplication fac-
The reference clock of the PLL is defined by the F
signal. In order to yield the proper output frequencies offered by the PLL, F
fied in the
Electrical Characteristics
section of the datasheet. In the case that F
the REFBY2 bit in the ADCNTRL2 register
quency of the F
RCLK2
signal. Once the REFBY2 bit is set, the F
grammable Comparator circuit operates at a F
must be supplied at the specified F
OSC
frequency in order to meet the specified F
RCLK2
signal (as shown in
Figure 3
and
Figure 4
) and sourced by the F
must operate at the F
is operating at the upper F
must be set in order to divide the F
RCLK1
signal that drives the PLL and digital filter in the Pro-
/2 frequency. If an external digital clock is sourcing F
frequency of the F
RCLK1
RCLK2
PLL
frequency as speci-
frequency,
RCLK1
OSC
2
3
by 2 to yield the appropriate F
PLL
fre-
RCLK2
RCLK1
RCLK1
, the input signal
signal.
PLL
RCLK2
Table 3. PLL Frequency Selection (F
PLL
/F
OSC
= 2MHz)
The PLL outputs may be used to clock both the PWM Timer 1 circuit and the main system clock. However, the PLL must first
be enabled by setting the PLLEN bit of the PSCALE register.
Once set, the PLL is turned on and begins the locking phase.
Before using any of the PLL outputs, software must wait the T
PLL_LOCK
quency and in phase. The PLLEN bit may not be changed while the PWM Timer 1 circuit is in run mode.
to this bit during this condition will not change its value.
4
to ensure that the PLL is locked into its appropriate fre-
5
Any write attempts
The PWM Timer 1 circuit may be clocked either by the PLL’s F
bit of the PSCALE register
selects between the PLL’s F
not be set if the PLL is not enabled (PLLEN=0) or changed while the PWM Timer 1 circuit is in run mode.
5
Any write attempts
to this bit during these conditions will not change its value.
PWMCLK
output or by the main system clock (F
PWMCLK
output (if FSEL=1) or F
ICLK
(if FSEL=0). The FSEL bit may
ICLK
). The FSEL
4
CMODE
F
RCLK1
Clock Source
0
Internal Oscillator (@ F
OSC
)
1
External digital clock (G1/AIN3)
FS[1:0]
F
RCLK2
F
ICLK
(FMODE = 0)
F
ICLK
(FMODE = 1)
F
PWMCLK
0
0
2 MHz
1 MHz
8 MHz
8 MHz
0
1
2 MHz
1 MHz
8 MHz
16 MHz
1
0
2 MHz
1 MHz
8 MHz
32 MHz
1
1
2 MHz
1 MHz
8 MHz
64 MHz
相關PDF資料
PDF描述
FMS7401LVN Digital Power Controller
FMS7401LVN14 Digital Power Controller
FMS7G10US60S SWTCH ROLLER SPDT 20A SCRW TERM
FMS7G10US60 SWTCH ROLLER SPDT 20A SOLD TERM
FMS7G15US60S SWTCH LEVER SPDT 20A SCREW TERM
相關代理商/技術參數
參數描述
FMS7401LEN14_Q 功能描述:處理器 - 專門應用 Int Controller for Ballast RoHS:否 制造商:Freescale Semiconductor 類型:Multimedia Applications 核心:ARM Cortex A9 處理器系列:i.MX6 數據總線寬度:32 bit 最大時鐘頻率:1 GHz 指令/數據緩存: 數據 RAM 大小:128 KB 數據 ROM 大小: 工作電源電壓: 最大工作溫度:+ 95 C 安裝風格:SMD/SMT 封裝 / 箱體:MAPBGA-432
FMS7401LVN 功能描述:處理器 - 專門應用 Int Controller for Ballast RoHS:否 制造商:Freescale Semiconductor 類型:Multimedia Applications 核心:ARM Cortex A9 處理器系列:i.MX6 數據總線寬度:32 bit 最大時鐘頻率:1 GHz 指令/數據緩存: 數據 RAM 大小:128 KB 數據 ROM 大小: 工作電源電壓: 最大工作溫度:+ 95 C 安裝風格:SMD/SMT 封裝 / 箱體:MAPBGA-432
FMS7401LVN14 功能描述:8位微控制器 -MCU Int Controller for Ballast RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
FMS7401LVN14_Q 功能描述:8位微控制器 -MCU Int Controller for Ballast RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
FMS75X6 功能描述:MAGENTIC STRIP .75" X 6' RoHS:否 類別:線纜，導線 - 管理 >> 線槽，走線系統 - 附件 系列:- 標準包裝:1 系列:PANDUCT® 附件類型:蓋 - 線管 適用于相關產品:Panduit 導管 H 型 高度:- 寬:4"（101.6mm） 長度:36.0"（914.4mm） 顏色:黑 其它名稱:298-HC4BL36
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*