- 您現在的位置：買賣IC網 > PDF目錄1924 > IDT82P2916BFG (IDT, Integrated Device Technology Inc)IC LIU T1/E1/J1 16CH SH 484BGA PDF資料下載
參數資料
| 型號： | IDT82P2916BFG |
| 廠商： | IDT, Integrated Device Technology Inc |
| 文件頁數： | 70/138頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LIU T1/E1/J1 16CH SH 484BGA |
| 標準包裝： | 84 |
| 功能： | 線路接口單元（LIU） |
| 接口： | E1，J1，T1 |
| 電路數： | 16 |
| 電源電壓： | 1.8V, 3.3V |
| 功率（瓦特）： | 3.10W |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 484-LFBGA |
| 供應商設備封裝： | 484-CABGA（19x19） |
| 包裝： | 托盤 |
| 包括： | AIS 警報檢測器和發生器，回送功能，PRBS 發生器 / 檢測器，遠程檢測器和發生器 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁當前第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁
IDT82P2916
16-CHANNEL HIGH-DENSITY T1/E1/J1 LINE INTERFACE UNIT
Functional Description
37
April 24, 2010
3.5.3
LOSS OF SIGNAL (LOS) DETECTION
The IDT82P2916 detects three kinds of LOS:
LLOS: Line LOS, detected in the receive path;
SLOS: System LOS, detected in the transmit system side;
TLOS: Transmit LOS, detected in the transmit line side.
3.5.3.1 Line LOS (LLOS)
The amplitude and density of the data received from the line side are
monitored. When the amplitude of the data is less than Q Vpp for N
consecutive pulse intervals, LLOS is declared. When the amplitude of
the data is more than P Vpp and the average density of marks is at least
12.5% for M consecutive pulse intervals starting with a mark, LLOS is
cleared. Here Q is defined by the ALOS[2:0] bits (b6~4, LOS,...). P is the
sum of Q and 250 mVpp. N and M are defined by the LAC bit (b7,
In T1/J1 mode, LLOS detection supports ANSI T1.231 and I.431. In
E1 mode, LLOS detection supports G.775 and ETSI 300233/I.431. The
criteria are selected by the LAC bit (b7, LOS,...).
When LLOS is detected, the LLOS_S bit (b0, STAT0,...) will be set. A
transition from ‘0’ to ‘1’ on the LLOS_S bit (b0, STAT0,...) or any transi-
tion (from ‘0’ to ‘1’ or from ‘1’ to ‘0’) on the LLOS_S bit (b0, STAT0,...) will
set the LLOS_IS bit (b0, INTS0,...) to ‘1’, as selected by the LOS_IES bit
(b1, INTES,...). When the LLOS_IS bit (b0, INTS0,...) is ‘1’, an interrupt
will be reported by INT if not masked by the LLOS_IM bit (b0, INTM0,...).
Two pins (LLOS0 and LLOS) are dedicated to LLOS indication.
Whether LLOS is detected in channel 0 or not, LLOS0 is high for a
CLKE1 clock cycle to indicate the start position on LLOS. LLOS indi-
cates LLOS status of all 16 channels in a serial format and repeats every
16 cycles. Refer to Figure-20. LLOS0 and LLOS are updated on the
rising edge of CLKE1. When the clock output on CLKE1 is disabled,
LLOS0 and LLOS will be held in High-Z state. The output on CLKE1 is
controlled by the CLKE1_EN bit (b3, CLKG) and the CLKE1 bit (b2,
CLKG). Refer to section 8.11 on page 125 for CLKE1 timing characteris-
tics.
LLOS may be counted by an internal Error Counter or may be indi-
cated by the RMFn pin. Refer to Section 3.5.6 Error Counter and
Section 3.5.7.1 RMFn Indication respectively.
During LLOS, in Receive Single Rail NRZ Format mode, Receive
Dual Rail NRZ Format mode and Receive Dual Rail RZ Format mode,
RDPn/RDNn output low level. In Receive Dual Rail Sliced mode RDPn/
RDNn still output sliced data. RCLKn (if available) outputs high level or
During LLOS, if any of AIS, pattern generation in the receive path or
Digital Loopback is enabled or automatic digital loopback happens,
RDPn/RDNn and RCLKn output corresponding data and clock, and the
setting of the RCKH bit (b7, RCF0,...) is ignored. Refer to the corre-
sponding chapters for details.
Figure-20 LLOS Indication on Pins
1. XCLK is derived from MCLK. It is 1.544 MHz in T1/J1 mode or 2.048 MHz
in E1 mode.
Table-17 LLOS Criteria
Operation
Mode
LAC
Criteria
LLOS Declaring
LLOS Clearing
T1/J1
0
ANSI T1.231
below Q Vpp, N = 175 bits above P Vpp, 12.5% mark density with less than 100 consecutive zeros, M = 175 bits
1
ANSI I.431
below Q Vpp, N = 1544 bits above P Vpp, 12.5% mark density with less than 100 consecutive zeros, M = 175 bits
E1
0
G.775
below Q Vpp, N = 32 bits
above P Vpp, 12.5% mark density with less than 16 consecutive zeros, M = 32 bits
1
ETSI 300233/
I.431
below Q Vpp, N = 2048 bits
above P Vpp, 12.5% mark density with less than 16 consecutive zeros, M = 32 bits
One LLOS Indication Cycle
LLOS
LLOS0
CLKE1
CH0 CH1
CH14 CH15
01
2
314
15
0
CH0
相關PDF資料 |
PDF描述 |
|---|---|
| IDT82P5088BBG | IC LIU T1/E1/J1 OCTAL 256PBGA |
| IDT82V2041EPPG | IC LIU T1/J1/E1 1CH 44-TQFP |
| IDT82V2042EPFG | IC LIU T1/J1/E1 2CH SHORT 80TQFP |
| IDT82V2044EPFG | IC LIU T1/E1 QUAD SHORT 128-TQFP |
| IDT82V2048DAG | IC LIU T1/E1 8CH SHORT 144-TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IDT82P2916BFG8 | 制造商:Integrated Device Technology Inc 功能描述:IC LIU T1/E1/J1 16CH SH 484BGA |
| IDT82P5088 | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:Universal Octal T1/E1/J1 LIU with Integrated Clock Adapter |
| IDT82P5088BBBLANK | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:Universal Octal T1/E1/J1 LIU with Integrated Clock Adapter |
| IDT82P5088BBG | 功能描述:IC LIU T1/E1/J1 OCTAL 256PBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
| IDT82P5088BBG8 | 制造商:Integrated Device Technology Inc 功能描述:IC LIU T1/E1/J1 OCTAL 256PBGA |
發布緊急采購，3分鐘左右您將得到回復。