參數資料
型號: IS83C154TXXX-25D
廠商: ATMEL CORP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 25 MHz, MICROCONTROLLER, PQCC44
封裝: PLASTIC, LCC-44
文件頁數: 64/101頁
文件大?。?/td> 3398K
代理商: IS83C154TXXX-25D
88
8168C-MCU Wireless-02/10
AT86RF212
Note that IEEE 802.15.4–2006 CCA mode 3 defines the logical combination of CCA
mode 1 and 2 with the logical operators AND or OR. This can be selected with:
o
CCA_MODE = 0
for logical operation OR, and
o
CCA_MODE = 3
for logical operation AND.
Bit 4:0 – CHANNEL
Refer to section 7.8.6.
Register 0x09 (CCA_THRES):
This register sets the ED threshold level for CCA.
Table 6-35. Register 0x09 (CCA_THRES)
Bit
7
6
5
4
Name
Reserved
Read/Write
R/W
Reset Value
0
1
Bit
3
2
1
0
Name
CCA_ED_THRES
Read/Write
R/W
Reset Value
0
1
Bit 7:4 – Reserved
Bit 3:0 – CCA_ED_THRES
For CCA_MODE = 1, a busy channel is indicated if the measured received power is
above (RSSI_BASE_VAL + 2.07
CCA_ED_THRES) [dBm]. CCA modes 0 and 3 are
logically related to this result.
6.7 Listen Before Talk (LBT)
6.7.1 Overview
Equipment using the AT86RF212 shall conform to the established regulations. With
respect to the regulations in Europe, CSMA-CA based transmission according to IEEE
802.15.4 is not appropriate. In principle, transmission is subject to low duty cycles (0.1
to 1 %). However, according to [5], equipment employing listen before talk (LBT) and
adaptive frequency agility (AFA) does not have to comply with duty cycle conditions.
Hence, LBT can be attractive in order to reduce network latency.
Minimum Listening Time
A device with LBT needs to comply with a minimum listening time, refer to section
9.1.1.2 of [5]. Prior transmission, the device must listen for a receive signal at or above
the LBT threshold level to determine whether the intended channel is available for use,
unless transmission is pursuing acknowledgement.
A device using LBT needs to listen for a fixed period of 5 ms. If the channel is free after
this period, transmission may immediately commence (i.e. no CSMA is required).
Otherwise, a new listening period of a randomly selected time span between 5 and 10
ms is required. The time resolution shall be approximately 0.5 ms. The last step needs
to be repeated until a free channel is available.
相關PDF資料
PDF描述
IF180C52EXXX-L16:R 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP44
MQ80C52CXXX-20/883R 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQFP44
MJ80C31U-36:D MICROCONTROLLER
R80C52XXX-12SHXXX 8-BIT, MROM, 12 MHz, MICROCONTROLLER, CQCC44
MQ80C32-12SBR 8-BIT, 12 MHz, MICROCONTROLLER, CQFP44
相關代理商/技術參數
參數描述
IS83D 制造商:IDEC CORPORATION 功能描述:SENS.IND. 2W/F 24-230VAC NO
IS83DK 制造商:IDEC CORPORATION 功能描述:SENS.IND. 2W/F 24-230VAC NO
IS83DL 制造商:IDEC CORPORATION 功能描述:SENS.IND. 2W/F 24-230VAC NO
IS83K 制造商:IDEC CORPORATION 功能描述:SENS.IND. 2W/F 24-230VAC NO
IS83L 制造商:IDEC CORPORATION 功能描述:SENS.IND. 2W/F 24-230VAC NO