- 您現在的位置：買賣IC網 > PDF目錄16521 > KSZ8841-PMQL-EVAL (Micrel Inc)BOARD EVALUATION KSZ8841-PMQL PDF資料下載
參數資料
| 型號： | KSZ8841-PMQL-EVAL |
| 廠商： | Micrel Inc |
| 文件頁數： | 14/74頁 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION KSZ8841-PMQL |
| 標準包裝： | 1 |
| 主要目的： | 接口，以太網控制器（PHY 和 MAC） |
| 嵌入式： | 否 |
| 已用 IC / 零件： | KSZ8841-PMQL |
| 主要屬性： | 1 個端口，100BASE-TX/10BASE-T |
| 次要屬性： | PCI 接口，LinkMD 線纜診斷 |
| 已供物品： | 板 |
| 產品目錄頁面： | 1114 (CN2011-ZH PDF) |
| 相關產品： | 576-2118-ND - IC MAC CTRLR 32BIT PCI 128-PQFP 576-2117-ND - IC MAC CTRLR 32BIT 128-PQFP |
| 其它名稱： | 576-1633 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
Micrel, Inc.
KSZ8841-PMQL
October 2007
21
M9999-100407-1.5
On the transmit side, the KSZ8841-PMQL has intelligent and efficient ways to determine when to invoke flow control.
The flow control is based on availability of the system resources.
The KSZ8841-PMQL issues a flow control frame (XON), containing the maximum pause time defined in IEEE standard
802.3x. Once the resource is freed up, the KSZ8841-PMQL sends out another flow control frame (XOFF) with zero
pause time to turn off the flow control (turn on transmission to the port). A hysteresis feature is provided to prevent the
flow control mechanism from being constantly activated and deactivated.
Half-Duplex Backpressure
A half-duplex backpressure option (non-IEEE 802.3 standards) is also provided. The activation and deactivation
conditions are the same as above in full-duplex mode. If backpressure is required, the KSZ8841-PMQL sends
preambles to defer the other stations' transmission (carrier sense deference).
To avoid jabber and excessive deference (as defined in the 802.3 standard), after a certain time, the KSZ8841-PMQL
discontinues the carrier sense and then raises it again quickly. This short silent time (no carrier sense) prevents other
stations from sending out packets thus keeping other stations in a carrier sense deferred state. If the port has packets
to send during a backpressure situation, the carrier sense type backpressure is interrupted and those packets are
transmitted instead. If there are no additional packets to send, carrier sense type backpressure is reactivated again until
chip resources free up. If a collision occurs, the binary exponential back-off algorithm is skipped and carrier sense is
generated immediately, thus reducing the chance of further colliding and maintaining carrier sense to prevent packet
reception.
The backpressure will take effect automatically in Auto-negotiation enable and half-duplex mode.
Clock Generator
The X1 and X2 pins are connected to a 25MHz crystal. X1 can also serve as the connector to the 3.3V 25MHz oscillator
(as described in the pin description).
EEPROM Interface
An external serial EEPROM with a standard microwire bus interface is used for non-volatile storage of information such
as the node address and subsystem ID.
As part of the initialization after system reset, the KSZ8841-PMQL reads the external EEPROM and places the data
into certain host-accessible registers if the EEEN pin is pulled-up, the KSZ8841-PMQL performs an automatic read of
the EEPROM word from 0x0 to 0x6 after the de-assertion of Reset. An EEPROM of 1KB(93C46) or 4KB(93C66) can be
used based on application.
The EEPROM read/write function can also be performed by software reading and writing to the EEPCR register.
The KSZ8841-PMQL EEPROM format is given in Table 2.
WORD
15
8
7
0
0x0
Reserved
0x1
MAC Address Byte 2
MAC Address Byte 1
0x2
MAC Address Byte 4
MAC Address Byte 3
0x3
MAC Address Byte 6
MAC Address Byte 5
0x4
0x5
0x6
0x7-0x3F
Subsystem ID
Subsystem Vendor ID
ConfigParam
Not used by KSZ8841-PMQL (available for user to use)
Table 2. KSZ8841-PMQL EEPROM Format
相關PDF資料 |
PDF描述 |
|---|---|
| M3CKK-1018R | IDC CABLE - MKC10K/MC10M/MPK10K |
| EBC40DCMD | CONN EDGECARD 80POS .100 WW |
| ECC22DCAT | CONN EDGECARD 44POS R/A .100 SLD |
| EBM08DRMN-S273 | CONN EDGECARD 16POS .156 WW |
| EBM08DRMD-S273 | CONN EDGECARD 16POS .156 WW |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8841-PMQLI | 功能描述:以太網 IC Single Ethernet Port + 32-bit/33MHz PCI interface, Ind Temp (Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8842 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:2-Port Ethernet Switch with PCI Interface |
| KSZ8842-16 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:2-Port Ethernet Switch with Non-PCI Interface |
| KSZ8842-16_08 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:2-Port Ethernet Switch with Non-PCI Interface |
| KSZ8842-16_1 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:2-Port Ethernet Switch with Non-PCI Interface |
發布緊急采購，3分鐘左右您將得到回復。