- 您現在的位置：買賣IC網 > PDF目錄385497 > LPC2939FBD208 (NXP SEMICONDUCTORS) ARM9 microcontroller with CAN, LIN, and USB PDF資料下載
參數資料
| 型號： | LPC2939FBD208 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | ARM9 microcontroller with CAN, LIN, and USB |
| 中文描述： | 32-BIT, FLASH, 125 MHz, RISC MICROCONTROLLER, PQFP208 |
| 封裝： | 28 X 28 MM, 1.40 MM HEIGHT, PLASTIC, SOT-459, MS-026, LQFP-208 |
| 文件頁數： | 48/99頁 |
| 文件大?。?/td> | 1945K |
| 代理商： | LPC2939FBD208 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁當前第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁
LPC2939_3
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 03 — 7 April 2010
48 of 99
NXP Semiconductors
LPC2939
ARM9 microcontroller with CAN, LIN, and USB
6.15.5.3
Master and slave mode
A PWM module can provide synchronization signals to other modules (also called Master
mode). The signal sync_out is a pulse of one clock cycle generated when the internal
PWM counter (re)starts. The signal trans_enable_out is a pulse synchronous to sync_out,
generated if a transfer from system registers to PWM shadow registers occurred when the
PWM counter restarted. A delay may be inserted between the counter start and
generation of trans_enable_out and sync_out.
A PWM module can use input signals trans_enable_in and sync_in to synchronize its
internal PWM counter and the transfer of shadow registers (Slave mode).
6.15.5.4
Pin description
Each of the four PWM modules in the MSCSS has the following pins. These are combined
with other functions on the port pins of the LPC2939.
Table 24
shows the PWM0 to PWM3
pins.
Table 24.
Symbol
PWMn CAP[0]
PWMn CAP[1]
PWMn CAP[2]
PWMn MAT[0]
PWMn MAT[1]
6.15.5.5
Clock description
The PWM modules are clocked by CLK_MSCSS_PWMx (x = 0 to 3), see
Section 6.7.2
.
Note that each PWM has its own CLK_MSCSS_PWMx branch clock for power
management. The frequency of all these clocks is identical to CLK_MSCSS_APB since
they are derived from the same base clock BASE_MSCSS_CLK.
Also note that unlike the timer modules in the Peripheral SubSystem, the actual timer
counter registers of the PWM modules run at the same clock as the APB system interface
CLK_MSCSS_APB. This clock is independent of the AHB system clock.
If a PWM module is not used its CLK_MSCSS_PWMx branch clock can be switched off.
6.15.6
Timers in the MSCSS
The two timers in the MSCSS are functionally identical to the timers in the peripheral
subsystem, see
Section 6.13.3
. The features of the timers in the MSCSS are the same as
the timers in the peripheral subsystem, but the capture inputs and match outputs are not
available on the device pins. These signals are instead connected to the ADC and PWM
modules as outlined in the description of the MSCSS, see
Section 6.15.1
.
See
Section 6.13.3
for a functional description of the timers.
PWM pins
Pin name
PCAPn[0]
PCAPn[1]
PCAPn[2]
PMATn[0]
PMATn[1]
Direction
IN
IN
IN
OUT
OUT
Description
PWM n capture input 0
PWM n capture input 1
PWM n capture input 2
PWM n match output 0
PWM n match output 1
PWMn MAT[2]
PWMn MAT[3]
PWMn MAT[4]
PWMn MAT[5]
PWMn TRAP
PMATn[2]
PMATn[3]
PMATn[4]
PMATn[5]
TRAPn
OUT
OUT
OUT
OUT
IN
PWM n match output 2
PWM n match output 3
PWM n match output 4
PWM n match output 5
PWM n trap input
相關PDF資料 |
PDF描述 |
|---|---|
| LPC3180FEL320 | 16-32-bit ARM microcontroller; hardware floating-point coprocessor, USB On-The-Go, and SDRAM memory interface |
| LPC3220FET296 | ARM926EJ-S with 128 kB SRAM, USB High-speed OTG, SD-MMC, NAND flash controller |
| LPC3230FET296 | ARM926EJ-S with 256 kB SRAM, USB High-speed OTG, SD-MMC, NAND flash controller, LCD controller |
| LPC3240FET296 | ARM926EJ-S with 256 kB SRAM, USB High-speed OTG, SD-MMC, NAND flash controller, Ethernet |
| LPV531 | Programmable Micropower CMOS Input, Rail-to-Rail Output Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC2939FBD208,551 | 功能描述:ARM微控制器 - MCU IC ARM9 MCU FLASH 768KB RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2939FBD208551 | 制造商:NXP Semiconductors 功能描述:MCU ARM9 208LQFP |
| LPC2939FET208,551 | 功能描述:ARM微控制器 - MCU LPC2939FET208/TFBGA208/TRAYBDP RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC-2FS01 | 制造商:Honda Tsushin Kogyo Co Ltd 功能描述:CABLE CRIMPING TYPE FEMALE INSULATOR |
| LPC3130 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-cost, low-power ARM926EJ-S MCUs with high-speed USB 2.0 OTG, SD/MMC, and NAND flash controller |
發布緊急采購，3分鐘左右您將得到回復。