參數資料
型號: M32000D4
廠商: Mitsubishi Electric Corporation
英文描述: SINGLE CHIP 32 BIT CMOS MICROCOMPUTER
中文描述: 單芯片32位CMOS微機
文件頁數: 20/45頁
文件大?。?/td> 535K
代理商: M32000D4
SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
M32000D4AFP
20
Internal DRAM access control (CS)
The internal DRAM can be accessed when CS is driven to an "L"
level after the M32000D4AFP enters the hold state (HACK = "L").
To access the internal DRAM from external, the following signals
from the system bus side should be controlled.
A8 to A30
Input internal DRAM addresses to be read or written.
BCH, BCL
Specify the byte position of data to be written into the internal
DRAM. BCH corresponds to the MSB side (D0 to D7), and BCL
corresponds to the LSB side (D8 to D15).
R/W
Specify read or write operation. When reading, R/W = "H". When
writing, R/W = "L".
D0 to D15
16-bit data I/O bus.
DC
This signal notifies to an external bus master that the internal
DRAM access is complete. When access is complete, an "L"
level is output to DC.
Read and write operations of the M32000D4AFP are carried out us-
ing the address bus, data bus, and the R/W, BCH, BCL and DC sig-
nals. When reading, the R/W signal goes to an "H" level, and the
BCH and BCL signals go to an "L" level. The CPU reads the data in
the valid byte positions. When writing, an "L" level is output from R/
W, and BCH and BCL are output according to the valid byte posi-
tions, so as to specify the byte positions for writing into an external
device.
pin name
BCH, BCL
ST, R/W, BS, BURST
D0 - D15
pin condition or operation
high-impedance
output when internal DRAM is read
by an external bus master (CS = "L",
__
R/W = "H"), otherwise high-impedance
output when internal DRAM is
accessed by an external bus master
__
(CS = "L"), otherwise high-impedance
output "L"
normal operation
__
__
DC
HACK
other pins
Table 1 Pin condition in hold state
idle
read
"H"
"H"
CLKIN
BS
A8 - A30
SID, ST
BCH, BCL
BURST
D0 - D15
DC
R/W
idle
read
idle
write
idle
write
CLKIN
BS
A8 - A30
SID, ST
BCH, BCL
BURST
D0 - D15
DC
R/W
"H"
"Hi-z"
"Hi-z"
"Hi-z"
"Hi-z"
Note:
"Hi-z" means high-impedance, and indicates sampling timing.
Fig. 16 Read/write timing (two no-wait accesses)
相關PDF資料
PDF描述
M32000D4AFP SINGLE CHIP 32 BIT CMOS MICROCOMPUTER
M32170F3VFP SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
M32174F3VFP SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
M32170F3VFG 32-BIT RISC SINGLE-CHIP MICROCOMPUTER
M32170F3VWG 32-BIT RISC SINGLE-CHIP MICROCOMPUTER
相關代理商/技術參數
參數描述
M32000D4AFP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE CHIP 32 BIT CMOS MICROCOMPUTER
M32000D4BFP-80 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 32-BIT CMOS MICROCOMPUTER
M32002AGLJ 制造商:MTRONPTI 制造商全稱:MTRONPTI 功能描述:9x14 mm, 3.3/2.5/1.8 Volt, PECL/LVDS/CML, VCXO
M32002AGMJ 制造商:MTRONPTI 制造商全稱:MTRONPTI 功能描述:9x14 mm, 3.3/2.5/1.8 Volt, PECL/LVDS/CML, VCXO
M32002AGPJ 制造商:MTRONPTI 制造商全稱:MTRONPTI 功能描述:9x14 mm, 3.3/2.5/1.8 Volt, PECL/LVDS/CML, VCXO