參數資料
型號: MC68HC05F8FU
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 1.8 MHz, MICROCONTROLLER, PQFP64
封裝: PLASTIC, QFP-64
文件頁數: 91/126頁
文件大?。?/td> 1084K
代理商: MC68HC05F8FU
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁當前第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
MC68HC05F8
MOTOROLA
7-3
SERIAL PERIPHERAL INTERFACE
7
7.2.2
Serial Data Output (SDO)
Data is transmitted in MSB rst format. The state of the SDO pin will always reect the value of
the rst bit receive on the previous transmission if there was one. Prior to enabling the SPI, PD5
can be initialized to determine the beginning state if a standard output since that pin is coupled to
the last stage of the serial shift register. On the first falling edge of SCK the rst data bit to be
shifted out is presented to the output pin.
7.2.3
Serial Data Input (SDI)
The SDI pin becomes an input as soon as the SPI pin on the falling edge of SCK. Valid data must
be present at least 112ns before the rising edge of the clock and remain valid for 112ns after the
edge.
7.3
General Operation
A block diagram of the serial peripheral interface (SPI) is shown in Figure 7-3. In a master
conguration, the master start logic originates the system clock (SCK) based on the 447.5KHz (or
the E/4) clock. This clock is also used internally to control the state controller as well as the 8-bit
shift register. As a master device, data is parallel loaded into the 8-bit shift register (from the
internal bus) during a write cycle, data is applied serially from a slave device via SDI pin to the
8-bit shift register. After the 8-bit shift register is loaded, its data is parallel transferred to the read
buffer and then is made available to the internal data bus a CPU read cycle.
In a slave conguration, the slave start logic receives a system clock input (from the master
device) at SCK pin. Thus, the slave is synchronized with the master. Data from the master is
received serially at the slave SDI and loads the 8-bit shift register. After the 8-bit shift register is
loaded, its data is parallel transferred to the read buffer and then is made available to the internal
data bus during a CPU read cycle. During a write cycle, data is parallel loaded into the 8-bit shift
register from the internal data bus and then shifted out serially to the SDO pin for application to
the master device.
One point to be noted, the SCK pin needs to be externally pulled high with 10K Ohms, in order to
bias the initial states at logic high.
7.4
SPI Registers
There are three registers associated with the serial parallel interface. They are the Serial
Peripheral Control register (SPCR, location $10), the Serial Peripheral Status register (SPSR,
location $11), and the Serial Peripheral Data I/O register (SPDR, location $12). Each register are
described below.
TPG
65
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
In
c
..
.
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
相關PDF資料
PDF描述
MC68HC05I8FU 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQFP64
MC68HC05J1DW 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO20
MC68HC05J1CP 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP20
MC68HC05J5AJDWR2 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO16
MC68HRC05J5ADWR3 8-BIT, MROM, MICROCONTROLLER, PDSO20
相關代理商/技術參數
參數描述
MC68HC05J1 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS MICROCONTROLLER UNIT
MC68HC05J1A 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05J1ACDW 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05J1ACP 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05J1ADW 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers