- 您現在的位置：買賣IC網 > PDF目錄45377 > MQ80C154-20P883 (ATMEL CORP) 8-BIT, 20 MHz, MICROCONTROLLER, CQFP44 PDF資料下載
參數資料
| 型號： | MQ80C154-20P883 |
| 廠商： | ATMEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, 20 MHz, MICROCONTROLLER, CQFP44 |
| 封裝： | CERAMIC, QFP-44 |
| 文件頁數： | 61/101頁 |
| 文件大?。?/td> | 3398K |
| 代理商： | MQ80C154-20P883 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁當前第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁
85
8168C-MCU Wireless-02/10
AT86RF212
The sub-register CCA_ED_THRES of register 0x09 (CCA_THRES) defines the receive
power threshold of the “energy above threshold” algorithm. The threshold is calculated
by
V_THRES [dBm] = RSSI_BASE_VAL + 2.07
CCA_ED_THRES .
Any received power above this level is interpreted as a busy channel.
Note that it is not recommended to manually initiate a CCA request when using the
Extended Operating Mode.
6.6.3 Data Interpretation
The current channel status (CCA_STATUS) and the CCA completion status
(CCA_DONE) are accessible through register 0x01 (TRX_STATUS). Note that register
bits CCA_DONE and CCA_STATUS are cleared in response to a CCA_REQUEST.
The completion of a measurement cycle is indicated by CCA_DONE = 1. If the radio
transceiver detects no signal (idle channel) during the CCA evaluation period, the
CCA_STATUS bit is set to 1; otherwise, it is set to 0.
When using the “energy above threshold” algorithm, a received power above V_THRES
level is interpreted as a busy channel.
When using the “carrier sense” algorithm (i.e. CCA_MODE = 0, 2, and 3), the
AT86RF212 reports a busy channel upon detection of a PHY mode specific
IEEE 802.15.4 signal above RSSI_BASE_VAL [dBm] (see Table 6-25). The
AT86RF212 is also capable of detecting signals below this value, but the detection
probability decreases with decreasing signal power. It is almost zero at the radio
transceivers sensitivity level (see parameter 10.7.1 on page 154).
6.6.4 Interrupt Handling
Interrupt IRQ_4 (CCA_ED_DONE) is issued at the end of a manually initiated CCA
measurement.
Note
A CCA request should only be initiated in Basic Operating Mode RX states.
Otherwise, the radio transceiver generates IRQ_4 (CCA_ED_DONE) and sets the
register bit CCA_DONE = 1, without actually performing a CCA measurement.
6.6.5 Measurement Time
The response time of a manually initiated CCA measurement depends on the receiver
state.
In RX_ON state, the CCA measurement is done over 8 symbol periods and the result is
accessible upon the event IRQ_4 (CCA_ED_DONE) or upon CCA_DONE = 1 (register
0x01, TRX_STATUS).
In BUSY_RX state, the CCA measurement duration depends on the CCA mode and the
CCA request relative to the detection of the SHR. The end of the CCA measurement is
indicated by IRQ_4 (CCA_ED_DONE). The variation of a CCA measurement period in
BUSY_RX state is described in Table 6-29.
相關PDF資料 |
PDF描述 |
|---|---|
| IR80C52CXXX-12:RD | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, CQCC44 |
| IS83C154TXXX-25D | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, PQCC44 |
| IF180C52EXXX-L16:R | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP44 |
| MQ80C52CXXX-20/883R | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQFP44 |
| MJ80C31U-36:D | MICROCONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MQ80C154-25 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MQ80C154-30 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MQ80C154-36 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MQ80C154-L16 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MQ80C186-10/BYA | 制造商:Rochester Electronics LLC 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。