30
MON08 Multilink User Manual
P&E
Microcomputer
Systems, Inc.
MON08 MULTILINK
4
PC-HOSTED DEBUG/PROGRAMMING SOFTWARE
Free or low-cost software options for interactively programming and
debugging 68HC08 MCUs from the PC are available from P&E
Microcomputer Systems (
www.pemicro.com
) and Metrowerks
(
www.metrowerks.com
). P&E’s ICS08 interface software packages are
available at no charge from their web site. Metrowerks’ CodeWarrior
Development Studio for 68HC08, Special Edition, is available at no charge
from the Motorola MCU Web site (
www.motorola.com/semiconductors/mcu
).
You must register for the license key for this software.
Note: The user should make sure they have the most recent version of these
software kits. The latest updates can be downloaded from the web pages listed
in
Section 4.1.1 Latest Updates - P&E Software
and
Section 4.2.1 Latest
Updates - Metrowerks Software
.
4.1
P&E Microcomputer Systems Software
P&E’s ICS08 software packages contain the WinIDE integrated development
environment, which pulls together an assembler, in-circuit simulator, flash
memory programmer, and in-circuit debugger. The programmer and debugger
work with any MON08 hardware interface, including P&E’s dedicated
hardware interfaces. The MON08 MULTILINK is a Class V device, and the
MON08 MULTILINK is Class VII.
Figure 4-28: Hardware Selection in P&E PROG08SZ
4.1.1
Latest Updates - P&E Software
The most recent updates of P&E’s 68HC08 software products are available to
download, after a brief registration, at http://www.pemicro.com/ics08.
4.1.2
In-Circuit Debugger
The ICD08SZ In-Circuit Debugger uses the PC’s Parallel Port to communicate
with the MON08 MULTILINK, which further controls the target 68HC08
device via the MON08 connection. With the ICD08SZ In-Circuit Debugger
you can load code into the on-chip RAM, run code out of RAM or FLASH