參數資料
型號： OM11079
廠商： NXP Semiconductors
文件頁數： 31/57頁
文件大?。?/td> 0K
描述： MODULE DIMM LPC3250 ARM9
標準包裝： 1
附件類型： 模塊卡
適用于相關產品： ARM-57TS-LPC3250
相關產品： 622-1033-ND - KIT LCD TOUCH 5.7" FOR LPC2478
568-4743-ND - KIT LCD TOUCH 5.7" FOR LPC3250
568-4741-ND - KIT LCD TOUCH 5.7" FOR LPC2478
622-1030-ND - KIT LCD TOUCH 5.7" FOR LPC3250
622-1028-ND - KIT LCD TOUCH 5.7" FOR LPC2478
其它名稱： 568-4744
LPC3220_30_40_50
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 2 — 20 October 2011
37 of 79
NXP Semiconductors
LPC3220/30/40/50
16/32-bit ARM microcontrollers
7.8.1 UARTs
The LPC3220/30/40/50 contains seven UARTs. Four are standard UARTs, and three are
high-speed UARTs.
7.8.1.1
Standard UARTs
The four standard UARTs are compatible with the INS16Cx50. These UARTs support
rates up to 460800 bit/s from a 13 MHz peripheral clock.
Features
Each standard UART has 64 byte Receive and Transmit FIFOs.
Receiver FIFO trigger points at 16, 32, 48, and 60 Bytes.
Transmitter FIFO trigger points at 0, 4, 8, and 16 Bytes.
Register locations conform to the “550” industry standard.
Each standard UART has a fractional rate pre-divider and an internal baud rate
generator.
The standard UARTs support three clocking modes: on, off, and auto-clock. The
auto-clock mode shuts off the clock to the UART when it is idle.
UART 6 includes an IrDA mode to support infrared communication.
The standard UARTs are designed to support data rates of (2400, 4800, 9600,
19200, 38400, 57600, 115200, 230400, 460800) bit/s.
Each UART includes an internal loopback mode.
7.8.1.2
High-speed UARTs
The three high-speed UARTs are designed to support rates up to 921600 bit/s from a
13 MHz peripheral clock for on-board communication in low noise conditions. This is
accomplished by changing the over sampling from 16
to 14 and altering the rate
generation logic.
Features
Each high-speed UART has 64-byte Receive and Transmit FIFOs.
Receiver FIFO trigger points at 1, 4, 8, 16, 32, and 48 B.
Transmitter FIFO trigger points at 0, 4, and 8 B.
Each high-speed UART has an internal baud rate generator.
The high-speed UARTs are designed to support data rates of (2400, 4800, 9600,
19200, 38400, 57600, 115200, 230400, 460800, 921600) bit/s.
The three high speed UARTs only support (8N1) 8-bit data word length, 1-stop bit, no
parity, and no flow control as a the communications protocol.
Each UART includes an internal loopback mode.
7.8.2 SPI serial I/O controller
The LPC3220/30/40/50 has two Serial Peripheral Interfaces (SPI). The SPI is a 3-wire
serial interface that is able to interface with a large range of serial peripheral or memory
devices (SPI mode 0 to 3 compatible slave devices).
相關PDF資料
PDF描述
1025-16K COIL .68UH MOLDED UNSHIELDED
ISL28214SOICEVAL2Z EVALUATION BOARD FOR ISL28214
GBC19DRTF CONN EDGECARD 38POS DIP .100 SLD
SLPX152M200H7P3 CAP ALUM 1500UF 200V 20% SNAP
SCRH127-180 INDUCTOR SMD 18UH 3.90A 1KHZ
相關代理商/技術參數
參數描述
OM11079,598 功能描述:開發板和工具包 - ARM NXP LPC3250 SODIMM for IRD2.0 RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
OM11080,598 制造商:NXP Semiconductors 功能描述:LPC1768 CORTEX-M3 3.2" 2X40 LCD DISPLAY KIT, ARM CORTEX-M3 M - Boxed Product (Development Kits)
OM11082,598 功能描述:開發板和工具包 - ARM NXP LPC3250 IRD2.0-5.7"LCD/Lnx RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
OM11083 制造商:NXP Semiconductors 功能描述:EVAL LPCXPRESSO BASEBOARD 制造商:NXP Semiconductors 功能描述:BASEBOARD, FOR LPCXPRESSO, LPC1XXX 制造商:NXP Semiconductors 功能描述:BASEBOARD, FOR LPCXPRESSO, LPC1XXX; Silicon Manufacturer:NXP; Features:BaseBoard for LPCXpresso/mbed Board with a viariety of interfaces and I/O devices; SVHC:No SVHC (19-Dec-2012) ;RoHS Compliant: Yes
OM11083,598 功能描述:開發板和工具包 - ARM Embedded Artist Base LPCXpresso mbed RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*