- 您現在的位置：買賣IC網 > PDF目錄378045 > PCI6621 (Texas Instruments, Inc.) DUAL/SINGLE SOCKET CARDBUS AND ULTRAMEDIA CONTROLLER PDF資料下載
參數資料
| 型號： | PCI6621 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | DUAL/SINGLE SOCKET CARDBUS AND ULTRAMEDIA CONTROLLER |
| 中文描述： | 雙/單插槽CardBus和UltraMedia控制器 |
| 文件頁數： | 65/204頁 |
| 文件大?。?/td> | 860K |
| 代理商： | PCI6621 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁當前第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁
317
PCI6x21/PCI6x11 internal event, because it depends on the completion of applying power to the socket rather than
on a signal change at the PC Card interface.
3.7.2
Interrupt Masks and Flags
Host software may individually mask (or disable) most of the potential interrupt sources listed in Table 310 by setting
the appropriate bits in the PCI6x21/PCI6x11 controller. By individually masking the interrupt sources listed, software
can control those events that cause a PCI6x21/PCI6x11 interrupt. Host software has some control over the system
interrupt the PCI6x21/PCI6x11 controller asserts by programming the appropriate routing registers. The
PCI6x21/PCI6x11 controller allows host software to route PC Card CSC and PC Card functional interrupts to separate
system interrupts. Interrupt routing somewhat specific to the interrupt signaling method used is discussed in more
detail in the following sections.
When an interrupt is signaled by the PCI6x21/PCI6x11 controller, the interrupt service routine must determine which
of the events listed in Table 39 caused the interrupt. Internal registers in the PCI6x21/PCI6x11 controller provide
flags that report the source of an interrupt. By reading these status bits, the interrupt service routine can determine
the action to be taken.
Table 39 details the registers and bits associated with masking and reporting potential interrupts. All interrupts can
be masked except the functional PC Card interrupts, and an interrupt status flag is available for all types of interrupts.
Notice that there is not a mask bit to stop the PCI6x21/PCI6x11 controller from passing PC Card functional interrupts
through to the appropriate interrupt scheme. These interrupts are not valid until the card is properly powered, and
there must never be a card interrupt that does not require service after proper initialization.
Table 39 lists the various methods of clearing the interrupt flag bits. The flag bits in the ExCA registers (16-bit PC
Card-related interrupt flags) can be cleared using two different methods. One method is an explicit write of 1 to the
flag bit to clear and the other is by reading the flag bit register. The selection of flag bit clearing methods is made by
bit 2 (IFCMODE) in the ExCA global control register (ExCA offset 1Eh/5Eh/81Eh, see Section 5.20), and defaults to
the flag-cleared-on-read method.
The CardBus-related interrupt flags can be cleared by an explicit write of 1 to the interrupt flag in the socket event
register (see Section 6.1). Although some of the functionality is shared between the CardBus registers and the ExCA
registers, software must not program the chip through both register sets when a CardBus card is functioning.
3.7.3
Using Parallel IRQ Interrupts
The seven multifunction terminals, MFUNC6MFUNC0, implemented in the PCI6x21/PCI6x11 controller can be
routed to obtain a subset of the ISA IRQs. The IRQ choices provide ultimate flexibility in PC Card host interruptions.
To use the parallel ISA-type IRQ interrupt signaling, software must program the device control register (PCI offset
92h, see Section 4.39), to select the parallel IRQ signaling scheme. See Section 4.36,
Multifunction Routing Status
Register
, for details on configuring the multifunction terminals.
A system using parallel IRQs requires (at a minimum) one PCI terminal, INTA, to signal CSC events. This requirement
is dictated by certain card and socket-services software. The INTA requirement calls for routing the MFUNC0 terminal
for INTA signaling. The INTRTIE bit is used, in this case, to route socket interrupt events to INTA. This leaves (at a
maximum) six different IRQs to support legacy 16-bit PC Card functions.
As an example, suppose the six IRQs used by legacy PC Card applications are IRQ3, IRQ4, IRQ5, IRQ9, IRQ10,
and IRQ15. The multifunction routing status register must be programmed to a value of 0A9F 5432h. This value
routes the MFUNC0 terminal to INTA signaling and routes the remaining terminals as illustrated in Figure 311. Not
shown is that INTA must also be routed to the programmable interrupt controller (PIC), or to some circuitry that
provides parallel PCI interrupts to the host.
相關PDF資料 |
PDF描述 |
|---|---|
| PCI6515 | SINGLE SOCKET CARDBUS CONTROLLER WITH DEDICATED SMART CARD SOCKET |
| PCI6515GHK | SINGLE SOCKET CARDBUS CONTROLLER WITH DEDICATED SMART CARD SOCKET |
| PCI6515ZHK | SINGLE SOCKET CARDBUS CONTROLLER WITH DEDICATED SMART CARD SOCKET |
| PCI7610LQFP | PC Card, UltraMedia, and Integrated 1394a-2000 OHCI Two-Port PHY/Link-Layer Controller |
| PCM1712U | Stereo Audio Digital-To-Analog Converter(立體聲音頻D\A轉換器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCI6621GHK | 制造商:Texas Instruments 功能描述:DUAL/SGL SCKT CARDBUS AND ULTRAMEDIA CNTRLR W/ DEDICATED FLA - Trays |
| PCI6621ZHK | 制造商:Texas Instruments 功能描述:DUAL/SGL SCKT CARDBUS AND ULTRAMEDIA CNTRLR W/ DEDICATED FLA - Trays |
| PCI-6870 | 制造商:ADVANTECH 制造商全稱:Advantech Co., Ltd. 功能描述:Socket 370 PCI Half-sized SBC, VGA/LAN/CFC II |
| PCI-6870F-00A2E | 制造商:ADVANTECH 制造商全稱:Advantech Co., Ltd. 功能描述:Socket 370 PCI Half-sized SBC, VGA/LAN/CFC II |
| PCI-6873 | 制造商:ADVANTECH 制造商全稱:Advantech Co., Ltd. 功能描述:AMD Geode? LX800 PCI Half-sized SBC with VGA/LCD/LVDS/LAN/SATA and SSD |
發布緊急采購，3分鐘左右您將得到回復。