參數資料
型號: RTL8100CL-LF
廠商: Electronic Theatre Controls, Inc.
英文描述: SINGLE-CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
中文描述: 單芯片快速以太網控制器電源管理
文件頁數: 42/73頁
文件大?。?/td> 652K
代理商: RTL8100CL-LF
RTL8100C & RTL8100CL
Datasheet
Single-Chip Fast Ethernet Controller
34
Track ID: JATR-1076-21 Rev. 1.06
5.36. Config5: Configuration Register 5 (Offset 00D8h, R/W)
This register, unlike other Config registers, is not protected by the 93C46 Command register. There is no
need to enable the Config register write prior to writing to Config5.
Table 36. Config5. Configuration Register 5
Symbol
Description
-
Reserved.
BWF
Broadcast Wakeup Frame.
1: Enable Broadcast Wakeup Frame with Destination ID field mask
bytes of FF FF FF FF FF FF
0: Default value. Disable Broadcast Wakeup Frame with
Destination ID field mask bytes of FF FF FF FF FF FF
MWF
Multicast Wakeup Frame.
1: Enable Multicast Wakeup Frame with mask bytes of only the
Destination ID field, which is a multicast address
0: Default value. Disable Multicast Wakeup Frame with mask bytes
of only the Destination ID field, which is a multicast address
UWF
Unicast Wakeup Frame.
1: Enable Unicast Wakeup Frame with mask bytes of only the
Destination ID field, which is its own physical address
0: Default value. Disable Unicast Wakeup Frame with mask bytes of
only the Destination ID field, which is its own physical address
FIFOAddrPtr
FIFO Address Pointer (Realtek internal use only).
The power-on default value of this bit is 0.
LDPS
Link Down Power Saving mode.
1: Disable
0: Enable. When the cable is disconnected (Link Down), the analog
part will power itself down (PHY Tx part and part of the Twister)
automatically except for the PHY Rx part and the part of the twister
that monitors the SD signal in case the cable is reconnected and the
Link should be established again
LANWake
LANWake signal enable/disable.
1: Enable LANWake signal
0: Disable LANWake signal
PME_STS
PME_Status bit.
Always sticky/can be reset by PCI RST# and software.
1: The PME_Status bit may be reset by PCI reset or by software
0: The PME_Status bit may only be reset by software
Bit
7
6
R/W
-
R/W
5
R/W
4
R/W
3
R/W
2
R/W
1
R/W
0
R/W
相關PDF資料
PDF描述
RTL8100C SINGLE-CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8100C-LF SINGLE-CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8100CL SINGLE-CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8130 REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8100 REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
相關代理商/技術參數
參數描述
RTL8100L 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8101 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8101L 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER AND MC97 CONTROLLER WITH POWER MANAGEMENT
RTL8101LLQFP 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER AND MC97 CONTROLLER WITH POWER MANAGEMENT
RTL8101LQFP 制造商:未知廠家 制造商全稱:未知廠家 功能描述:REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER AND MC97 CONTROLLER WITH POWER MANAGEMENT