- 您現在的位置：買賣IC網 > PDF目錄3764 > SC28C94A1A,518 (NXP Semiconductors)IC UART QUAD W/FIFO 52-PLCC PDF資料下載
參數資料
| 型號： | SC28C94A1A,518 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 18/39頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC UART QUAD W/FIFO 52-PLCC |
| 產品培訓模塊： | Stand-Alone UARTs |
| 標準包裝： | 1 |
| 特點： | 故障啟動位檢測 |
| 通道數： | 4，QUART |
| FIFO's： | 8 字節 |
| 電源電壓： | 5V |
| 帶自動流量控制功能： | 是 |
| 帶故障啟動位檢測功能： | 是 |
| 帶調制解調器控制功能： | 是 |
| 帶CMOS： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 52-LCC（J 形引線） |
| 供應商設備封裝： | 52-PLCC（19.2x19.2） |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 828 (CN2011-ZH PDF) |
| 其它名稱： | 568-1114-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁
Philips Semiconductors
Product data sheet
SC28C94
Quad universal asynchronous receiver/transmitter (QUART)
2006 Aug 09
25
AC ELECTRICAL CHARACTERISTICS1, 2, 3, 4
VCC = 5V ± 10%, TA = –40_C to 85_C, unless otherwise specified.
SYMBOL
FIGURE
PARAMETER
LIMITS
UNIT
SYMBOL
FIGURE
PARAMETER
Min
Typ
Max
UNIT
Reset timing
tRES
10
Reset pulse width
200
ns
I/O Port timing
tPS
11
I/O input setup time before RDN Low
0
ns
tPH
11
I/O input hold time after RDN High
0
ns
tPD
11
I/O output valid from
WRN High (WRN or CEN high, whichever occurs first)
RDN Low (RDN or CEN low, whichever occurs last)
40
ns
Interrupt timing
tIR
12
IRQN negated or I/O output High from:
Read RHR (RxRDY/FFULL interrupt)
Write THR (TxRDY interrupt)
Reset command (break change interrupt)
Reset command (I/O change interrupt)
Stop C/T command (counter interrupt)
Write IMR (clear of interrupt mask bit)
With respect to a
3.6864MHz clock
on pin X1/CLK
80
ns
Clock timing
tCLK
13
X1/CLK low/high time
125/100
ns
tCLK
13
X1/CLK low/high time (above 4MHz; X1/CLK
÷ 2 active)
56/56
ns
tCLK5
13
X1/CLK frequency
0
3.6864
8.0
MHz
tCTC
13
Counter/timer clock high or low time
60
ns
fCTC5
13
Counter/timer clock frequency
0
8
MHz
tRX
13
RxC high or low time
30
ns
fRX5
13
RxC frequency (16X)
RxC frequency (1X)
0
16
1.0
MHz
tTX
13
TxC high or low time
30
ns
fTX5
13
TxC frequency (16X)
TxC frequency (1X)
0
16
1.0
MHz
Transmitter timing
tTXD
14
TxD output delay from TxC low
70
ns
tTCS
14
TxC output delay from TxD output data
–10
+10
ns
Receiver timing
tRXS
15
RxD data setup time to RxC high
60
5
ns
tRXH
15
RxD data hold time from RxC high
60
5
ns
NOTES:
1. All voltage measurements are referenced to ground (GND). For testing, all inputs swing between 0.4 V and 2.4 V with a transition time of
20 ns maximum. For X1/CLK this swing is between 0.4 V and 4.4 V. All time measurements are referenced at input voltages of VIL and VIH,
as appropriate.
2. Typical values are at +25
°C, typical supply voltages, and typical processing parameters.
3. Test condition for interrupt and I/O outputs: CL = 50 pF, RL = 2.7 k to VCC. Test conditions for rest of outputs: CL = 150 pF.
4. Timing is illustrated and referenced to the WRN and RDN inputs. The device may also be operated with CEN as the ‘strobing’ input. CEN
and RDN (also CEN and WRN) are ANDed internally. As a consequence, the signal asserted last initiates the cycle and the signal negated
first terminates the cycle.
5. The minimum value is not tested, but is guaranteed by design. For tCLK minimum test rate is 2.0 MHz.
相關PDF資料 |
PDF描述 |
|---|---|
| SC16C754BIA68,518 | IC UART QUAD W/FIFO 68-PLCC |
| SC26C92C1N,602 | IC UART DUAL W/FIFO 40-DIP |
| SC28L91A1B,551 | IC UART SINGLE W/FIFO 44-PQFP |
| SC28L91A1B,528 | IC UART SINGLE W/FIFO 44PQFP |
| SC28L91A1A,529 | IC UART SINGLE W/FIFO 44-PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC28C94A1AB | 制造商:PHILIPS-SEMI 功能描述: |
| SC28C94A1N | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Quad universal asynchronous receiver/transmitter QUART |
| SC28C94A1N,112 | 功能描述:IC UART QUAD W/FIFO 48-DIP RoHS:是 類別:集成電路 (IC) >> 接口 - UART（通用異步接收器/發送器） 系列:- 標準包裝:250 系列:- 特點:* 通道數:2，DUART FIFO's:16 字節 規程:RS232，RS485 電源電壓:2.25 V ~ 5.5 V 帶并行端口:- 帶自動流量控制功能:是 帶IrDA 編碼器/解碼器:是 帶故障啟動位檢測功能:是 帶調制解調器控制功能:是 帶CMOS:是 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:托盤 其它名稱:XR16L2551IM-F-ND |
| SC28L194 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Quad UART for 3.3V and 5V supply voltage |
| SC28L194A1A | 功能描述:UART 接口集成電路 3V-5V 4CH UART INTEL/MOT INTRF RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。