參數資料
型號： SN54ABT8996FK
廠商： Texas Instruments, Inc.
英文描述： 10-BIT ADDRESSABLE SCAN PORTS MULTIDROP-ADDRESSABLE IEEE STD 1149.1 JTAG TAP TRANSCEIVERS
中文描述： 10位可尋址掃描港口多點尋址IEEE標準1149.1的JTAG技術咨詢收發器
文件頁數： 7/40頁
文件大?。?/td> 564K
代理商： SN54ABT8996FK
SN54ABT8996, SN74ABT8996
10-BIT ADDRESSABLE SCAN PORTS
MULTIDROP-ADDRESSABLE IEEE STD 1149.1 (JTAG) TAP TRANSCEIVERS
SCBS489C – AUGUST 1994 – REVISED APRIL 1999
7
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
shadow protocol
Addressing of an ASP in system is accomplished by shadow protocols, which are received at PTDI
synchronously to PTCK. Shadow protocols can occur only in the following stable TAP states: Test-Logic-Reset,
Run-Test/Idle, Pause-DR, and Pause-IR. Shadow protocols never occur in Shift-DR or Shift-IR states in order
to prevent contention on the signal bus to which PTDO is wired. Additionally, the ASP PTMS must be held at
a constant low or high level throughout a shadow protocol. If TAP-state changes occur in the midst of a shadow
protocol, the shadow protocol is aborted and the select-protocol state machine returns to its initial state.
The shadow protocol is based on a serial bit-pair signaling scheme in which two bit-pair combinations (data one,
data zero) are used to represent address data and the other two bit-pair combinations (select, idle) are used
for framing – that is, to indicate where address data begins and ends.
These bit pairs are received serially at PTDI (or transmitted serially at PTDO) synchronously to PTCK as follows:
–
The idle bit pair (I) is represented as two consecutive high signals.
–
The select bit pair (S) is represented as two consecutive low signals.
–
The data-one bit pair (D) is represented as a low signal followed by a high signal.
–
The data-zero bit pair (D) is represented as a high signal followed by a low signal.
PTCK
PTDI
or
PTDO
First Bit of Pair Is Transmitted
First Bit of Pair Is Received
Second Bit of Pair Is Transmitted
Second Bit of Pair Is Received
Figure 3. Bit-Pair Timing (Data Zero Shown)
A complete shadow protocol is composed of the receipt of a select protocol followed, if applicable, by the
transmission of an acknowledge protocol (which is issued from PTDO only if the received address matches that
at the A9–A0 inputs). Both of these subprotocols are composed of ten data bit pairs framed at the beginning
by idle and select bit pairs and at the end by select and idle bit pairs. This is represented in an abbreviated
fashion as follows: ISDDDDDDDDDDSI. Figure 4 shows a complete shadow protocol (the symbol T is used to
represent a high-impedance condition on the associated signal line – since the high-impedance state at PTDI
is logically high due to pullup, it maps onto the idle bit pair).
T I S D D D D D D D D D D S I T T T T T T T T T T T T T T T
T T T T T T T T T T T T T T T I S D D D D D D D D D D S I T
Received at PTDI
Transmitted at PTDO
Primary Tap Is Inactive
Select Protocol Begins
Select Protocol Ends
Acknowledge Protocol Begins
Acknowledge Protocol Ends
Primary-to-Secondary Connect,
Scan Operations Can Be Initiated
LSB
MSB
LSB
MSB
Figure 4. Complete Shadow Protocol
相關PDF資料
PDF描述
SN54ABT8996JT 10-BIT ADDRESSABLE SCAN PORTS MULTIDROP-ADDRESSABLE IEEE STD 1149.1 JTAG TAP TRANSCEIVERS
SN54ABTE16246 11-Bit Incident-Wave Switching Bus Transceivers(11位入射波開關總線收發器(三態,開路集電極輸出))
SN54ABTH162245 16-BIT BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
SN74ABTH162245DGG 16-BIT BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
SN74ABTH162245DGV 16-BIT BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
相關代理商/技術參數
參數描述
SN54ABT8996JT 制造商:Texas Instruments 功能描述:ADDRESSABLE SCAN PORT 24CDIP - Rail/Tube
SN54ABTE16245 制造商:TI 制造商全稱:Texas Instruments 功能描述:16-BIT INCIDENT-WAVE SWITCHING BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
SN54ABTE16245_06 制造商:TI 制造商全稱:Texas Instruments 功能描述:16-BIT INCIDENT-WAVE SWITCHING BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
SN54ABTE16245WD 制造商:TI 制造商全稱:Texas Instruments 功能描述:16-BIT INCIDENT-WAVE SWITCHING BUS TRANSCEIVERS WITH 3-STATE OUTPUTS
SN54ABTE16246 制造商:TI 制造商全稱:Texas Instruments 功能描述:11-BIT INCIDENT-WAVE SWITCHING BUS TRANSCEIVERS WITH 3-STATE AND OPEN-COLLECTOR OUTPUTS
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*