參數資料
型號: ST62E40B
廠商: 意法半導體
元件分類: DRAM
英文描述: The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each
中文描述: 該CAT24FC02是一個2 KB的EEPROM的國內256個8位每字舉辦的串行CMOS
文件頁數: 12/72頁
文件大?。?/td> 445K
代理商: ST62E40B
12/72
12
ST62T40B/E40B
MEMORY MAP
(Cont’d)
1.3.6
Data
(DRBR)
Address: CBh
RAM/EEPROM
Bank
Register
Write only
Bit 7-5 = These bits are not used
Bit 4 -
DRBR4
. This bit, when set, selects RAM
Page 2.
Bit 3 -
DRBR3
. This bit, when set, selects RAM
Page 1.
Bit2. These bits are not used.
Bit 1 -
DRBR1
. This bit, when set, selects
EEPROM Page 1.
Bit 0 -
DRBR0
. This bit, when set, selects
EEPROM Page 0.
The selection of the bankis madeby programming
the Data RAM Bank Switch register (DRBR regis-
ter) located at address CBh of the Data Space ac-
cording to Table 1. No more than one bank should
be set at a time.
The DRBR register can be addressed like a RAM
Data Space at the address CBh; nevertheless it is
a write only register that cannot be accessed with
single-bit operations.This register is used to select
the desired 64-byte RAM/EEPROM bank of the
Data Space. The number of banks has to be load-
ed in the DRBR register and the instruction has to
point to the selected location as if it was in bank 0
(from 00h address to 3Fh address).
This register is not cleared during the MCU initiali-
zation, therefore it must be written before the first
access to the Data Space bank region. Refer to
the Data Space description for additional informa-
tion. The DRBR register is not modified when an
interrupt or a subroutine occurs.
Notes
:
Care is required when handling the DRBR register
as it is write only. For this reason, it is not allowed
to change the DRBR contents while executing in-
terrupt service routine, as the service routine can-
not save and then restore its previous content. If it
is impossible to avoid the writing of this register in
interrupt service routine, an image of this register
must be saved in a RAM location, and each time
the program writes to DRBR it must write also to
the image register. The image register must be
written first, so if an interrupt occurs between the
two instructions the DRBR is not affected.
In DRBR Register, only 1 bit must be set. Other-
wise two or more pages are enabled in parallel,
producing errors.
Table 6. Data RAM Bank Register Set-up
7
0
-
-
-
DRBR4 DRBR3
-
DRBR1 DRBR0
DRBR
00h
01h
02h
08h
10h
other
ST62T40B/E40B
None
EEPROM Page 0
EEPROM Page 1
RAM Page 1
RAM Page 2
Reserved
相關PDF資料
PDF描述
ST62T40B The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each
ST62T10 8-BIT OTP/EPROM MCUs WITH A/D CONVERTER
ST62T28C 8-BIT MCUs WITH A/D CONVERTER, AUTO-RELOAD TIMER, UART, OSG, SAFE RESET AND 28-PIN PACKAGE
ST6228CN1 ER 3C 3#16S SKT RECP WALL
ST6228CN3 CB 5C 5#16S PIN RECP WALL
相關代理商/技術參數
參數描述
ST62E40BG1 功能描述:8位微控制器 -MCU UV EPROM 8K SPI RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ST62E40C 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:GANG PROGRAMMERS FOR ST62 MCU FAMILY
ST62E40G1 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
ST62E42 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:GANG PROGRAMMERS FOR ST62 MCU FAMILY
ST62E42B 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT OTP/EPROM MCU WITH LCD DRIVER, EEPROM AND A/D CONVERTER