參數資料
型號: ST62E40B
廠商: 意法半導體
元件分類: DRAM
英文描述: The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each
中文描述: 該CAT24FC02是一個2 KB的EEPROM的國內256個8位每字舉辦的串行CMOS
文件頁數: 19/72頁
文件大?。?/td> 445K
代理商: ST62E40B
19/72
19
ST62T40B/E40B
CLOCK SYSTEM
(Cont’d)
3.1.2 32 KHz STAND-BY OSCILLATOR
An additional32KHz stand-by on chip oscillatoral-
lows to generate real time interrupts and to supply
the clock to the LCD driver with the main oscillator
stopped. This enables the MCU to perform real
time functions with the LCD display running while
keeping advantages of low power consumption.
Figure 10 shows the 32KHz oscillator block dia-
gram.
A 32.768KHz quartz crystal must be connected to
the OSC32in and OSC32out pins to perform the
real time clock operation. Two external capacitors
of 15-22pF each must be connected between the
oscillator pins and ground. The 32KHz oscillator is
managed by the dedicated status/control register
32OCR.
As long as the 32KHz stand-by oscillator is ena-
bled, 32KHz internal clock is available to drive
LCD controller driver. This clock is divideby 2
14
to
generate interrupt requestevery 500ms . The peri-
odic interrupt request serves as reference time-
base for real time functions.
Note
: When the 32KHz stand-by oscillator is
stopped (bit 5 of the Status/Control register
cleared) the divider chain is supplied with a clock
signal synchronous with machine cycle (f
INT
/13),
this produces an interrupt request every 13x2
14
clock cycle (i.e. 26.624ms) with an 8MHz quartz
crystal.
32KHz Oscillator Register (32OCR)
Address: DBh - Read/Write
Bit 7=
EOSCI
. Enable Oscillator Interrupt This bit,
when set, enables the 32KHz oscillator interrupt
request.
Bit 6 =
OSCEOC
. Oscillator Interrupt Flag This bit
indicates when the 32KHz oscillatorhas measured
a
500ms
elapsed
32.768KHzquartz crystal is connected to the
32KHz oscillator dedicated pins). An interrupt re-
quest can be generated in relation to the state of
EOSCI bit. This bit must be cleared by the user
program before leaving the interrupt service rou-
tine.
Bit 5 =
START/STOP
. Oscillator Start/Stop bit
This bit, when set, enables the 32KHz stand-by
oscillator and the free running divider chain is sup-
plied by the 32KHz oscillator signal. When this bit
is cleared to zero the dividerchain is supplied with
f
INT
/13.
This register is cleared during reset.
Note
:
To achieve minimumpower consumptionin STOP
mode (no system clock), the stand-by oscillator
must be switched off (real time function not availa-
ble) by clearing the Start/Stop bit in the oscillator
status/control register.
time
(providing
a
Figure 10. 32KHz Oscillator Block Diagram
7
0
EOSCI OSCEOC
S/S
D4
D3
D2
D1
D0
OSC32KHz
EOSCI
OSCEOC
START
STOP
X
X
X
X
X
INT
OSC32IN
OSC32OUT
2x15...22pF
32.768KHz
Crystal
f
INT
/13
OSC32KHz
MUX
1
0
DIV 2
14
相關PDF資料
PDF描述
ST62T40B The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each
ST62T10 8-BIT OTP/EPROM MCUs WITH A/D CONVERTER
ST62T28C 8-BIT MCUs WITH A/D CONVERTER, AUTO-RELOAD TIMER, UART, OSG, SAFE RESET AND 28-PIN PACKAGE
ST6228CN1 ER 3C 3#16S SKT RECP WALL
ST6228CN3 CB 5C 5#16S PIN RECP WALL
相關代理商/技術參數
參數描述
ST62E40BG1 功能描述:8位微控制器 -MCU UV EPROM 8K SPI RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ST62E40C 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:GANG PROGRAMMERS FOR ST62 MCU FAMILY
ST62E40G1 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
ST62E42 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:GANG PROGRAMMERS FOR ST62 MCU FAMILY
ST62E42B 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT OTP/EPROM MCU WITH LCD DRIVER, EEPROM AND A/D CONVERTER