參數資料
型號： T48C862x-Rf-TNS
廠商： Atmel Corp.
元件分類： 4位微控制器
英文描述： Microcontroller with UHF ASK/FSK Transmitter
中文描述： 微控制器，帶有超高頻ASK / FSK發射器
文件頁數： 33/108頁
文件大小： 1023K
代理商： T48C862X-RF-TNS
33
T48C862-R4 [Preliminary]
4551C–4BMCU–01/04
Bi-directional Ports
With the exception of Port 1 and Port 6, all other ports (2, 4 and 5) are 4 bits wide. Port 1
and Port 6 have a data width of 2 bits (bit 0 and bit 3). All ports may be used for data
input or output. All ports are equipped with Schmitt trigger inputs and a variety of mask
options for open-drain, open-source, full-complementary outputs, pull-up and pull-down
transistors. All Port Data Registers (PxDAT) are I/O mapped to the primary address reg-
ister of the respective port address and the Port Control Register (PxCR), to the
corresponding auxiliary register.
There are five different directional ports available:
Port 1
2-bit wide bi-directional port with automatic full bus width direction switching.
Port 2
4-bit wide bitwise-programmable I/O port.
Port 5
4-bit wide bitwise-programmable bi-directional port with optional strong
pull-ups and programmable interrupt logic.
Port 4
4-bit wide bitwise-programmable bi-directional port also provides the I/O
interface to Timer 2, SSI, voltage monitor input and external interrupt input.
Port 6
2-bit wide bitwise-programmable bi-directional port also provides the I/O
interface to Timer 3 and external interrupt input.
Bi-directional Port 1
In Port 1 the data direction register is not independently software programmable, the
direction of the complete port being switched automatically when an I/O instruction
occurs (see Figure 28 on page 34). The port is switched to output mode via an OUT
instruction and to input via an IN instruction. The data written to a port will be stored into
the output data latches and appears immediately at the port pin following the OUT
instruction. After RESET all output latches are set to "1" and the port is switched to input
mode. An IN instruction reads the condition of the associated pins.
Note:
Care must be taken when switching the bi-directional port from output to input. The
capacitive pin loading at this port in conjunction with the high resistance pull-ups may
cause the CPU to read the contents of the output data register rather than the external
input state. To avoid this, one of the following programming techniques should be used:
Use two IN instructions and DROP the first data nibble. The first IN switches the port
from output to input and the DROP removes the first invalid nibble. The second IN reads
the valid pin state.
Use an OUT instruction followed by an IN instruction. Via the OUT instruction, the capac-
itive load is charged or discharged depending on the optional pull-up/pull-down
configuration. Write a "1" for pins with pull-up resistors and a "0" for pins with pull-down
resistors.
相關PDF資料
PDF描述
T48C893 The multiple times programmable (MTP) version for the MARC4 ROM types
T48C893-TK The multiple times programmable (MTP) version for the MARC4 ROM types
T48C893-TKQ The multiple times programmable (MTP) version for the MARC4 ROM types
T500 DIL 14 PIN SINGLE OUTPUT
T500 Phase Control SCR (40-80 Amperes (63-125 RMS) 1600 Volts)
相關代理商/技術參數
參數描述
T48C893 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:The multiple times programmable (MTP) version for the MARC4 ROM types
T48C893-TK 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:The multiple times programmable (MTP) version for the MARC4 ROM types
T48C893-TKQ 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:The multiple times programmable (MTP) version for the MARC4 ROM types
T48D 制造商:WELWYN 制造商全稱:Welwyn Components Limited 功能描述:High Voltage Precision Thick Film Resistors
T48DH-100MFI 制造商:TT Electronics / Welwyn 功能描述:RESISTOR 100 MEG OHM 1%
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*