參數資料
型號： TMX320F2810GHHS
廠商： Texas Instruments, Inc.
元件分類： 數字信號處理
英文描述： DIGITAL SIGNAL PROCESSORS
中文描述： 數字信號處理器
文件頁數： 82/103頁
文件大小： 1341K
代理商： TMX320F2810GHHS
TMS320F2810, TMS320F2812
DIGITAL SIGNAL PROCESSORS
SPRS174B
–
APRIL 2001
–
REVISED SEPTEMBER 2001
82
POST OFFICE BOX 1443
HOUSTON, TEXAS 77251
–
1443
serial peripheral interface (SPI) module
The F2810 and F2812 devices include the four-pin serial peripheral interface (SPI) module. The SPI is a
high-speed, synchronous serial I/O port that allows a serial bit stream of programmed length (one to sixteen
bits) to be shifted into and out of the device at a programmable bit-transfer rate. Normally, the SPI is used for
communications between the DSP controller and external peripherals or another processor. Typical
applications include external I/O or peripheral expansion through devices such as shift registers, display drivers,
and ADCs. Multidevice communications are supported by the master/slave operation of the SPI.
The SPI module features include:
Four external pins:
–
SPISOMI: SPI slave-output/master-input pin
–
SPISIMO: SPI slave-input/master-output pin
–
SPISTE: SPI slave transmit-enable pin
–
SPICLK: SPI serial-clock pin
NOTE: All four pins can be used as GPIO, if the SPI module is not used.
Two operational modes: master and slave
Baud rate: 125 different programmable rates/37.5 Mbps at 150-MHz SYSCLKOUT
Data word length: one to sixteen data bits
Four clocking schemes (controlled by clock polarity and clock phase bits) include:
–
Falling edge without phase delay: SPICLK active-high. SPI transmits data on the falling edge of the
SPICLK signal and receives data on the rising edge of the SPICLK signal.
–
Falling edge with phase delay: SPICLK active-high. SPI transmits data one half-cycle ahead of the
falling edge of the SPICLK signal and receives data on the falling edge of the SPICLK signal.
–
Rising edge without phase delay: SPICLK inactive-low. SPI transmits data on the rising edge of the
SPICLK signal and receives data on the falling edge of the SPICLK signal.
–
Rising edge with phase delay: SPICLK inactive-low. SPI transmits data one half-cycle ahead of the
falling edge of the SPICLK signal and receives data on the rising edge of the SPICLK signal.
Simultaneous receive and transmit operation (transmit function can be disabled in software)
Transmitter and receiver operations are accomplished through either interrupt-driven or polled algorithms.
Nine SPI module control registers: Located in control register frame beginning at address 7040h.
NOTE: All registers in this module are 16-bit registers that are connected to Peripheral Frame 2. When a register is accessed, the register
data is in the lower byte (7
–
0), and the upper byte (15
–
8) is read as zeros. Writing to the upper byte has no effect.
Enhanced feature:
16-level transmit/receive FIFO
Delayed transmit control
P
相關PDF資料
PDF描述
TMP320F2810GHHS DIGITAL SIGNAL PROCESSORS
TMX320F2810PGFA DIGITAL SIGNAL PROCESSORS
TMP320F2810PGFA DIGITAL SIGNAL PROCESSORS
TMX320F2810PGFAEP Digital Signal Processors
TMP320F2810PGFAEP Digital Signal Processors
相關代理商/技術參數
參數描述
TMX320F2810PBKA 制造商:TI 制造商全稱:Texas Instruments 功能描述:DIGITAL SIGNAL PROCESSORS
TMX320F2810PBKAEP 制造商:TI 制造商全稱:Texas Instruments 功能描述:Digital Signal Processors
TMX320F2810PBKS 制造商:TI 制造商全稱:Texas Instruments 功能描述:DIGITAL SIGNAL PROCESSORS
TMX320F2810PGFA 制造商:TI 制造商全稱:Texas Instruments 功能描述:DIGITAL SIGNAL PROCESSORS
TMX320F2810PGFAEP 制造商:TI 制造商全稱:Texas Instruments 功能描述:Digital Signal Processors
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*