- 您現在的位置：買賣IC網 > PDF目錄373713 > TS68230FN (意法半導體) HMOS PARALLEL INTERFACE/TIMER PDF資料下載
參數資料
| 型號： | TS68230FN |
| 廠商： | 意法半導體 |
| 英文描述： | HMOS PARALLEL INTERFACE/TIMER |
| 中文描述： | HMO的并行接口/定時器 |
| 文件頁數： | 2/61頁 |
| 文件大小： | 2911K |
| 代理商： | TS68230FN |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁
INTRODUCTION
The TS68230 parallel interface/timer (PI/T) provides
versatile double buffered parallel interfaces and a
system oriented timer for TS68000 systems. The
parallel interfaces operate in unidirectional or bidi-
rectional modes, either 8 or 16 bits wide. In the uni-
directional modes, an associated data direction
register determines whether each port pin is an input
or output. In the bidirectional modes the data direc-
tion registers are ignored and the direction is deter-
mined dynamically by the state of four handshake
pins. These programmable handshake pins provide
an interface flexible enough for connection to a wide
variety of low, medium, or high speed peripherals or
other computer systems. The PI/T ports allow use
of vectored or autovectored interrupts, and also pro-
vide a DMA request pin for connection to the 68440
direct memory access controller (DMAC) or a similar
circuit. The PI/T timer contains a 24-bit wide counter
and a 5-bit prescaler. The timer may be clocked by
the system clock (PI/T CLK pin) or by an external
clock (TIN pin), and a 5-bit prescaler can be used.
It can generate periodic interrupts, a square wave,
or a single interrupt after a programmed time period.
It can also be used for elapsed time measurement
.
TS68000 Bus Compatible
.
Port Modes Include :
Bit I/O
Unidirectional 8 Bit and 16 Bit
Bidirectional 8 Bit and 16 Bit
.
Programmable Handshaking Options
.
24-Bit Programmable Timer Modes
.
Five Separate Interrupt Vectors
.
Separate Port and Timer Interrupt Service
Requests
.
Registers are Read/Write and Directly
Addressable
.
Registers are Addressed for MOVEP (Move
Peripheral) and DMAC Compatibility
Features of the PI/T include :
The PI/T consists of two logically independent sec-
tions : the ports and the timer. The port section
consists of port A (PA0-PA7), port B (PB0-PB7), four
handshake pins (H1, H2, H3, and H4), two general
input/output (I/O) pins, and six dual-function pins.
The dual-function pins can individually operate as a
third port (port C) or an alternate function related to
either port A, port B, or the timer. The four program-
mable handshake pins, depending on the mode,
can control data transfer to and from the ports, or
can be used as interrupt generating inputs or I/O
pins. Refer to figure 1.1.
The timer consists of a 24-bit counter, optionally
clocked by a 5-bit prescaler. Three pins provide
complete timer I/O : PC2/TIN, PC3/TOUT, and
PC7/TIACK. Only the ones needed for the given
configuration perform the timer function, while the o-
thers remain port C I/O.
The system bus interface provides for asynchro-
nous transfer of data from the PI/T to a bus master
over the data bus (D0-D7). Data transfer acknow-
ledge (DTACK), register selects (RS1-RS5), timer
interrupt acknowledge (TIACK), read/write line
(R/W), chip select (CS), or port interrupt acknow-
ledge (PIACK) control data transfer between the
PI/T and an TS68000.
1.1. PORT MODE DESCRIPTION
The primary focus of most applications will be on
port A, port B, the handshake pins, the port interrupt
pins, and the DMA request pin. They are controlled
in the following way : the port general control register
contains a 2-bit field that specifies one of four ope-
ration modes. These govern the overall operation of
the ports and determine their interrelation-ships.
Some modes require additional information from
each port’s control register to further define its ope-
ration. In each port control register, there is a 2-bit
submode field that serves this purpose. Each port
mode/submode combination specifies a set of pro-
grammable characteristics that fully define the be-
havior of that port and two of the handshake pins.
This structure is summarized in table 1.1 and fig-
ure 1.2.
SECTION 1
TS68230
2/61
相關PDF資料 |
PDF描述 |
|---|---|
| TS68230 | HMOS PARALLEL INTERFACE/TIMER |
| TS68230CP10 | HMOS PARALLEL INTERFACE/TIMER |
| TS68230CP8 | HMOS PARALLEL INTERFACE/TIMER |
| TS68230P | HMOS PARALLEL INTERFACE/TIMER |
| TS68230CFN8 | HMOS PARALLEL INTERFACE/TIMER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TS68230MC1B/C10 | 制造商:e2v technologies 功能描述: |
| TS68230MCB/C8 | 制造商:e2v technologies 功能描述: |
| TS68230P | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:HMOS PARALLEL INTERFACE/TIMER |
| TS68302 | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Integrated Multiprotocol Processor IMP |
| TS68302CA1B/C16 | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Integrated Multiprotocol Processor IMP |
發布緊急采購，3分鐘左右您將得到回復。