參數資料
型號： TSC2302IRGZR
元件分類： Codec
英文描述： PROGRAMMABLE TOUCH SCREEN CONTROLLER WITH STEREO AUDIO CODEC
中文描述： 可編程觸摸屏控制器，立體聲編解碼器
文件頁數： 64/81頁
文件大?。?/td> 1211K
代理商： TSC2302IRGZR
www.ti.com
TSC2302
SLAS394–JULY 2003
The digital decimation filter block includes a high-pass IIR filter for the purpose of removing any dc or
sub-audio-frequency component from the signal. Since such a low frequency filter can have significant settling
time, the filter has an adjustable cutoff frequency, in order to allow the host to set a faster settling time initially,
then later switch it back to a level that does not affect the audio band. The settings for this high-pass filter are:
HPF -3-dB frequency:
0.000019 Fs (0.912 Hz at Fs = 48 kHz)
0.000078 Fs (3.744 Hz at Fs = 48 kHz)
0.1 Fs (4.8 kHz at Fs = 48 kHz)
The filter block provides an audio passband ripple of +/-0.03 dB over a passband from 0 Hz to 0.454 sampling
frequency (Fs), and 70-dB minimum stopband attenuation from 0.548 Fs to 64 Fs.
The ADC modulator and digital filter operate on a clock that changes directly with Fs. This is in contrast to the
DAC, which keeps the modulator running at a high rate of 128 x 44.1 kHz or 128 x 48 kHz even if the incoming
data rate is much lower, such as 8 kHz. Group delay of the ADC path varies with sampling frequency and is
given by 28.7/Fs.
Audio ADC SNR performance is 88-dB-A typical over 20-Hz - 20-kHz bandwidth in 44.1/48-kHz mode with a
3.3-V supply level.
Each audio ADC is preceded by an analog volume control with gain programmable from 20 dB to -40 dB or mute
in 0.5-dB steps using Reg 01h, Pg 2. The input to these volume controls are selected as LLINEIN, RLINEIN,
MICIN, or a mono mix of LLINEIN and RLINEIN through the INML bits (Bits [13:12], Reg 00h, Pg 2). An
additional preamp gain is selectable on the MICIN input as 0 dB, 6 dB, or 12 dB using the MICG bits (Bits [9:8],
Reg 00h, Pg 2).
Audio Bypass Mode
In audio bypass mode, the L/RLINEIN analog inputs can be routed to mix with the DAC output and play to the
headphone outputs (HPL/R) and mono output (MONO). This path has a stereo analog volume control associated
with it, with range settings from 12.0 dB to -35.5 dB in 0.5-dB steps. If the audio ADCs and DACs are not used
while the bypass path is in use, the ADCs and DAC must be powered down to improve noise performance and
reduce power consumption.
This analog volume control has soft-stepping logic associated with it, so that when a volume change is made via
the SPI bus, the logic changes the actual volume incrementally, single-stepping the actual volume up or down
once every 20 μsec until it reaches the desired volume level.
This volume control also has similar algorithms as the ADC/DAC volume controls, in that the volume starts at
mute upon power-up, then is slowly single-stepped up to the desired level. At a power-down request, the volume
is slowly single-stepped down to mute before the circuit is actually powered down.
Monophonic Output (MONO)
The mono output of the TSC2302 can be used to drive a power amplifier which drives a low-impedance speaker.
This block can output either a mono mix of the stereo outputs, or the analog input to the left-channel ADC. This
is selected through the MONS bit (Bit 2, Reg 04h, Pg 2). The mono mix of the line outputs is represented by the
equation HPL/2 + HPR/2. Similarly, the mono mix of the analog line inputs is represented by LLINEIN/2 +
RLINEIN/2.
Microphone Bias Voltage (MICBIAS)
The TSC2302 provides an output voltage suitable for biasing an electret microphone capsule. This voltage is
always 1 V below the supply voltage of the part. This output can be disabled through the MIBPD bit (Bit 6, Reg
05h, Pg 2) to reduce power consumption if not used.
64
相關PDF資料
PDF描述
TSC87C51 CMOS 0 to 25 MHz Programmable 8?bit Microcontroller
TSC87C51-25MGMQ CMOS 0 to 25 MHz Programmable 8?bit Microcontroller
TSC87C51-25MIMQ CMOS 0 to 25 MHz Programmable 8?bit Microcontroller
TSC87C51-25MJMQ CMOS 0 to 25 MHz Programmable 8?bit Microcontroller
TSM600-250-RA PolySwitch PTC Devices Overcurrent Protection Device
相關代理商/技術參數
參數描述
TSC2302IRGZRG4 功能描述:觸摸屏轉換器和控制器 Prog 4-Wire w/20-Bit Stereo Audio Codec RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20
TSC2303IZQZ 制造商:Texas Instruments 功能描述:
TSC2303IZQZR 制造商:Texas Instruments 功能描述:
TSC236 制造商:TSC 制造商全稱:Taiwan Semiconductor Company, Ltd 功能描述:High Voltage NPN Transistor
TSC236CIC0 制造商:TSC 制造商全稱:Taiwan Semiconductor Company, Ltd 功能描述:High Voltage NPN Transistor
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*