REV. 1.0.3 voltage at the pin should be 3.3V when an external clock is supplied." />
參數資料
型號: XR19L402IL48-0B-EB
廠商: Exar Corporation
文件頁數: 2/49頁
文件大小: 0K
描述: EVAL BOARD FOR XR19L402-B 48QFN
標準包裝: 1
系列: *
XR19L402
10
TWO CHANNEL INTEGRATED UART AND RS-485 TRANSCEIVER
REV. 1.0.3
voltage at the pin should be 3.3V when an external clock is supplied. For programming details, see
“Programmable Baud Rate Generator.”
FIGURE 5. TYPICAL CRYSTAL CONNECTIONS
C1
22-47pF
C2
22-47pF
Y1
1.8432 MHz
to
24 MHz
R1
0-120
(Optional)
R2
500K - 1M
XTAL1
XTAL2
The on-chip oscillator is designed to use an industry standard microprocessor crystal (parallel resonant,
fundamental frequency with 10-22 pF capacitance load, ESR of 20-120 ohms and 100ppm frequency
tolerance) connected externally between the XTAL1 and XTAL2 pins. When VCC = 5V, the on-chip oscillator
can operate with a crystal whose frequency is not greater than 24 MHz. On the other hand, the L402 can
accept an external clock of up to 64 MHz at XTAL1 pin which results in a maximum data rate of 8 Mbps. For
further reading on the oscillator circuit please see DAN108 on EXAR’s web site at http://www.exar.com.
2.9
Programmable Baud Rate Generator with Fractional Divisor
Each UART has its own Baud Rate Generator (BRG) with a prescaler for the transmitter and receiver. The
prescaler is controlled by a software bit in the MCR register. The MCR register bit-7 sets the prescaler to divide
the input crystal or external clock by 1 or 4. The output of the prescaler clocks to the BRG. The BRG further
divides this clock by a programmable divisor between 1 and (216 - 0.0625) in increments of 0.0625 (1/16) to
obtain a 16X or 8X sampling clock of the serial data rate. The sampling clock is used by the transmitter for data
bit shifting and receiver for data sampling. The BRG divisor (DLL, DLM and DLD registers) defaults to the value
of ’1’ (DLL = 0x01, DLM = 0x00 and DLD = 0x00) upon reset. Therefore, the BRG must be programmed during
initialization to the operating data rate. The DLL and DLM registers provide the integer part of the divisor and
the DLD register provides the fractional part of the dvisior. Only the four lower bits of the DLD are implemented
and they are used to select a value from 0 (for setting 0000) to 0.9375 or 15/16 (for setting 1111). Programming
the Baud Rate Generator Registers DLL, DLM and DLD provides the capability for selecting the operating data
rate. Table 5 shows the standard data rates available with a 24MHz crystal or external clock at 16X clock rate.
If the pre-scaler is used (MCR bit-7 = 1), the output data rate will be 4 times less than that shown in Table 5. At
8X sampling rate, these data rates would double. Also, when using 8X sampling mode, please note that the bit-
time will have a jitter (+/- 1/16) whenever the DLD is non-zero and is an odd number. When using a non-
standard data rate crystal or external clock, the divisor value can be calculated with the following equation(s):
Required Divisor (decimal) = (XTAL1 clock frequency / prescaler) / (serial data rate x 16), with 16X mode EMSR[7] = 1
Required Divisor (decimal) = (XTAL1 clock frequency / prescaler / (serial data rate x 8), with 8X mode EMSR[7] = 0
相關PDF資料
PDF描述
W681511DK KIT DEVELOPMENT FOR W681511
M3DDK-1420K IDC CABLE - MKR14K/MC14F/MKR14K
5503162-5 CABLE ASSY,2.5BAY,SM DUAL,5 M1
ACC06DRXS CONN EDGECARD 12POS .100 DIP SLD
RBC17DREI-S13 CONN EDGECARD 34POS .100 EXTEND
相關代理商/技術參數
參數描述
XR19L402IL48-F 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR1AEX2NV1XX 制造商:Eaton Corporation 功能描述:SWITCH, ROCKER, SPST, 18A, 125VAC, BLACK, Contact Configuration:SPST, Switch Ope 制造商:Eaton Corporation 功能描述:SWITCH, ROCKER, SPST, 18A, 125VAC, BLACK, Contact Configuration:SPST, Switch Operation:Off-On, Contact Current Max:18A, Contact Voltage AC Nom:125V, Switch Mounting:Panel, Actuator / Cap Color:Red, Illumination Color:Red , RoHS Compliant: Yes
XR1AEX3NV1XX 制造商:Eaton Corporation 功能描述:SWITCH, ROCKER, SPST, 18A, 125VAC, BLACK, Contact Configuration:SPST, Switch Ope
XR1AEX4NV1XX 制造商:Eaton Corporation 功能描述:SWITCH, ROCKER, SPST, 18A, 125VAC, BLACK, Contact Configuration:SPST, Switch Operation:Off-On, Contact Current Max:18A, Contact Voltage AC Nom:125V, Switch Mounting:Panel, Actuator / Cap Color:Amber, Illumination Color:Amber , RoHS Compliant: Yes
XR1BG33NV1XX 制造商:Eaton Corporation 功能描述:SWITCH, ROCKER, SPDT, 18A, 125VAC, BLACK, Contact Configuration:SPDT, Switch Ope