參數資料
型號: Z8913820FSC
廠商: ZILOG INC
元件分類: 數字信號處理
英文描述: 8-BIT, 20.48 MHz, MIXED DSP, PQFP100
封裝: QFP-100
文件頁數: 12/65頁
文件大?。?/td> 2054K
代理商: Z8913820FSC
Z89138/Z89139
Voice Processing Controllers
Zilog
2
P R E L I M I N A R Y
DS97TAD0201
GENERAL DESCRIPTION (Continued)
Power connections follow conventional descriptions be-
low:
Z8 Core Processor
The on-chip Z8 is Zilog’s 8-bit microcontroller core with an
Expanded Register File to allow access to register-
mapped peripheral and I/O circuits. The Z8 offers a flexible
I/O scheme, an efficient register and address space struc-
ture and a number of ancillary features, which makes it
ideally suited for high-volume processing, peripheral con-
trollers, and consumer applications.
For applications demanding powerful I/O capabilities, the
Z89138 provides 47 pins dedicated to input and output.
These I/O lines are grouped into six ports. Each port is
configurable under software control to provide timing, sta-
tus signals and parallel I/O with or without handshake.
Four basic memory resources for the Z8 are available to
support a wide range of configurations: Program Memory,
Register File, Data Memory, and Expanded Register File.
The Z8 core processor is supported by an efficient register
file that allows any of 256 on-board data and control regis-
ters to be either the source and/or the destination of almost
any instruction. This unique architecture eliminates tradi-
tional microprocessor Accumulator bottlenecks and per-
mits rapid content switching.
The Register File is composed of 236 bytes of general-pur-
pose registers, four I/O port registers, and 15 control and
status registers. The Expanded Register File consists of
mailbox registers, WDT mode register, DSP Control regis-
ter, Stop-Mode Recovery register, Port Configuration reg-
ister, and the control and data registers for Port 4 and Port
5. Some of these registers are shared with the DSP.
To unburden the software from supporting real-time prob-
lems such as counting/timing and data communication, the
Z8 offers two on-chip counter/timers with a large number
of user-selectable modes.
Watch-Dog Timer and Stop-Mode Recovery features are
software driven by setting specific bits in control registers.
STOP and HALT instructions support reduced power op-
eration. The low-power Stop Mode allows parameter infor-
mation to be stored in the register file if power fails. An ex-
ternal capacitor or battery will retain device memory and
power the 32 kHz timer.
DSP Coprocessor
The DSP coprocessor is a second generation, 16-bit
two’s- complement CMOS Digital Signal Processor (DSP).
Most instructions, including multiply and accumulate, are
accomplished in a single clock cycle. The processor con-
tains two on-chip data RAM blocks of 256 words, a 6K
word program ROM, 24-bit ALU, 16x16 multiplier, 24-bit
Accumulator, shifter, six-level stack, three vectored inter-
rupts and two inputs for conditional program jumps. Each
RAM block contains a set of four pointers which can be in-
cremented or decremented automatically to affect hard-
ware looping without software overhead. The data RAMs
can be simultaneously addressed and loaded to the multi-
plier for a true single-cycle scalar multiply.
Four external DSP registers are mapped into the expand-
ed register file of the Z8. Communication between the Z8
and the DSP occurs through those common registers that
form the mailbox registers.
The analog output is generated by a 10-bit resolution
Pulse Width Modulator (PWM). The PWM output is a digi-
tal signal with CMOS output levels. The output signal has
a resolution of 1 in 1024 with a sampling rate of 16 kHz
(XTAL = 20.48 MHz). The sampling rate can be changed
under software control and can be set at 10 and 16 kHz.
The dynamic range of the PWM is from 0 to 4V.
An 8-bit resolution half-flash A/D converter is provided.
The conversion is conducted with a sampling frequency of
16 kHz. (XTAL = 20.48 MHz) in order to provide oversam-
pling. The input signal is 4V peak to peak.
Two additional timers (Timer2 and Timer3) have been
added to support different sampling rates for the A/D and
D/A converters. These timers are free-running counters
that divide the crystal frequency to the appropriate sam-
pling of frequency. Two DSP I/O pins: DSP0, DSP1 are
provided for application.
Connection
Circuit
Device
Power
VCC
VDD
Ground
GND
VSS
相關PDF資料
PDF描述
Z9025106PSC 8-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDIP42
ZADM023H151.0012 PROXIMITY SENSOR-PHOTOELECTRIC, 150-150mm, 4-20mA, RECTANGULAR, BOARD MOUNT
ZADM023H300.0002 PROXIMITY SENSOR-PHOTOELECTRIC, 30-30mm, 4-20mA, RECTANGULAR, BOARD MOUNT
ZADM023H351.0001 PROXIMITY SENSOR-PHOTOELECTRIC, 350-350mm, 4-20mA, RECTANGULAR, BOARD MOUNT
ZADM023H351.0011 PROXIMITY SENSOR-PHOTOELECTRIC, 350-350mm, 4-20mA, RECTANGULAR, BOARD MOUNT
相關代理商/技術參數
參數描述
Z8913829ASC 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
Z8913829FSC 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
Z89139 制造商:ZILOG 制造商全稱:ZILOG 功能描述:Voice Processing Controllers
Z8913920ASC 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
Z8913920FSC 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller