- 您現在的位置：買賣IC網 > PDF目錄33600 > 405GP (Applied Micro Circuits Corp.) Power PC 405GP Embedded Processor PDF資料下載
參數資料
| 型號： | 405GP |
| 廠商： | Applied Micro Circuits Corp. |
| 英文描述： | Power PC 405GP Embedded Processor |
| 中文描述： | 405GP的Power PC嵌入式處理器 |
| 文件頁數： | 43/59頁 |
| 文件大?。?/td> | 782K |
| 代理商： | 405GP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
405GP – Power PC 405GP Embedded Processor
48
AMCC
Revision 2.03 – September 7, 2007
Data Sheet
Spread Spectrum Clocking
Care must be taken when using a spread spectrum clock generator (SSCG) with the PPC405GP. This controller
uses a PLL for clock generation inside the chip. The accuracy with which the PLL follows the SSCG is referred to
as tracking skew. The PLL bandwidth and phase angle determine how much tracking skew there is between the
SSCG and the PLL for a given frequency deviation and modulation frequency. When using an SSCG with the
PPC405GP the following conditions must be met:
The frequency deviation must not violate the minimum clock cycle time. Therefore, when operating the
PPC405GP with one or more internal clocks at their maximum supported frequency, the SSCG can only lower
the frequency.
The maximum frequency deviation cannot exceed
3%, and the modulation frequency cannot exceed 40kHz.
In some cases, on-board PPC405GP peripherals impose more stringent requirements (see Note 1).
Use the peripheral bus clock (PerClk) for logic that is synchronous to the peripheral bus since this clock tracks
the modulation.
Use the SDRAM MemClkOut since it also tracks the modulation.
Please refer to the application note Using a Spread Spectrum Clock Generator with the PowerPC 405GP for
additional details. This application note is available on the AMCC web site at http://www.amcc.com.
Notes:
1. The serial port baud rates are synchronous to the modulated clock. The serial port has a tolerance of
approximately 1.5% on baud rate before framing errors begin to occur. The 1.5% tolerance assumes that the
connected device is running at precise baud rates. If an external serial clock is used the baud rate is unaffected
by the modulation.
2. Operation of the PPC405GP PCI Bridge is unaffected by the use of a SSCG.
For PCI frequencies of 33.33 MHz and below the PCI controller supports synchronous mode operation. This is
accomplished by strapping the PPC405GP for synchronous mode PCI and connecting the PCI bus clock to the
PPC405GP SysClk input. For 33.33 MHz signalling, the PCI specification has no limitation on the amount of
frequency deviation or modulation that may be applied to the PCI clock. Therefore, the PPC405GP SSCG
requirements stated above take precedence.
At PCI frequencies above 33.33 MHz, the PCI controller must be operated in asynchronous mode. When in
asynchronous mode, the PCI bus clock must be driven into the PPC405GP PCIClk input. In this configuration
the PCI controller supports the 66.66 MHz PCI clock specification which specifies a maximum frequency
deviation of -1% at a modulation of between 30 kHz and 33 kHz.
3. Ethernet operation is unaffected.
4. IIC operation is unaffected.
Caution: It is up to the system designer to ensure that any SSCG used with the PPC405GP meets the above
requirements and does not adversely affect other aspects of the system.
相關PDF資料 |
PDF描述 |
|---|---|
| 4060120000 | RELAY,MICROSERIES 24 V,1CO |
| 4060EFE | Standalone Linear NiMH/NiCd Fast Battery Charger |
| 40659 | 2.5 mm2, BRASS, RING TERMINAL |
| 40696 | 6 mm2, RING TERMINAL |
| 40696-2 | RING TERMINAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 405GPR | 制造商:AMCC 制造商全稱:Applied Micro Circuits Corporation 功能描述:Power PC 405GPr Embedded Processor |
| 405-GR | 制造商:Leviton Manufacturing Co 功能描述: |
| 405HC5900KR | 功能描述:4μF Film Capacitor 900V Polypropylene (PP) Axial 4.016" Dia (102.00mm) 制造商:illinois capacitor 系列:HC5 包裝:散裝 零件狀態(tài):新產品 電容:4μF 容差:±10% 額定電壓 - AC:900V 額定電壓 - DC:- 介電材料:聚丙烯（PP） ESR（等效串聯電阻）:0.9 毫歐 工作溫度:-40°C ~ 85°C 安裝類型:底座安裝 封裝/外殼:軸向 大小/尺寸:4.016" 直徑（102.00mm） 高度 - 安裝（最大值）:2.819"（71.60mm） 端接:螺釘端子 引線間距:- 應用:傳導冷卻，高脈沖，DV/DT 特性:- 標準包裝:5 |
| 405I11AM | 制造商:CTS 制造商全稱:CTS Corporation 功能描述:Surface Mount Quartz Crystal |
| 405I11BM | 制造商:CTS 制造商全稱:CTS Corporation 功能描述:Surface Mount Quartz Crystal |
發(fā)布緊急采購，3分鐘左右您將得到回復。