參數資料
型號: A3PE-STARTER-KIT-2
廠商: Microsemi SoC
文件頁數: 59/162頁
文件大小: 0K
描述: KIT EVAL FOR A3PE1500 PROASIC3
產品變化通告: Kit/Part Number Change 25/Jul/2012
標準包裝: 1
系列: ProASIC3
類型: FPGA
適用于相關產品: A3PE1500
所含物品: 板,電源,編程器
其它名稱: 1100-1144
A3PE-STARTER-KIT
Revision 13
5-1
5 – Datasheet Information
List of Changes
The following table lists critical changes that were made in each revision of the ProASIC3E datasheet.
Revision
Changes
Page
Revision 13
(January 2013)
(CCC) and PLL Wide Input Frequency Range from ’1.5 MHz to 200 MHz’ to
’1.5MHz to 350 MHz’ based on Table 2-98 ProASIC3E CCC/PLL Specification
(SAR 22196).
The "ProASIC3E Ordering Information" section has been updated to mention "Y"
as "Blank" mentioning "Device Does Not Include License to Implement IP Based
on the Cryptography Research, Inc. (CRI) Patent Portfolio" (SAR 43220).
The programming temperature range supported is Tambient = 0°C to 85°C.
The note in Table 2-98 ProASIC3E CCC/PLL Specification referring the reader
to SmartGen was revised to refer instead to the online help associated with the
core (SAR 42571).
Libero Integrated Design Environment (IDE) was changed to Libero System-on-
Chip (SoC) throughout the document (SAR 40285).
Live at Power-Up (LAPU) has been replaced with ’Instant On’.
NA
Revision 12
(September 2012)
The "Security" section was modified to clarify that Microsemi does not support
read-back of programmed data.
Revision 11
(August 2012)
Added a Note stating "VMV pins must be connected to the corresponding VCCI pins.
information.
The drive strength, IOL, and IOH value for 3.3 V GTL and 2.5 V GTL was
changed from 25 mA to 20 mA in the following tables (SAR 31924):
Also added note stating "Output drive strength is below JEDEC specification." for
Tables 2-17 and 2-19.
Additionally, the IOL and IOH values for 3.3 V GTL+ and 2.5 V GTL+ were
corrected from 51 to 35 (for 3.3 V GTL+) and from 40 to 33 (for 2.5 V GTL+) in
table Table 2-13 (SAR 39714).
the maximum temperature from 110°C to 100°C, with an example of six months
instead of three months (SAR 37934).
The following sentence was deleted from the "2.5 V LVCMOS" section (SAR
34796):
"It uses a 5 V–tolerant input buffer and push-pull output buffer." This change was
made in revision 10 and omitted from the change table in error.
相關PDF資料
PDF描述
0210490279 CABLE JUMPER 1.25MM .051M 22POS
EBM22DCMD-S288 CONN EDGECARD 44POS .156 EXTEND
ECA14DRMI-S288 CONN EDGECARD 28POS .125 EXTEND
0210490905 CABLE JUMPER 1.25MM .102M 21POS
MPC8377E-RDBA BOARD REF DES MPC8377 REV 2.1
相關代理商/技術參數
參數描述
A3PFA1X201J1 制造商:APEM 功能描述:Pushbutton,A3,latching,12V,red
A3PFA1X201J2 制造商:APEM 功能描述:Pushbutton,latching,12V,green
A3PFA1X201J3 制造商:APEM 功能描述:Pushbutton,latching,12V,amber
A3PFA1X201J4 制造商:APEM 功能描述:Pushbutton,A3,latching,12V,blue
A3PFA1X201K1 制造商:APEM 功能描述:Pushbutton,A3,latching 24V,red