- 您現在的位置：買賣IC網 > PDF目錄9660 > ADN2818ACPZ-RL7 (Analog Devices Inc)IC CLOCK/DATA RECOVERY 32-LFCSP PDF資料下載
參數資料
| 型號： | ADN2818ACPZ-RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/40頁 |
| 文件大小： | 0K |
| 描述： | IC CLOCK/DATA RECOVERY 32-LFCSP |
| 標準包裝： | 1,500 |
| 類型： | 時鐘和數據恢復（CDR），多路復用器 |
| PLL： | 是 |
| 主要目的： | SONET/SDH |
| 輸入： | CML |
| 輸出： | CML |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:2 |
| 差分 - 輸入:輸出： | 是/是 |
| 頻率 - 最大： | 2.7GHz |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 32-LFCSP-VQ（5x5） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
Data Sheet
ADN2817/ADN2818
Rev. E | Page 19 of 40
JITTER SPECIFICATIONS
The ADN2817/ADN2818 CDR is designed to achieve the best
bit error rate (BER) performance and exceeds the jitter transfer,
generation, and tolerance specifications proposed for SONET/SDH
equipment defined in the Telcordia Technologies specification.
Jitter is the dynamic displacement of digital signal edges from
their long-term average positions, measured in unit intervals
(UI), where 1 UI = 1 bit period. Jitter on the input data can cause
dynamic phase errors on the recovered clock sampling edge. Jitter
on the recovered clock causes jitter on the retimed data.
The following sections briefly summarize the specifications
of jitter generation, transfer, and tolerance in accordance with
the Telcordia document (GR-253-CORE, Issue 3, September
2000) for the optical interface at the equipment level and the
ADN2817/ADN2818 performance with respect to those
specifications.
JITTER GENERATION
The jitter generation specification limits the amount of jitter
that can be generated by the device with no jitter and wander
applied at the input. For OC-48 devices, the band-pass filter
has a 12 kHz high-pass cutoff frequency with a roll-off of
20 dB/decade and a low-pass cutoff frequency of at least
20 MHz. The jitter generated must be less than 0.01 UI rms
and must be less than 0.1 UI p-p.
JITTER TRANSFER
The jitter transfer function is the ratio of the jitter on the output
signal to the jitter applied on the input signal vs. the frequency.
This parameter measures the limited amount of the jitter on
an input signal that can be transferred to the output signal
0.1
ACCEPTABLE
RANGE
fC
JITTER FREQUENCY (kHz)
SLOPE = –20dB/DECADE
JI
TTE
R
GA
IN
(
d
B
)
0
60
01-
01
5
Figure 26. Jitter Transfer Curve
JITTER TOLERANCE
The jitter tolerance is defined as the peak-to-peak amplitude of
the sinusoidal jitter applied on the input signal, which causes a
1 dB power penalty. This is a stress test intended to ensure that
no additional penalty is incurred under the operating conditions
(see Figure 27).
15.00
1.50
0.15
f0
f1
f2
f3
f4
JITTER FREQUENCY (kHz)
SLOPE = –20dB/DECADE
IN
P
U
T
J
ITT
E
R
A
M
P
L
ITU
D
E
(
U
I
p-
p
)
060
01
-01
6
Figure 27. SONET Jitter Tolerance Mask
相關PDF資料 |
PDF描述 |
|---|---|
| MS27472E24B35SA | CONN RCPT 128POS WALL MNT W/SCKT |
| MS27468T25B19P | CONN RCPT 19POS JAM NUT W/PINS |
| SY87701LZG | IC CLOCK/DATA RECOVERY 28-SOIC |
| VI-21Z-MV-F2 | CONVERTER MOD DC/DC 2V 60W |
| SY87721LHY TR | IC CLOCK/DATA RECOVERY 64-TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADN2819 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multirate to 2.7 Gb/s Clock and Data Recovery IC with Integrated Limiting Amp |
| ADN2819ACP-CML | 制造商:Analog Devices 功能描述:CDR 2488.32Mbps/2666.06Mbps SONET/SDH 48-Pin LFCSP EP Tray 制造商:Rochester Electronics LLC 功能描述:MULTI-RATE 2.7GBPS CDR/ PA LOW POWER I.C - Bulk |
| ADN2819ACP-CML-RL | 制造商:Analog Devices 功能描述:CDR 2488.32Mbps/2666.06Mbps SONET/SDH 48-Pin LFCSP EP T/R |
| ADN2819ACPZ-CML | 功能描述:IC CLOCK/DATA RECOVERY 48LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:28 系列:- 類型:時鐘/頻率發生器 PLL:是 主要目的:Intel CPU 服務器 輸入:時鐘 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:3:22 差分 - 輸入:輸出:無/是 頻率 - 最大:400MHz 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:64-TFSOP （0.240"，6.10mm 寬） 供應商設備封裝:64-TSSOP 包裝:管件 |
| ADN2819ACPZ-CML1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Multirate to 2.7 Gb/s Clock and Data Recovery IC with Integrated Limiting Amp |
發布緊急采購，3分鐘左右您將得到回復。