- 您現在的位置：買賣IC網 > PDF目錄16215 > CP2201EK (Silicon Laboratories Inc)KIT EVAL FOR CP2201 ETH CTRLR PDF資料下載
參數資料
| 型號： | CP2201EK |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 25/108頁 |
| 文件大?。?/td> | 0K |
| 描述： | KIT EVAL FOR CP2201 ETH CTRLR |
| 標準包裝： | 1 |
| 主要目的： | 接口，以太網傳感器 |
| 嵌入式： | 是，MCU，8 位 |
| 已用 IC / 零件： | CP2200，CP2201 |
| 主要屬性： | 溫度和光傳感器 |
| 次要屬性： | 圖形用戶界面 |
| 已供物品： | 板，電源，線纜，CD |
| 產品目錄頁面： | 627 (CN2011-ZH PDF) |
| 相關產品： | 336-1313-ND - IC ETH CTRLR SNGL-CHIP 28QFN 336-1312-ND - IC ETH CTRLR SNGL-CHIP 48TQFP |
| 其它名稱： | 336-1316 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁
CP2200/1
Rev. 1.0
23
7. Internal Memory and Registers
The CP2200/1 is controlled through direct and indirect registers accessible through the parallel host interface. The
host interface provides an 8-bit address space, of which there are 114 valid direct register locations (see Table 11
on page 25). All remaining addresses in the memory space are reserved and should not be read or written. The
direct registers provide access to the RAM buffers, Flash memory, indirect MAC configuration registers, and other
status and control registers for various device functions.
Figure 13 shows the RAM and Flash memory organization. The transmit and receive RAM buffers share the same
address space and are both accessed using the RAMADDRH:RAMADDRL pointer. Each of the buffers has a
dedicated data register. The Flash memory has a separate address space and a dedicated address pointer and
data register. See “13. Flash Memory” on page 73 for detailed information on how to read and write to Flash.
Figure 13. RAM Buffers and Flash Memory Organization
7.1. Random Access to RAM Transmit and Receive Buffers
The most common and most efficient methods for accessing the transmit and receive buffers are the AutoWrite
and AutoRead interfaces. These interfaces allow entire packets to be written or read at a time. In very few cases,
the transmit and receive buffers may need to be accessed randomly. An example of this is a system in which a
specific byte in the packet is checked to determine whether to read the packet or discard it. The following
procedure can be used to read or write data to either RAM buffer:
Step 1: Write the address of the target byte to RAMADDRH:RAMADDRL.
Step 2: Transmit Buffer:
Read or write 8-bit data to RAMTXDATA to read or write from the target byte in the transmit buffer.
Receive Buffer:
Read or write 8-bit data to RAMRXDATA to read or write from the target byte in the receive buffer.
Note: Reads and writes of the RAM buffers using the random access method are independent of the
AutoRead and AutoWrite interfaces. Each of the interfaces has a dedicated set of address and data
registers. See “11.2. Transmitting a Packet” on page 48 and “12.2. Reading a Packet Using the
Autoread Interface” on page 58 for additional information about the AutoRead and AutoWrite
interfaces.
Flash Memory (8K)
0x0000 – 0x1FFF
Transmit Buffer (2K)
0x0000 – 0x07FF
Receive Buffer (4K)
0x0000 – 0x0FFF
RAMADDRH:RAMADDRL
FLASHADDRH:FLASHADDRL
相關PDF資料 |
PDF描述 |
|---|---|
| PM1210-820J-RC | INDUCTOR 82UH 5% 1210 SMD |
| H3WWH-6036G | IDC CABLE - HPL60H/AE60G/HPL60H |
| UPS2C471MRD | CAP ALUM 470UF 160V 20% RADIAL |
| A3CKB-4006M | IDC CABLE - AKC40B/AE40M/APK40B |
| MODEMDK | KIT DEV EMBEDDED MODEM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CP2201-GM | 功能描述:以太網 IC Ethernet Controller RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| CP2201-GMR | 功能描述:以太網 IC Ethernet Controller RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| CP-220-K | 制造商:PREMO 制造商全稱:PREMO CORPORATION S.L 功能描述:Coils and Chokes for general use |
| CP221 | 制造商:CENTRAL 制造商全稱:Central Semiconductor Corp 功能描述:Small Signal Transistor |
| CP-221 1 1/2"BL 100' | 功能描述:HEATSHRNK CP221 1-1/2" X 100'BLK 制造商:3m 系列:CP-221 零件狀態:過期 類型:套管，彈性 收縮率:2 至 1 長度:100'（30.48m） 內徑（出廠）:1.500"（38.1mm） 內徑 - 恢復后:0.752"（19.1mm） 恢復后的壁厚:0.040"（1.02mm） 材料:聚烯烴（PO） 特性:自熄滅 顏色:黑 工作溫度:-55°C ~ 135°C 收縮溫度:121°C 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。