參數資料
型號: CP2201EK
廠商: Silicon Laboratories Inc
文件頁數: 53/108頁
文件大?。?/td> 0K
描述: KIT EVAL FOR CP2201 ETH CTRLR
標準包裝: 1
主要目的: 接口,以太網傳感器
嵌入式: 是,MCU,8 位
已用 IC / 零件: CP2200,CP2201
主要屬性: 溫度和光傳感器
次要屬性: 圖形用戶界面
已供物品: 板,電源,線纜,CD
產品目錄頁面: 627 (CN2011-ZH PDF)
相關產品: 336-1313-ND - IC ETH CTRLR SNGL-CHIP 28QFN
336-1312-ND - IC ETH CTRLR SNGL-CHIP 48TQFP
其它名稱: 336-1316
CP2200/1
Rev. 1.0
49
11.5. Transmit Status and Control Registers
The CP2200 transmit interface is controlled and managed through the registers in Table 14. After each packet is
transmitted, information about the last transmitted packet can be obtained from the 52-bit transmit status vector
accessible through the TXSTA0 — TXSTA6 registers. The transmit status vector is described in Table 15.
Table 14. Transmit Status and Control Register Summary
Register
Long Name
Address
Description
TXCN
Transmit Control
0x53
Contains the transmit configuration option over-
ride bits and the TXGO bit used to start packet
transmission.
TXBUSY
Transmit Busy Indicator
0x54
Read-only register returning 0x01 when transmit
interface is currently transmitting a packet and
0x00 when transmit interface is not transmitting.
TXPAUSEH
TXPAUSEL
Transmit Pause High and Low Bytes
0x55
0x56
16-bit pause value used for PAUSE packet
transmission. The pause value is in units of 512
bit times (51.2
μs).
TXSTARTH
TXSTARTL
Transmit Data Starting Address High
and Low Bytes
0x59
0x5A
Starting address of outgoing packet in the trans-
mit buffer. Packets added to the transmit buffer
must start at 0x0000.
TXENDH
TXENDL
Transmit Data Ending Address High
and Low Bytes
0x57
0x58
Address of last byte added to the transmit
buffer. This register is managed by hardware.
TXAUTOWR Transmit Data AutoWrite
0x03
Writes to this register add a byte to the transmit
buffer, set TXEND to the address of the written
byte, and increment TXSTART.
TXSTA6
TXSTA5
TXSTA4
TXSTA3
TXSTA2
TXSTA1
TXSTA0
Transmit Status Vector
0x5C
0x5D
0x5E
0x5F
0x60
0x61
0x62
52-bit transmit status vector containing informa-
tion about the last transmitted packet including
collision count, successful transmission, total
bytes transmitted, etc.
相關PDF資料
PDF描述
PM1210-820J-RC INDUCTOR 82UH 5% 1210 SMD
H3WWH-6036G IDC CABLE - HPL60H/AE60G/HPL60H
UPS2C471MRD CAP ALUM 470UF 160V 20% RADIAL
A3CKB-4006M IDC CABLE - AKC40B/AE40M/APK40B
MODEMDK KIT DEV EMBEDDED MODEM
相關代理商/技術參數
參數描述
CP2201-GM 功能描述:以太網 IC Ethernet Controller RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
CP2201-GMR 功能描述:以太網 IC Ethernet Controller RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
CP-220-K 制造商:PREMO 制造商全稱:PREMO CORPORATION S.L 功能描述:Coils and Chokes for general use
CP221 制造商:CENTRAL 制造商全稱:Central Semiconductor Corp 功能描述:Small Signal Transistor
CP-221 1 1/2"BL 100' 功能描述:HEATSHRNK CP221 1-1/2" X 100'BLK 制造商:3m 系列:CP-221 零件狀態:過期 類型:套管,彈性 收縮率:2 至 1 長度:100'(30.48m) 內徑(出廠):1.500"(38.1mm) 內徑 - 恢復后:0.752"(19.1mm) 恢復后的壁厚:0.040"(1.02mm) 材料:聚烯烴(PO) 特性:自熄滅 顏色:黑 工作溫度:-55°C ~ 135°C 收縮溫度:121°C 標準包裝:1