- 您現在的位置：買賣IC網 > PDF目錄366891 > CR16HCS9VJE8Y Microcontroller PDF資料下載
參數資料
| 型號： | CR16HCS9VJE8Y |
| 英文描述： | Microcontroller |
| 中文描述： | 微控制器 |
| 文件頁數： | 154/157頁 |
| 文件大?。?/td> | 1256K |
| 代理商： | CR16HCS9VJE8Y |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁當前第154頁第155頁第156頁第157頁
www.national.com
154
When a frame was successfully sent by CR16CAN the con-
tents of the Time Stamp counter are captured into the Time
Stamp register (TSTP) of the transmit buffer during the ACK-
slot of the frame currently being sent. Also, when a message
is received, the TSTP-register of the receiving buffer is load-
ed with the Time Stamp counter value during the ACK-slot of
the CAN frame currently being received.
This means, in the case where a message is received in one
buffer, which was sent from another buffer of the same
CR16CAN node, the TSTP-register contents are equal after
this transaction.
A comparison of the two TSTP-register values can be insert-
ed into a "read from CAN receive buffer" software routine, to
distinguish whether the data received are from another CAN
node (valid) or from the same CAN node (invalid).
The flowchart below shows a possible implementation. The
same CAN buffer settings as described in Section also apply
to this example.
Modified CAN Receive Sequence:
Advantage:
None of the CAN receive buffers must be disabled at any
time.
Disadvantage:
The receive buffer contents are overwritten by an invalid
message sent from the same CR16CAN node.
26.2
8/16-BIT MICROWIRE/SPI (MWSPI16)
26.2.1
According to the specification, the MSKn clock output in mas-
ter mode should have the value of the MnIDL bit of the
MWnCTL register, even when the module is disabled. How-
ever, the MSKn pin is enabled and the module is disabled.
thus, even if the MnIDL bit is set, the MSKn clock will change
MWSPI16 Problem Description
to a low level as soon as the module is disabled. If any slave
is selected at this time, i will interpret this unwanted transition
as a shift clock.
26.2.2
Even if the module is disabled and the alternate function of
the MSKn pin is enabled, the module can still influence the
MSKn pin and drives the default value ‘0’.
MWSPI16 Problem Cause
26.2.3
When the MSKn idle level of ‘1’ is to be used, the following
procedure should be followed when the module is disabled:
1. Set the MSKn pin to high level in the corresponding port
data output register.
2. Configure the MSKn pin to an output in the correspond-
ing port direction register.
3. Disable the alternate function of the MSKn pin in the cor-
responding port alternate function register.
4. Disable the MWSPI16 module.
MWSPI16 Problem Solutions
26.3
TIMING AND WATCHDOG MODULE
26.3.1
Timing and WATCHDOG Module Problem
Description
The available window for a valid WATCHDOG service varies
with the TWM configuration and the operating mode of the
R16MCS9. Therefore it is not possible to generally provide
the limits for the maximum service window. However, the lim-
its for the minimum service window is guaranteed and should
be used.
26.3.2
Timing and WATCHDOG Module Problem
Cause
The timing and WATCHDOG module uses two different clock
signals for its operation, the slow system clock as well as the
fast system clock.
The slow system clock can either be generated by an exter-
nal 32 kHz quartz or it can be derived from the fast system
clock by means of a prescaler counter in the CLK2RES mod-
ules. The TWM can operate off a maximum slow system
clock of 100 kHz. The WATCHDOG counter (down-counter)
is either clocked directly by the slow system (T0IN) or it is
decremented every time the counter T0 underflows
(T0OUT).
The fast system clock is used for accesses to TWM registers,
which build the user interface of the TWM. These user inter-
face registers include all memory-mapped registers of the
TWM.
Every time the user (CR16B core) writes to a TWM configu-
ration register or to the WATCHDOG Service Data Match
register, this “high speed operation” must be synchronized to
the internal TWM logic running at the slow clock rate. This
synchronization process takes a variable number of low
speed clock cycles, depending on the ratio between the low-
speed and the high-speed system clock and the phase shift
between the two clock signals. The more the two frequencies
differ from each other, the longer it takes the synchronization
process.
In other words, write operations to the TWM registers take a
certain number of low-speed clock cycles to show the desired
effects to the TWM logic.
Message received
into Buffer 1
Time Stamp of
Buffer 1
=
Time Stamp of
Buffer 0
Read out Buffer 1 Data
Reset Buffer 1 Status to
RX_READY
Exit
相關PDF資料 |
PDF描述 |
|---|---|
| CR16HCT5 | |
| CR16HCT5VJE7Y | Microcontroller |
| CR16HCT5VJE8Y | Microcontroller |
| CR16HCT5VJE9Y | Microcontroller |
| CR16HCT9 | |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CR16HCS9VJE9 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers |
| CR16HCS9VJI0 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers |
| CR16HCS9VJI1 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers |
| CR16HCS9VJI2 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers |
| CR16HCS9VJI3 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。