- 您現在的位置：買賣IC網 > PDF目錄377000 > DSP1628 TVS 400W 60V BIDIRECT SMA PDF資料下載
參數資料
| 型號： | DSP1628 |
| 英文描述： | TVS 400W 60V BIDIRECT SMA |
| 中文描述： | 澄清，串行I /設備的DSP1620/27/28/29 O控制注冊說明 |
| 文件頁數： | 25/114頁 |
| 文件大?。?/td> | 804K |
| 代理商： | DSP1628 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁
Preliminary Data Sheet
February 1997
DSP1628 Digital Signal Processor
Lucent Technologies Inc.
23
4 Hardware Architecture
(continued)
While ILD1 and OLD1 are not required externally for
multiprocessor operation, they are used internally in the
DSP's SIO. Setting the LD field of the master's
sioc
reg-
ister to a logic level 1 will ensure that the active genera-
tion of SYNC1, ILD1, and OLD1 is derived from OCK1
(see Table 26). With this configuration, all DSPs should
use ICK1 (tied to OCK1) in passive mode to avoid con-
flicts on the clock (CK) line (see the DSP1611/17/18/27
Digital Signal Processor Information Manualfor more
information).
Four registers (per SIO) configure the multiprocessor
mode: the time-division multiplexed slot register (
tdms
or
tdms2
), the serial receive and transmit address reg-
ister (
srta
or
srta2
), the serial data transmit register
(
sdx
or
sdx2
), and the multiprocessor serial address/
protocol register (
saddx
or
saddx2
).
Multiprocessor mode requires no external logic and
uses a TDM interface with eight 16-bit time slots per
frame. The transmission in any time slot consists of
16 bits of serial data in the data channel and 16 bits of
address and protocol information in the address/proto-
col channel. The address information consists of the
transmit address field of the
srta
register of the trans-
mitting device. The address information is transmitted
concurrently with the transmission of the first 8 bits of
data. The protocol information consists of the transmit
protocol field written to the
saddx
register and is trans-
mitted concurrently with the last 8 bits of data (see
Table 29, Multiprocessor Protocol Register). Data is re-
ceived or recognized by other DSP(s) whose receive
address matches the address in the address/protocol
channel. Each SIO port has a user-programmable re-
ceive address and transmit address associated with it.
The transmit and receive addresses are programmed in
the
srta
register.
In multiprocessor mode, each device can send data in
a unique time slot designated by the
tdms
register
transmit slot field (bits 7—0). The
tdms
register has a
fully decoded transmit slot field in order to allow one
DSP1628 device to transmit in more than one time slot.
This procedure is useful for multiprocessor systems
with less than eight DSP1628 devices when a higher
bandwidth is necessary between certain devices in that
system. The DSP operating during time slot 0 also
drives SYNC1.
In order to prevent multiple bus drivers, only one DSP
can be programmed to transmit in a particular time slot.
In addition, it is important to note that the address/pro-
tocol channel is 3-stated in any time slot that is not being
driven.
Therefore, to prevent spurious inputs, the address/pro-
tocol channel should be pulled up to V
DD
with a 5 k
re-
sistor, or it should be guaranteed that the bus is driven
in every time slot. (If the SYNC1 signal is externally gen-
erated, then this pull-up is required for correct initializa-
tion.)
Each SIO also has a fully decoded transmitting address
specified by the
srta
register transmit address field (bits
7—0). This is used to transmit information regarding the
destination(s) of the data. The fully decoded receive ad-
dress specified by the
srta
register receive address field
(bits 15—8) determines which data will be received. The
SIO protocol channel data is controlled via the
saddx
register. When the
saddx
register is written, the lower 8
bits contain the 8-bit protocol field. On a read, the high-
order 8 bits read from
saddx
are the most recently re-
ceived protocol field sent from the transmitting DSP's
saddx
output register. The low-order 8 bits are read as
0s.
An example use of the protocol channel is to use the top
3 bits of the
saddx
value as an encoded source address
for the DSPs on the multiprocessor bus. This leaves the
remaining 5 bits available to convey additional control
information, such as whether the associated field is an
opcode or data, or whether it is the last word in a trans-
fer, etc. These bits can also be used to transfer parity in-
formation about the data. Alternatively, the entire field
can be used for data transmission, boosting the band-
width of the port by 50%.
Using SIO2
The SIO2 functions the same as the SIO. Please refer
to Pin Multiplexing in Section 4.1 for a description of pin
multiplexing of BIO, PHIF, VEC[3:0], and SIO2.
相關PDF資料 |
PDF描述 |
|---|---|
| DSP16210 | TVS 400W 6.5V UNIDIRECT SMA |
| DSP1627 | TVS 400W 6.5V BIDIRECT SMA |
| DSP1629 | TVS 400W 64V UNIDIRECT SMA |
| DSP16410C | TVS 400W 7.0V UNIDIRECT SMA |
| DSP16410 | 16-bit fixed point DSP with Flash |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSP1629 | 制造商:AGERE 制造商全稱:AGERE 功能描述:DSP1629 Digital Signal Processor |
| DSP1629BA10K10IT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP|16-BIT|CMOS|BGA|144PIN|PLASTIC |
| DSP1629BA10K12.5IR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:16-Bit Digital Signal Processor |
| DSP1629BA10K16.7IT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP|16-BIT|CMOS|BGA|144PIN|PLASTIC |
| DSP1629BA10K19.2IR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:16-Bit Digital Signal Processor |
發布緊急采購，3分鐘左右您將得到回復。