- 您現在的位置：買賣IC網 > PDF目錄19290 > DSP56303VF100B1 (Freescale Semiconductor)IC DSP 24BIT 100MHZ 196-BGA PDF資料下載
參數資料
| 型號： | DSP56303VF100B1 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 2/108頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DSP 24BIT 100MHZ 196-BGA |
| 標準包裝： | 630 |
| 系列： | DSP563xx |
| 類型： | 定點 |
| 接口： | 主機接口，SSI，SCI |
| 時鐘速率： | 100MHz |
| 非易失內存： | ROM（576 B） |
| 芯片上RAM： | 24kB |
| 電壓 - 輸入/輸出： | 3.30V |
| 電壓 - 核心： | 3.30V |
| 工作溫度： | -40°C ~ 100°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 196-LBGA |
| 供應商設備封裝： | 196-MAPBGA（15x15） |
| 包裝： | 托盤 |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁
DSP56303 Technical Data, Rev. 11
1-6
Freescale Semiconductor
Signals/Connections
BG
Input
Ignored Input
Bus Grant—Asserted by an external bus arbitration circuit when the DSP56303
becomes the next bus master. When BG is asserted, the DSP56303 must wait until BB
is deasserted before taking bus mastership. When BG is deasserted, bus mastership is
typically given up at the end of the current bus cycle. This may occur in the middle of an
instruction that requires more than one external bus cycle for execution.
The default operation of this bit requires a setup and hold time as specified in Table 2-
14. An alternate mode can be invoked: set the asynchronous bus arbitration enable
(ABE) bit (Bit 13) in the Operating Mode Register. When this bit is set, BG and BB are
synchronized internally. This eliminates the respective setup and hold time
requirements but adds a required delay between the deassertion of an initial BG input
and the assertion of a subsequent BG input.
BB
Input/
Output
Ignored Input
Bus Busy—Indicates that the bus is active. Only after BB is deasserted can the
pending bus master become the bus master (and then assert the signal again). The
bus master may keep BB asserted after ceasing bus activity regardless of whether BR
is asserted or deasserted. Called “bus parking,” this allows the current bus master to
reuse the bus without rearbitration until another device requires the bus. BB is
deasserted by an “active pull-up” method (that is, BB is driven high and then released
and held high by an external pull-up resistor).
The default operation of this signal requires a setup and hold time as specified in Table
2-14. An alternative mode can be invoked by setting the ABE bit (Bit 13) in the
Operating Mode Register. When this bit is set, BG and BB are synchronized internally.
See BG for additional information.
Note: BB requires an external pull-up resistor.
CAS
Output
Tri-stated
Column Address Strobe—When the DSP is the bus master, CAS is an active-low
output used by DRAM to strobe the column address. Otherwise, if the Bus Mastership
Enable (BME) bit in the DRAM control register is cleared, the signal is tri-stated.
BCLK
Output
Tri-stated
Bus Clock
When the DSP is the bus master, BCLK is active when the Operating Mode Register
Address Trace Enable bit is set. When BCLK is active and synchronized to CLKOUT by
the internal PLL, BCLK precedes CLKOUT by one-fourth of a clock cycle.
BCLK
Output
Tri-stated
Bus Clock Not
When the DSP is the bus master, BCLK is the inverse of the BCLK signal. Otherwise,
the signal is tri-stated.
Table 1-8.
External Bus Control Signals (Continued)
Signal
Name
Type
State During Reset,
Stop, or Wait
Signal Description
相關PDF資料 |
PDF描述 |
|---|---|
| VI-24D-EU | CONVERTER MOD DC/DC 85V 200W |
| HMC30DRYH-S734 | CONN EDGECARD 60POS DIP .100 SLD |
| TACR475M010XTA | CAP TANT 4.7UF 10V 20% 0805 |
| VI-24B-EU | CONVERTER MOD DC/DC 95V 200W |
| VE-B6Y-CX-S | CONVERTER MOD DC/DC 3.3V 49.5W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSP56303VF100R2 | 功能描述:數字信號處理器和控制器 - DSP, DSC 24 BIT DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56303VL100 | 功能描述:數字信號處理器和控制器 - DSP, DSC 24 BIT DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56303VL100B1 | 功能描述:數字信號處理器和控制器 - DSP, DSC 24 BIT DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56304GC66 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:24-Bit Digital Signal Processor |
| DSP56304GC80 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:24-Bit Digital Signal Processor |
發布緊急采購，3分鐘左右您將得到回復。