- 您現在的位置：買賣IC網 > PDF目錄19290 > DSP56303VF100B1 (Freescale Semiconductor)IC DSP 24BIT 100MHZ 196-BGA PDF資料下載
參數資料
| 型號： | DSP56303VF100B1 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 25/108頁 |
| 文件大小： | 0K |
| 描述： | IC DSP 24BIT 100MHZ 196-BGA |
| 標準包裝： | 630 |
| 系列： | DSP563xx |
| 類型： | 定點 |
| 接口： | 主機接口，SSI，SCI |
| 時鐘速率： | 100MHz |
| 非易失內存： | ROM（576 B） |
| 芯片上RAM： | 24kB |
| 電壓 - 輸入/輸出： | 3.30V |
| 電壓 - 核心： | 3.30V |
| 工作溫度： | -40°C ~ 100°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 196-LBGA |
| 供應商設備封裝： | 196-MAPBGA（15x15） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁
AC Electrical Characteristics
DSP56303 Technical Data, Rev. 11
Freescale Semiconductor
2-3
2.5 AC Electrical Characteristics
The timing waveforms shown in the AC electrical characteristics section are tested with a VIL maximum of 0.3 V
and a VIH minimum of 2.4 V for all pins except EXTAL, which is tested using the input levels shown in Note 6 of
the previous table. AC timing specifications, which are referenced to a device input signal, are measured in
production with respect to the 50 percent point of the respective input signal transition. DSP56303 output levels are
measured with the production test machine VOL and VOH reference levels set at 0.4 V and 2.4 V, respectively.
Note:
Although the minimum value for the frequency of EXTAL is 0 MHz, the device AC test conditions are 15
MHz and rated speed.
2.5.1
Internal Clocks
Notes:
1.
Refers to MODA/IRQA, MODB/IRQB, MODC/IRQC, and MODD/IRQD pins.
2.
Section 4.3 provides a formula to compute the estimated current requirements in Normal mode. In order to obtain these
results, all inputs must be terminated (that is, not allowed to float). Measurements are based on synthetic intensive DSP
benchmarks (see Appendix A). The power consumption numbers in this specification are 90 percent of the measured results
of this benchmark. This reflects typical DSP applications. Typical internal supply current is measured with VCC = 3.3 V at TJ =
100°C.
3.
In order to obtain these results, all inputs must be terminated (that is, not allowed to float).
4.
In order to obtain these results, all inputs that are not disconnected at Stop mode must be terminated (that is, not allowed to
float). PLL and XTAL signals are disabled during Stop state.
5.
Periodically sampled and not 100 percent tested.
6.
VCC = 3.3 V ± 0.3 V; TJ = –40°C to +100 °C, CL = 50 pF
7.
This characteristic does not apply to XTAL and PCAP.
8.
Driving EXTAL to the low VIHX or the high VILX value may cause additional power consumption (DC current). To minimize
power consumption, the minimum VIHX should be no lower than
0.9
× V
CC and the maximum VILX should be no higher than 0.1 × VCC.
Table 2-4.
Internal Clocks, CLKOUT
Characteristics
Symbol
Expression1, 2
Min
Typ
Max
Internal operation frequency and CLKOUT
with PLL enabled
f—
(Ef
× MF)/
(PDF
× DF)
—
Internal operation frequency and CLKOUT
with PLL disabled
f—
Ef/2
—
Internal clock and CLKOUT high period
With PLL disabled
With PLL enabled and MF
≤4
With PLL enabled and MF > 4
TH
—
0.49
× ETC ×
PDF
× DF/MF
0.47
× ETC ×
PDF
× DF/MF
ETC
—
0.51
× ETC ×
PDF
× DF/MF
0.53
× ETC ×
PDF
× DF/MF
Internal clock and CLKOUT low period
With PLL disabled
With PLL enabled and MF
≤4
With PLL enabled and MF > 4
TL
—
0.49
× ETC ×
PDF
× DF/MF
0.47
× ETC ×
PDF
× DF/MF
ETC
—
0.51
× ETC ×
PDF
× DF/MF
0.53
× ETC ×
PDF
× DF/MF
Internal clock and CLKOUT cycle time with
PLL enabled
TC
—ETC × PDF ×
DF/MF
—
Table 2-3.
DC Electrical Characteristics6 (Continued)
Characteristics
Symbol
Min
Typ
Max
Unit
相關PDF資料 |
PDF描述 |
|---|---|
| VI-24D-EU | CONVERTER MOD DC/DC 85V 200W |
| HMC30DRYH-S734 | CONN EDGECARD 60POS DIP .100 SLD |
| TACR475M010XTA | CAP TANT 4.7UF 10V 20% 0805 |
| VI-24B-EU | CONVERTER MOD DC/DC 95V 200W |
| VE-B6Y-CX-S | CONVERTER MOD DC/DC 3.3V 49.5W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSP56303VF100R2 | 功能描述:數字信號處理器和控制器 - DSP, DSC 24 BIT DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56303VL100 | 功能描述:數字信號處理器和控制器 - DSP, DSC 24 BIT DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56303VL100B1 | 功能描述:數字信號處理器和控制器 - DSP, DSC 24 BIT DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT |
| DSP56304GC66 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:24-Bit Digital Signal Processor |
| DSP56304GC80 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:24-Bit Digital Signal Processor |
發布緊急采購，3分鐘左右您將得到回復。