1061
SAM4CP [DATASHEET]
43051E–ATPL–08/14
D
Minor changes.
Signal Description
CLKOUT: “20MHz External Clock Output” changed to “10MHz External Clock Output” in
Section 3. “Signal Description” on page 7
CLKOUT: “20MHz External Clock Output” changed to “10MHz External Clock Output” in
Section 27.5 “Signal Description” on page 423
.
PRIME Power Line Communications (PPLC)
Removed the following registers: “0xFD53, 0xFD54, 0xFD55, 0xFD56, 0xFD5F, 0xFD60,
0xFD61 and 0xFD62”.
“Address: 0xFE62 - 0xFE67” changed to “Address: 0xFEBA (MSB) – 0xFEBB (LSB)” in
Section 27.7.3.1.2 “CRC32 Errors Counter Register ” on page 437
.
Updated
Section 27.7.3.3.3 “BER HARD Average Error Registers” on page 457
“BER HARD
Average Error Registers”.
“Reset: 0x000000” changed to “Reset: 0x00000000” in
Section 27.8.3.3.9 “Accumulated
Header EVM Registers” on page 484
.
“Reset: 0x000000” changed to “Reset: 0x00000000” in
Section 27.8.3.3.10 “Accumulated
Payload EVM Registers” on page 486
.
“Reset: 0x00000000” changed to “Reset: 0x000124F8” in
Section 27.8.3.5.4 “TX Timeout
Registers ” on page 496
.
“Reset: 0x0000” changed to “Reset: 0x1111” in
Section 27.8.3.5.7 “TX Result Register ” on
page 503
.
SAM4CP Electrical Characteristics
Table 45-1, “Absolute Maximum Ratings*”
: removed junction temperature.
Table 45-18, “VDDIO Supply Monitor”
: modified min and max values for parameter ACC.
Table 45-23, “4/8/12 MHz RC Oscillators Characteristics”
: modified conditions for ACC4,
ACC8, ACC12. Modified max values for ACC8 and ACC12.
Figure 45-15
: added note below figure.
Table 45-45, “Typical Current Consumption Values for Backup Mode Configurations C and D”
: modified “Conditions” column to VDDIO.
Table 45-50, “Test Setup 3 Current Consumption”
: modified values for 128-bit Flash Access,
Cache Enabled columns.
Removed section 45.5.14.2 “10-bit ADC with Averager”.
Removed section 45.7.6 “Low-power Mode Wake-up Time”.
SAM4CP Mechanical Characteristics
Table 46-1, “LQFP Package Reference”
and
Table 46-2, “LQFP Package Characteristics”
added.
C
“RTCOUT” changed to “RTCOUT0” in whole document.
“PKCC” changed to “CPKCC” in whole document.
“ADC_SR changed to “ADC_ISR” in
Figure 40-3
and
Figure 40-4
.
SAM4CP Electrical Characteristics
Chapter updated.
B
Changes in the terminology.
A
First Issue.
Doc. Rev.
43051
Comments
Change
Request
Ref.