AMI v" />
參數資料
型號: IDT82V3280PFG8
廠商: IDT, Integrated Device Technology Inc
文件頁數: 112/171頁
文件大?。?/td> 0K
描述: IC PLL WAN SE STRATUM 2 100-TQFP
標準包裝: 750
類型: 時鐘/頻率發生器,多路復用器
PLL:
主要目的: 以太網,SONET/SDH,Stratum
輸入: CMOS,LVDS,PECL
輸出: CMOS,LVDS,PECL
電路數: 1
比率 - 輸入:輸出: 14:9
差分 - 輸入:輸出: 是/是
頻率 - 最大: 622.08MHz
電源電壓: 3 V ~ 3.6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 100-LQFP
供應商設備封裝: 100-TQFP(14x14)
包裝: 帶卷 (TR)
其它名稱: 82V3280PFG8
IDT82V3280
WAN PLL
Functional Description
45
December 9, 2008
3.15
INTERRUPT SUMMARY
The interrupt sources of the device are as follows:
AMI violation
LOS
T4 DPLL locking status change
Input clocks for T0 path validity change
T0 selected input clock fail
Input clocks for T4 path change to be no qualified input clock
available
T0 DPLL operating mode switch
External sync alarm
All of the above interrupt events are indicated by the corresponding
interrupt status bit. If the corresponding interrupt enable bit is set, any of
the interrupts can be reported by the INT_REQ pin. The output charac-
teristics on the INT_REQ pin are determined by the HZ_EN bit and the
INT_POL bit.
Interrupt events are cleared by writing a ‘1’ to the corresponding
interrupt status bit. The INT_REQ pin will be inactive only when all the
pending enabled interrupts are cleared.
In addition, the interrupt of T0 selected input clock fail can be
reported by the TDO pin, as determined by the LOS_FLAG_TO_TDO
bit.
3.16
T0 AND T4 SUMMARY
The main features supported by the T0 path are as follows:
Phase lock alarm;
Forced or Automatic input clock selection/switch;
3 primary and 3 secondary, temporary DPLL operating modes,
switched automatically or under external control;
Automatic switch between starting, acquisition and locked band-
widths/damping factors;
Programmable DPLL bandwidths from 0.5 mHz to 560 Hz in 19
steps;
Programmable damping factors: 1.2, 2.5, 5, 10 and 20;
Fast loss, coarse phase loss, fine phase loss and hard limit
exceeding monitoring;
Output phase and frequency offset limited;
Automatic Instantaneous, Automatic Slow Averaged, Automatic
Fast Averaged or Manual holdover frequency offset acquiring;
PBO to minimize output phase transients;
Programmable output phase offset;
Low jitter multiple clock outputs with programmable polarity;
Low jitter 2 kHz and 8 kHz frame sync signal outputs with pro-
grammable pulse width and polarity;
Master / Slave application to enable system protection against
single device failure.
The main features supported by the T4 path are as follows:
Forced or Automatic input clock selection/switch;
Locking to T0 DPLL output;
3 DPLL operating modes, switched automatically or under exter-
nal control;
Programmable DPLL bandwidth: 18 Hz, 35 Hz, 70 Hz and 560
Hz;
Programmable damping factor: 1.2, 2.5, 5, 10 and 20;
Fast loss, coarse phase loss, fine phase loss and hard limit
exceeding monitoring;
Output phase and frequency offset limited;
Automatic Instantaneous holdover frequency offset;
Low jitter multiple clock outputs with programmable polarity.
Table 30: Related Bit / Register in Chapter 3.15
Bit
Register
Address (Hex)
HZ_EN
INTERRUPT_CNFG
0C
INT_POL
LOS_FLAG_TO_TDO
MON_SW_PBO_CNFG
0B
相關PDF資料
PDF描述
MS3127E20-41P CONN RCPT 41POS BOX MNT W/PINS
IDT82V3280DQG8 IC PLL WAN SE STRATUM 2 100-TQFP
VE-B2X-MW-F1 CONVERTER MOD DC/DC 5.2V 100W
VE-B2R-MW-F4 CONVERTER MOD DC/DC 7.5V 100W
VE-B2P-MW-F2 CONVERTER MOD DC/DC 13.8V 100W
相關代理商/技術參數
參數描述
IDT82V3280PFGBLANK 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:WAN PLL
IDT82V3285 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:WAN PLL
IDT82V3285AEQG 功能描述:IC PLL WAN SE STRATUM 100TQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
IDT82V3285AEQG8 制造商:Integrated Device Technology Inc 功能描述:IC PLL WAN SE STRATUM 100TQFP
IDT82V3285DQG 功能描述:IC PLL WAN STRATUM 100-TQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT