參數資料
型號: IDT82V3280PFG8
廠商: IDT, Integrated Device Technology Inc
文件頁數: 127/171頁
文件大?。?/td> 0K
描述: IC PLL WAN SE STRATUM 2 100-TQFP
標準包裝: 750
類型: 時鐘/頻率發生器,多路復用器
PLL:
主要目的: 以太網,SONET/SDH,Stratum
輸入: CMOS,LVDS,PECL
輸出: CMOS,LVDS,PECL
電路數: 1
比率 - 輸入:輸出: 14:9
差分 - 輸入:輸出: 是/是
頻率 - 最大: 622.08MHz
電源電壓: 3 V ~ 3.6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 100-LQFP
供應商設備封裝: 100-TQFP(14x14)
包裝: 帶卷 (TR)
其它名稱: 82V3280PFG8
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁當前第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁
IDT82V3280
WAN PLL
Programming Information
59
December 9, 2008
7
PROGRAMMING INFORMATION
After reset, all the registers are set to their default values. The regis-
ters are read or written via the microprocessor interface.
Before
any
write
operation,
the
value
in
register
PROTECTION_CNFG is recommended to be confirmed to make sure
whether the write operation is enabled. The device provides 3 register
protection modes:
Protected mode: no other registers can be written except register
PROTECTION_CNFG itself;
Fully Unprotected mode: all the writable registers can be written;
Single Unprotected mode: one more register can be written
besides register PROTECTION_CNFG. After write operation
(not including writing a ‘1’ to clear a bit to ‘0’), the device auto-
matically switches to Protected mode.
Writing ‘0’ to the registers will take no effect if the registers are
cleared by writing ‘1’.
T0 and T4 paths share some registers, whose addresses are 26H ~
2CH, 4EH, 4FH, 5AH, 5BH, 62H ~ 64H, 68H and 69H. The names of
shared registers are marked with a *. Before register read/write opera-
tion, register T4_T0_REG_SEL_CNFG is recommended to be con-
firmed to make sure whether the register operation is available for T0 or
T4 path.
The access of the Multi-word Registers is different from that of the
Single-word Registers. Take the registers (04H, 05H and 06H) for an
example, the write operation for the Multi-word Registers follows a fixed
sequence. The register (04H) is configured first and the register (06H) is
configured last. The three registers are configured continuously and
should not be interrupted by any operation. The crystal calibration con-
figuration will take effect after all the three registers are configured. Dur-
ing read operation, the register (04H) is read first and the register (06H)
is read last. The crystal calibration reading should be continuous and not
be interrupted by any operation.
Certain bit locations within the device register map are designated as
Reserved. To ensure proper and predictable operation, bits designated
as Reserved should not be written by the users. In addition, their value
should be masked out from any testing or error detection methods that
are implemented.
7.1
REGISTER MAP
Table 42 is the map of all the registers, sorted in an ascending order
of their addresses.
Table 42: Register List and Map
Address
(Hex)
Register Name
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Reference
Page
Global Control Registers
00
ID[7:0] - Device ID 1
ID[7:0]
01
ID[15:8] - Device ID 2
ID[15:8]
02
MPU_PIN_STS - MPU_MODE[2:0]
Pins Status
-
MPU_PIN_STS[2:0]
04
NOMINAL_FREQ_VALUE[7:0]
05
NOMINAL_FREQ_VALUE[15:8]
06
NOMINAL_FREQ_VALUE[23:16]
07
---
T4_T0_SE
L
---
-
08
MULTI_FACTOR[1:0]
TIME_OUT_VALUE[5:0]
09
AUTO_EX
T_SYNC_
EN
EXT_SYN
C_EN
PH_ALAR
M_TIMEO
UT
SYNC_FREQ[1:0]
IN_SONET
_SDH
MASTER_
SLAVE
REVERTIV
E_MODE
0A
---
--
OSC_EDG
E
OUT7_PE
CL_LVDS
OUT6_PE
CL_LVDS
相關PDF資料
PDF描述
MS3127E20-41P CONN RCPT 41POS BOX MNT W/PINS
IDT82V3280DQG8 IC PLL WAN SE STRATUM 2 100-TQFP
VE-B2X-MW-F1 CONVERTER MOD DC/DC 5.2V 100W
VE-B2R-MW-F4 CONVERTER MOD DC/DC 7.5V 100W
VE-B2P-MW-F2 CONVERTER MOD DC/DC 13.8V 100W
相關代理商/技術參數
參數描述
IDT82V3280PFGBLANK 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:WAN PLL
IDT82V3285 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:WAN PLL
IDT82V3285AEQG 功能描述:IC PLL WAN SE STRATUM 100TQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
IDT82V3285AEQG8 制造商:Integrated Device Technology Inc 功能描述:IC PLL WAN SE STRATUM 100TQFP
IDT82V3285DQG 功能描述:IC PLL WAN STRATUM 100-TQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT