參數資料
型號: KSZ8851-16MLLJ
廠商: Micrel Inc
文件頁數: 17/90頁
文件大?。?/td> 0K
描述: IC CTLR MAC 1PORT NON-PCI 48LQFP
標準包裝: 250
控制器類型: 以太網控制器,MAC/PHY
接口: 總線
電源電壓: 1.8V,2.5V,3.3V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 48-LQFP
供應商設備封裝: 48-LQFP(7x7)
包裝: 托盤
其它名稱: 576-3629
KSZ8851-16MLLJ-ND
Micrel, Inc.
KSZ8851-16MLLJ
March 2010
24
M9999-030210-1.0
The KSZ8851-16MLLJ issues a flow control frame (Xoff, or transmitter off), containing the maximum pause time defined in
IEEE standard 802.3x. Once the resource is freed up, the KSZ8851-16MLLJ sends out the another flow control frame
(Xon, or transmitter on) with zero pause time to turn off the flow control (turn on transmission to the port). A hysteresis
feature is provided to prevent the flow control mechanism from being constantly activated and deactivated.
Half-Duplex Backpressure
A half-duplex backpressure option (non-IEEE 802.3 standards) is also provided. The activation and deactivation
conditions are the same as in full-duplex mode. If backpressure is required, the KSZ8851-16MLLJ sends preambles to
defer the other stations' transmission (carrier sense deference).
To avoid jabber and excessive deference (as defined in the 802.3 standard), after a certain time, the KSZ8851-16MLLJ
discontinues the carrier sense and then raises it again quickly. This short silent time (no carrier sense) prevents other
stations from sending out packets thus keeping other stations in a carrier sense deferred state. If the port has packets to
send during a backpressure situation, the carrier sense type backpressure is interrupted and those packets are
transmitted instead. If there are no additional packets to send, carrier sense type backpressure is reactivated again until
chip resources free up. If a collision occurs, the binary exponential back-off algorithm is skipped and carrier sense is
generated immediately, thus reducing the chance of further collision and carrier sense is maintained to prevent packet
reception.
Address Filtering Function
The KSZ8851-16MLLJ supports 11 different address filtering schemes as shown in the following Table 3. The Ethernet
destination address (DA) field inside the packet is the first 6-byte field which uses to compare with either the host MAC
address registers (0x10 – 0x15) or the MAC address hash table registers (0xA0 – 0xA7) for address filtering operation.
The first bit (bit 40) of the destination address (DA) in the Ethernet packet decides whether this is a physical address if bit
40 is “0” or a multicast address if bit 40 is “1”.
相關PDF資料
PDF描述
KSZ8851-32MQLI IC CTLR MAC/PHY NON PCI 128PQFP
KSZ8851-32MQL IC CTLR MAC/PHY NON PCI 128PQFP
KSZ8851SNLI TR IC ETHERNET CTLR 1PORT PCI 32MLF
KSZ8862-16MQL IC SWITCH 10/100 16BIT 128-PQFP
KSZ8862-32MQL IC ETHERNET SW 2PORT BUS 128PQFP
相關代理商/技術參數
參數描述
KSZ8851-16MLLJ_10 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:Single-Port Ethernet MAC Controller with 8-Bit or 16-Bit Non-PCI Interface
KSZ8851-16MLLU 功能描述:以太網 IC Single-Port Ethernet Controller (Automotive Grade) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
KSZ8851-16MLLU TR 功能描述:以太網 IC Single-Port Ethernet Controller (Automotive Grade) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
KSZ8851-16MQL 功能描述:以太網 IC Single Ethernet Port + Generic (16-bit) Bus Interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
KSZ8851-16MQL-EVAL 功能描述:以太網開發工具 Single Ethernet Port + Generic (16-bit) Bus Interface(Lead Free) Eval Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: