參數資料
型號： LAN83C185-JT
廠商： STANDARD MICROSYSTEMS CORP
元件分類： 網絡接口
英文描述： HIGH PERFORMANCE SINGLE CHIP LOW POWER 10/100 ETHERNET PHYSICAL LAYER TRANSCEIVER
中文描述： DATACOM, ETHERNET TRANSCEIVER, PQFP64
封裝： 10 X 10 MM, 1.40 MM HEIGHT, ROHS COMPLIANT, TQFP-64
文件頁數： 43/61頁
文件大?。?/td> 459K
代理商： LAN83C185-JT
High Performance Single Chip Low Power 10/100 Ethernet Physical Layer Transceiver (PHY)
Datasheet
SMSC LAN83C185
43
Rev. 0.8 (11-16-04)
DATASHEET
5.3
Management Interrupt
The Management interface supports an interrupt capability that is not a part of the IEEE 802.3
specification. It generates an active low interrupt signal on the nINT output whenever certain events
are detected. Reading the Interrupt Source register (Register 29) shows the source of the interrupt,
and clears the interrupt output signal. The Interrupt Mask register (Register 30) enables for each
source to set (LOW) the nINT, by asserting the corresponding mask bit. The Mask bit does not mask
the source bit in register 29. At reset, all bits are masked (negated). The nINT is an asynchronous
output.
5.4
Miscellaneous Functions
5.4.1
Carrier Sense
The carrier sense is output on CRS. CRS is a signal defined by the MII specification in the IEEE 802.3u
standard. The PHY asserts CRS based only on receive activity whenever the PHY is either in repeater
mode or full-duplex mode. Otherwise the PHY asserts CRS based on either transmit or receive activity.
The carrier sense logic uses the encoded, unscrambled data to determine carrier activity status. It
activates carrier sense with the detection of 2 non-contiguous zeros within any 10 bit span. Carrier
sense terminates if a span of 10 consecutive ones is detected before a /J/K/ Start-of Stream Delimiter
pair. If an SSD pair is detected, carrier sense is asserted until either /T/R/ End–of-Stream Delimiter
pair or a pair of IDLE symbols is detected. Carrier is negated after the /T/ symbol or the first IDLE. If
/T/ is not followed by /R/, then carrier is maintained. Carrier is treated similarly for IDLE followed by
some non-IDLE symbol.
31.4:2
Speed Indication
HCDSPEED value:
[001]=10Mbps Half-duplex
[101]=10Mbps Full-duplex
[010]=100Base-TX Half-duplex
[110]=100Base-TX Full-duplex
RO
000
31.1
Reserved
Write as 0; ignore on Read
RW
0
31.0
Scramble Disable
0 = enable data scrambling
1 = disable data scrambling,
RW
0
INTERRUPT SOURCE
SOURCE/MASK REG BIT #
ENERGYON activated
7
Auto-Negotiate Complete
6
Remote Fault Detected
5
Link Status negated (not asserted)
4
Auto-Negotiation LP Acknowledge
3
Parallel Detection Fault
2
Auto-Negotiation Page Received
1
Table 5.52 Register 31 - PHY Special Control/Status (continued)
ADDRESS
NAME
DESCRIPTION
MODE
DEFAULT
相關PDF資料
PDF描述
LAN8700 【15kV ESD Protected MII/RMII Fast-Ethernet PHY with HP Auto-MDIX and SMSC flexPWR TM in a Small Footprint
LAN9115 HIGHLY EFFICIENT SINGLE - CHIP 10/100 NON PCI ETHERNET CONTROLLER
LAN9115-MD HIGHLY EFFICIENT SINGLE - CHIP 10/100 NON PCI ETHERNET CONTROLLER
LAN9115-MT HIGHLY EFFICIENT SINGLE - CHIP 10/100 NON PCI ETHERNET CONTROLLER
LAN9116 Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller
相關代理商/技術參數
參數描述
LAN83C795QFP WAF 制造商:SMSC 功能描述:
LAN8700 制造商:SMSC 制造商全稱:SMSC 功能描述:【15kV ESD Protected MII/RMII Fast-Ethernet PHY with HP Auto-MDIX and SMSC flexPWR TM in a Small Footprint
LAN8700AEZG 制造商:SMSC 功能描述:
LAN8700-AEZG 功能描述:以太網 IC HIPERFRM ETHRNT PHY RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
LAN8700C-AEZG 功能描述:以太網 IC IC w/HP Auto-MDIX Embedded Ethernet RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*