參數資料
型號: MB86960APF-G
元件分類: 微控制器/微處理器
英文描述: 2 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP100
封裝: PLASTIC, QFP-100
文件頁數: 2/66頁
文件大?。?/td> 376K
代理商: MB86960APF-G
MB86960
10
CONTROLLER
ENCODER/
DECODER
NICE
CASE 00: NORMAL NICE MODE
CONTROLLER
ENCODER/
DECODER
NICE
CASE 01: NICE + MONITOR
CONTROLLER
ENCODER/
DECODER
NICE
CASE 10: ENCODER/DECODER BYPASS
CONTROLLER
ENCODER/
DECODER
NICE
CASE 01: NICE + MONITOR
CONTROLLER TEST
EED TEST
RXD, RXC
CRS, TCK, COL
TEN, TXD, LBC
Figure 2. Encoder/Decoder Modes
CRYSTAL OSCILLATOR
The ISO/ANSI/IEEE 8802–3 international LAN stan-
dard specifies a bit clock rate of 10 Mbit/sec. This is
obtained from a 20 MHz clock generated by the on-chip
oscillator, which operates from an external crystal
connected between pins X1 and X2 on the NICE chip.
Crystal capacitance as specified by the manufacturer
should be connected from X1 and X2 to ground,
considering any stray capacitance which can vary the
crystal’s frequency. See Figure 3 for typical values. A
crystal with the following specifications is recom-
mended: quartz (AT-cut; 20 MHz; frequency/accuracy of
±
50 ppm at 25_C to 70_C; parallel resonant with 20 pF
load in a fundamental mode. Possible vendors include:
Ecliptek Corp. (Costa Mesa, CA), p/n ECSM 20.000M;
and M-tron Industries, Inc. (Yankton, SD), p/n MP-1 &
MP-2, with 20MHz, 50ppm over 0
_C to 70_C, and 18 pF
fundamental load.
NICE
X1
X2
20 MHz
20pF
Figure 3. Crystal Connection
The clock also serves as a reference for an internal phase
locked loop which is used for clock recovery in the
decoder section. Internal clocks are shut down when
DLCR7 bit 5, PWRDN, is invoked for Power Down
Mode.
SRAM CONFIGURATIONS
Eight different configurations of SRAM for the packet
buffer are possible as illustrated in Figure 4. First, the
width of the SRAM data path can be 8 or 16 bits, selected
by programming the Buffer Byte/Buffer Word (BB/BW)
bit, bit 4 of DLCR6. If this bit is set to 1, byte-wide data is
selected; if set to 0, the width is word-wide (16 bits). The
SB/SW Bit, DLCR6 bit 5, selects the system bus width,
while the BB/BW Bit, DLCR6 bit 4 selects the SRAM
buffer width. Secondly, the depth of the SRAM is
programmed by setting Buffer Size 1 and 0 (BS1 and
BS0), bits 1 and 0 in DLCR6. Depth selections are 8, 16,
32 or 64 kilobytes.
相關PDF資料
PDF描述
MB86965A 2 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP16
MB88151APNF-G-500-JNE1 OTHER CLOCK GENERATOR, PDSO8
MB88151APNF-G-401-JNEFE1 OTHER CLOCK GENERATOR, PDSO8
MB88151APNF-G-801-JNERE1 OTHER CLOCK GENERATOR, PDSO8
MB88151APNF-G-400-JNERE1 OTHER CLOCK GENERATOR, PDSO8
相關代理商/技術參數
參數描述
MB86961A 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:UNIVERSAL INTERFACE FOR 10BASET
MB86961APD-G 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:UNIVERSAL INTERFACE FOR 10BASET
MB86961APF-G 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:UNIVERSAL INTERFACE FOR 10BASET
MB86965 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:EtherCoupler ETHERNET CONTROLLER WITH 10BASE?T TRANSCEIVER
MB86965B 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:EtherCoupler ETHERNET CONTROLLER WITH 10BASE?T TRANSCEIVER