參數資料
型號： MC68HC05BD3P
廠商： FREESCALE SEMICONDUCTOR INC
元件分類： 微控制器/微處理器
英文描述： 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP40
封裝： PLASTIC, DIP-40
文件頁數： 44/112頁
文件大?。?/td> 864K
代理商： MC68HC05BD3P
MC68HC05BD3
MOTOROLA
4-5
RESETS AND INTERRUPTS
4
4.2.2
Maskable Hardware Interrupts
If the interrupt mask bit (I-bit) of the CCR is set, all maskable interrupts (internal and external) are
masked. Clearing the I-bit allows interrupt processing to occur.
Note:
The internal interrupt latch is cleared in the rst part of the interrupt service routine;
therefore, one external interrupt pulse could be latched and serviced as soon as the
I-bit is cleared.
4.2.2.1
External Interrupt (IRQ)
The external interrupt IRQ can be software congured for “negative-edge” or “negative-edge and
level” sensitive triggering by the IRQN bit in the Multi-Function TImer Control and Status
register.
IRQN
1 (set)
–
Negative edge triggering for IRQ only
0 (clear) –
Level and negative edge triggering for IRQ
When the signal of the external interrupt pin, IRQ, satises the condition selected, an external
interrupt occurs. The actual processor interrupt is generated only if the interrupt mask bit of the
condition code register is also cleared. When the interrupt is recognized, the current state of the
processor is pushed onto the stack and the interrupt mask bit in the condition code register is set.
This masks further interrupts until the present one is serviced. The service routine address is
specied by the contents $3FFA & $3FFB.
The interrupt logic recognizes negative edge transitions and pulses (special case of negative
edges) on the external interrupt line. Figure 4-3 shows both a block diagram and timing for the
interrupt line (IRQ) to the processor. The rst method is used if pulses on the interrupt line are
spaced far enough apart to be serviced. The minimum time between pulses is equal to the number
of cycles required to execute the interrupt service routine plus 21 cycles. Once a pulse occurs, the
next pulse should not occur until the MCU software has exited the routine (an RTI occurs). The
second conguration shows several interrupt lines wired-OR to perform the interrupt at the
processor. Thus, if the interrupt lines remain low after servicing one interrupt, the next interrupt is
recognized.
Note:
The internal interrupt latch is cleared in the rst part of the service routine; therefore,
one (and only one) external interrupt pulse could be latched during tILIL and serviced
as soon as the I bit is cleared.
Address
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
State
on reset
MFT Control and Status
$0008
TOF
RTIF
TOFIE
RTIE
IRQN
RT1
RT0
0000 0-11
TPG
35
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相關PDF資料
PDF描述
MC68HC05C9AFNR2 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44
MC68HC05C9AFNR2 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44
MC68HC05C9ACFNR2 8-BIT, MROM, 4.2 MHz, MICROCONTROLLER, PQCC44
MC68HC05C9AMB 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP42
MC68HC05C9AMFN 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44
相關代理商/技術參數
參數描述
MC68HC05BD5 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:High-density complementary metal oxide semiconductor (HCMOS) microcontroller unit
MC68HC05C0CP 制造商:Motorola Inc 功能描述:
MC68HC05C12 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS
MC68HC05C12B 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS
MC68HC05C12CP 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*