108
ATmega64A [DATASHEET]
8160D–AVR–02/2013
event will also set the Compare Match Flag (OCFnA/B/C) which can be used to generate an Output Compare inter-
rupt request.
The Input Capture Register can capture the Timer/Counter value at a given external (edge triggered) event on
The Input Capture unit includes a digital filtering unit (Noise Canceler) for reducing the chance of capturing noise
spikes.
The TOP value, or maximum Timer/Counter value, can in some modes of operation be defined by either the
OCRnA Register, the ICRn Register, or by a set of fixed values. When using OCRnA as TOP value in a PWM
mode, the OCRnA Register can not be used for generating a PWM output. However, the TOP value will in this
case be double buffered allowing the TOP value to be changed in run time. If a fixed TOP value is required, the
ICRn Register can be used as an alternative, freeing the OCRnA to be used as PWM output.
16.2.2
Definitions
The following definitions are used extensively throughout this section:
16.2.3
Compatibility
The 16-bit Timer/Counter has been updated and improved from previous versions of the 16-bit AVR Timer/Coun-
ter. This 16-bit Timer/Counter is fully compatible with the earlier version regarding:
All 16-bit Timer/Counter related I/O Register address locations, including Timer Interrupt Registers.
Bit locations inside all 16-bit Timer/Counter registers, including Timer Interrupt Registers.
Interrupt Vectors.
The following control bits have changed name, but have same functionality and register location:
PWMn0 is changed to WGMn0.
PWMn1 is changed to WGMn1.
CTCn is changed to WGMn2.
The following registers are added to the 16-bit Timer/Counter:
Timer/Counter Control Register C (TCCRnC).
Output Compare Register C, OCRnCH and OCRnCL, combined OCRnC.
The following bits are added to the 16-bit Timer/Counter control registers:
COM1C1:0 are added to TCCR1A.
FOCnA, FOCnB, and FOCnC are added in the new TCCRnC Register.
WGMn3 is added to TCCRnB.
Interrupt flag and mask bits for Output Compare unit C are added.
The 16-bit Timer/Counter has improvements that will affect the compatibility in some special cases.
Table 16-1.
Definitions
BOTTOM
The counter reaches the BOTTOM when it becomes 0x0000.
MAX
The counter reaches its MAXimum when it becomes 0xFFFF (decimal 65535).
TOP
The counter reaches the TOP when it becomes equal to the highest value in the
count sequence. The TOP value can be assigned to be one of the fixed values:
0x00FF, 0x01FF, or 0x03FF, or to the value stored in the OCRnA or ICRn Reg-
ister. The assignment is dependent of the mode of operation.