- 您現在的位置：買賣IC網 > PDF目錄224604 > NT5SV8M16FT-75BI (NANYA TECHNOLOGY CORP) 8M X 16 SYNCHRONOUS DRAM, 5.4 ns, PDSO54 PDF資料下載
參數資料
| 型號： | NT5SV8M16FT-75BI |
| 廠商： | NANYA TECHNOLOGY CORP |
| 元件分類： | DRAM |
| 英文描述： | 8M X 16 SYNCHRONOUS DRAM, 5.4 ns, PDSO54 |
| 封裝： | 0.400 MM, PLASTIC, TSSOP2-54 |
| 文件頁數： | 2/65頁 |
| 文件大?。?/td> | 739K |
| 代理商： | NT5SV8M16FT-75BI |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁
NT5SV8M16FS / NT5SV8M16FT
128Mb Synchronous DRAM
REV 1.4
08/2009
10
NANYA TECHNOLOGY CORPORATION
NANYA reserves the right to change products and specifications without notice.
Read and Write Access Modes
After a bank has been activated, a read or write cycle can be executed. This is accomplished by setting RAS high and CAS low
at the clock’s rising edge after the necessary RAS to CAS delay (tRCD). WE must also be defined at this time to determine
whether the access cycle is a read operation (WE high), or a write operation (WE low). The address inputs determine the start-
ing column address.
The SDRAM provides a wide variety of fast access modes. A single Read or Write Command will initiate a serial read or write
operation on successive clock cycles up to 133 MHz for PC133 or upto 166MHz for PC166 devices. The number of serial data
bits for each access is equal to the burst length, which is programmed into the Mode Register.
Similar to Page Mode of conventional DRAMs, a read or write cycle can not begin until the sense amplifiers latch the selected
row address information. The refresh period (tREF) is what limits the number of random column accesses to an activated bank.
A new burst access can be done even before the previous burst ends. The ability to interrupt a burst operation at every clock
cycle is supported; this is referred to as the 1-N rule. When the previous burst is interrupted by another Read or Write Com-
mand, the remaining addresses are overridden by the new address.
Precharging an active bank after each read or write operation is not necessary providing the same row is to be accessed again.
To perform a read or write cycle to a different row within an activated bank, the bank must be precharged and a new Bank Acti-
vate command must be issued. When more than one bank is activated, interleaved (ping pong) bank Read or Write operations
are possible. By using the programmed burst length and alternating the access and precharge operations between multiple
banks, fast and seamless data access operation among many different pages can be realized. When multiple banks are acti-
vated, column to column interleave operation can be done between different pages. Finally, Read or Write Commands can be
issued to the same bank or between active banks on every clock cycle.
相關PDF資料 |
PDF描述 |
|---|---|
| NT5TU64M16DG-3C | 64M X 16 DDR DRAM, 0.45 ns, PBGA84 |
| NTA2425E | |
| NTA2425F | |
| NTA2410-10 | |
| NTD2410F | |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NT5SV8M16HS-6K | 制造商:Nanya Technology Corporation 功能描述:DRAM |
| NT5SV8M8DT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:64Mb Synchronous DRAM |
| NT5SV8M8DT-6K | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:64Mb Synchronous DRAM |
| NT5SV8M8DT-7 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:64Mb Synchronous DRAM |
| NT5SV8M8DT-7K | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:64Mb Synchronous DRAM |
發布緊急采購，3分鐘左右您將得到回復。