參數資料
型號: POE-VOICE-RD
廠商: Silicon Laboratories Inc
文件頁數: 72/108頁
文件大?。?/td> 0K
描述: KIT REF DESIGN PWR OVER ETHERNET
標準包裝: 1
主要目的: 參考設計,以太網供電(POE),語音傳輸
嵌入式: 是,MCU,8 位
已用 IC / 零件: C8051F340,CP2201,Si3400
主要屬性: 嵌入式以太網,以太網供電,8 kHz 語音采樣系統
次要屬性: 圖形用戶界面
已供物品: 板,線纜,電源,軟件
產品目錄頁面: 626 (CN2011-ZH PDF)
相關產品: 336-1385-ND - IC POWER OVER ETHERNET 20QFN
336-1322-ND - IC POWER OVER ETHERNET 20QFN
336-1313-ND - IC ETH CTRLR SNGL-CHIP 28QFN
336-1298-ND - IC 8051 MCU FLASH 64K 48TQFP
其它名稱: 336-1326
CP2200/1
66
Rev. 1.0
12.6. Advanced Receive Buffer Operation
Receive buffer operation is automatically handled by hardware and does not require any assistance from the host
processor. Note: The information in this section is provided for reference purposes only and will typically
not be used except when debugging a problem and additional control over the receive buffer is required.
Figure 18 shows a detailed block diagram of the receive buffer. As packets arrive and pass through the receive
filter, they are added to the circular receive buffer at the address pointed to by the tail pointer. The FIFO tail pointer
is incremented after each byte is received. As soon as a new packet arrives, the receive buffer controller searches
for an unused TLB slot to store data about the received packet. If an unused TLB slot is found, it is claimed and
assigned to the packet currently being received by setting the slot’s valid bit to ‘1’. A Packet Received interrupt will
be generated after the entire packet is copied to the buffer. If all 8 slots are full (valid bits for all slots are set to ‘1’),
then the packet will be dropped and a Receive FIFO Full interrupt will be generated.
Each TLB slot holds information about its assigned packet such as starting address in the buffer, length, and
information about the packet such as the type (broadcast, multicast, unicast) and any errors that occurred during
reception (CRC error, incomplete packet, etc.). The receive buffer controller rotates through the TLB slots in a
circular fashion. For debugging purposes, the host processor may access any TLB slot using the TLB registers
listed in Table 17.
Figure 18. Receive Buffer Block Diagram
The oldest packet received starts at the address pointed to by the FIFO head pointer. This packet (packet #1 in
Figure 18) will be referred to as the current packet. The FIFO head pointer is used by the AutoRead interface to
read data from the current packet. As data is read using the AutoRead interface, the FIFO head pointer is
incremented until the entire packet is read out. Once the packet is read out, the host processor must clear the valid
bit of the packet by writing a ‘1’ to RXCLRV (RXCN.2). If the host processor chooses not to read the entire packet,
the valid bit should be cleared (and unread data skipped) by writing a ‘1’ to RXSKIP (RXCN.1).
A copy of the TLB slot associated with the current packet is always available by reading the CTLB registers listed in
Table 16. The same information can be obtained by reading CPTLB to determine the current TLB slot, then directly
accessing the slot using the registers in Table 17.
0
1
0
FIFO Head Pointer
FIFO Tail Pointer
Packet #1
Packet #2
Packet #3
4 KB
Receive
Buffer
TLB0
TLB1
TLB2
TLB3
TLB4
TLB5
TLB6
TLB7
Translation Look-aside Buffer
(8-entry circular or random access)
Current packet address,
length, and information.
Valid Bit
CPINFO/
CPLEN/
CPADDR
Copy of
Current TLB
CPTLB
Current TLB
Entry Number
(e.g. 0 for TLB0)
RXAUTORD
Autoread interface automatically manages read pointers. TLB Entries are typically not
accessed by the host.
相關PDF資料
PDF描述
CW252016-R10G INDUCTOR 100NH 1008 SMD
GBA31DCBI CONN EDGECARD 62POS R/A .125 SLD
EBC18DRTH-S93 CONN EDGECARD 36POS DIP .100 SLD
ABM10DSUH CONN EDGECARD 20POS .156 DIP SLD
UPZ2D331MHD6 CAP ALUM 330UF 200V 20% RADIAL
相關代理商/技術參數
參數描述
POF 1200AE 制造商:Bosch Sensortec 功能描述:ROUTER 1200W
POF 1400ACE 制造商:Bosch Sensortec 功能描述:ROUTER, 1400W
POF-12664 功能描述:PUSH-ON FEET BLK .62 X .20" RoHS:是 類別:硬件,緊固件,配件 >> 緩沖器,支腳,焊盤,握把 系列:POF MSDS 材料安全數據表:MB1102,1200, SJ5300,5400,5600,5900,6000 MSDS 產品目錄繪圖:Resilient Rollstock 標準包裝:1 系列:SJ-5900 形狀:矩形,扁平 - 可定制 顏色:黑 尺寸:卷 - 1' L x 9.000" W x 0.250" H(304.80mm x 228.60mm x 6.35mm)1/4" H 尺寸 - 可視:卷 - 1' L x 9.000" W x 0.250" H(304.80mm x 228.60mm x 6.35mm)1/4" H 材質:聚氨脂泡沫 安裝類型:膠合劑 - 丙烯酸 其它名稱:SJ5904-1FT
POF-12664-10PK 制造商:Richco 功能描述:Push On Feet; PVC (Flexible); Black; 15.7 mm; 8.6 mm; 1.3 mm; 7 mm
POF-40022 功能描述:PUSH-ON FEET BLK .31 X .06" RoHS:是 類別:硬件,緊固件,配件 >> 緩沖器,支腳,焊盤,握把 系列:POF MSDS 材料安全數據表:MB1102,1200, SJ5300,5400,5600,5900,6000 MSDS 產品目錄繪圖:Resilient Rollstock 標準包裝:1 系列:SJ-5900 形狀:矩形,扁平 - 可定制 顏色:黑 尺寸:卷 - 1' L x 9.000" W x 0.250" H(304.80mm x 228.60mm x 6.35mm)1/4" H 尺寸 - 可視:卷 - 1' L x 9.000" W x 0.250" H(304.80mm x 228.60mm x 6.35mm)1/4" H 材質:聚氨脂泡沫 安裝類型:膠合劑 - 丙烯酸 其它名稱:SJ5904-1FT