參數資料
型號： TLE6266G
廠商： INFINEON TECHNOLOGIES AG
元件分類： 模擬信號調理
英文描述： SPECIALTY ANALOG CIRCUIT, PDSO28
封裝： 18 MM, PLASTIC, SOP-28
文件頁數： 10/50頁
文件大?。?/td> 1020K
代理商： TLE6266G
Datasheet TLE 6266 G
Version 2.21
18
July 29th, 2005
SPI CLK Monitoring during Cyclic Wake Mode
The TLE 6266 offers a feature to monitor the SPI clock signal (CLK pin) during the cyclic
wake mode. If there are edges on the CLK signal, the IC performs a reset and the RO
pin is set to LOW for t= tWDR (after tWDR a long open window is started and RO is HIGH
again). This feature is activated if the CSN pin is set to HIGH.
6.8
Oscillator
The TLE 6266 has an internal oscillator with +/-15% accuracy. The typ. frequency of the
oscillator is 125kHz. After an internal 64-times frequency divider, this gives an typ. cycle
time tcyc= 0.512ms. The frequency of the oscillator can be measured within the normal,
the Vbat stand-by and the RxD-only mode. This is a timebase test (see Chapter 6.15),
activated via SPI input bit 3 and 4. During this test, the HS3-switch will be activated
cyclically.
6.9
Window Watchdog and Reset
When the output voltage VCC exceeds the reset threshold voltage VRT the reset output
RO is switched HIGH after a delay time tRD. This is necessary for a defined start of the
microcontroller when the application is switched on. As soon as an under-voltage
condition of the output voltage (VCC < VRT) appears, the reset output RO is switched
LOW again. The LOW signal is guaranteed down to an output voltage VCC ≥ 1V. Please
refer to Figure 17, reset timing diagram.
In the cyclic wake HS OFF mode, the watchdog circuit is automatically disabled.Both,
the undervoltage reset and the watchdog reset set all SPI input bits LOW.
Long Open Window
After the delayed reset (LOW to HIGH transition of RO) the window watchdog circuit is
started by opening a long open window. The long open window allows the
microcontroller to run his set-up and to trigger the watchdog via the SPI afterwards.
Within the long open window period a watchdog trigger is alternating detected as a
“rising” or “falling edge” by sampling a HIGH on the SPI input bit 0. The trigger is
accepted when the CSN input becomes HIGH after the transmission of the SPI word.
After every reset condition (watchdog reset, undervoltage reset) as well as a transition
from every mode into the cyclic wake HS ON mode, the watchdog starts the long open
window and the default value of the SPI input bit 0 is LOW.
Closed/Open Window
A correct watchdog trigger immediately results in starting the window watchdog by
opening the closed window followed by the open window (see Figure 18). From now on
the microcontroller has to service the watchdog trigger by inverting the SPI input bit 0
alternating. The “negative” or “positive” edge has to meet the open window time. A
correct watchdog service immediately results in starting the next closed window. Please
refer to Figure 19, watchdog timing diagram.
相關PDF資料
PDF描述
TLE6280GP BRUSHLESS DC MOTOR CONTROLLER, PDSO36
TLE6361G SWITCHING REGULATOR, 425 kHz SWITCHING FREQ-MAX, PDSO36
TLE6363G DUAL SWITCHING CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO14
TLE6365G SWITCHING REGULATOR, 115 kHz SWITCHING FREQ-MAX, PDSO8
TLE6387GV60 1 A SWITCHING CONTROLLER, 430 kHz SWITCHING FREQ-MAX, PDSO14
相關代理商/技術參數
參數描述
TLE6266GNT 制造商:Infineon Technologies AG 功能描述:CAN 125KBd Shutdown 5V Automotive 28-Pin DSO
TLE6270R 功能描述:基準電壓& 基準電流 POWERTRAIN RoHS:否 制造商:STMicroelectronics 產品:Voltage References 拓?fù)浣Y(jié)構:Shunt References 參考類型:Programmable 輸出電壓:1.24 V to 18 V 初始準確度:0.25 % 平均溫度系數（典型值）:100 PPM / C 串聯 VREF - 輸入電壓（最大值）: 串聯 VREF - 輸入電壓（最小值）: 分流電流（最大值）:60 mA 最大工作溫度:+ 125 C 封裝 / 箱體:SOT-23-3L 封裝:Reel
TLE6270RAUMA1 制造商:Infineon Technologies AG 功能描述:QUAD LOW SIDE INJECTOR DRIVER 制造商:Infineon Technologies AG 功能描述:ENGINECONTROL_IC - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC DRIVER INJECTOR QUAD DSO-36
TLE6280 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:3-Phase Bridge Driver IC
TLE6280GP 功能描述:馬達/運動/點火控制器和驅動器 GATE DRIVER ICS FOR EXTERNAL MOSFETS RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*