參數資料
型號: XRT75L00DIV
廠商: EXAR CORP
元件分類: 數字傳輸電路
英文描述: E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
中文描述: DATACOM, PCM TRANSCEIVER, PQFP52
封裝: 10 X 10 MM, TQFP-52
文件頁數: 47/92頁
文件大小: 894K
代理商: XRT75L00DIV
XRT75L00D
REV. 1.0.2
E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
42
8.0
DIAGNOSTIC FEATURES:
8.1
The XRT75L00D contains an on-chip Pseudo Random Binary Sequence (PRBS) generator and detector for
diagnostic purpose. This feature is only available in Host mode. With the PRBSEN bit = “1”, the transmitter will
send out PRBS of 2
23
-1 in E3 rate or 2
15
-1 in STS-1/DS3 rate. At the same time, the receiver PRBS detector is
also enabled. When the correct PRBS pattern is detected by the receiver, the RNEG/LCV pin will go “Low” to
indicate PRBS synchronization has been achieved. When the PRBS detector is not in sync the PRBSLS bit will
be set to “1” and RNEG/LCV pin will go “High”.
With the PRBS mode enabled, the user can also insert a single bit error by toggling “INSPRBS” bit. This is
done by writing a “1” to INSPRBS bit. The receiver at RNEG/LCV pin will pulse “High” for half RxClk cycle for
every bit error detected. Any subsequent single bit error insertion must be done by first writing a “0” to
INSPRBS bit and followed by a “1”.
When PRBS mode is enabled, the PRBS counter starts counting each single bit error. The PRBS counter is 16
bits wide. The current value in the counter can be read via two readback operations of the Serial I/O registers.
1) Either the Least Significant Byte (LSB, address 0x30) or the Most Significant Byte (MSB, address 0x31) can
be read first. The value of the un-read register will be copied into the Holding register (address 0x38) and both
the LSB and MSB registers will be reset to zero.
2) Read the Holding register and concatenate the result with the value from the first read operation to get the
full 16 bit counter value.
When the PRBS mode is first enabled, errors will be counted while the receiver logic is synchronizing to the
PRBS pattern. When RNEG/LCV goes “Low” indicating PRBS synchronization, reset the counter by reading
either the LSB or the MSB register.
Figure 25 shows the status of RNEG/LCV pin when the XRT75L00D is configured in PRBS mode.
PRBS Generator and Detector:
0x32-
0x37
Reserved
0x38
Read
Only
D[7:0]
PRBShold
PRBS Holding Register
0x39-
0x3D
Reserved
0x3E
Read
Only
D[7:0]
Chip_id
This read only register contains device id.
01010001
0x3F
Read
Only
D[7:0]
Chip_version
This read only register contains chip version number
00000001
A
DDRESS
(H
EX
)
T
YPE
B
IT
L
OCATION
S
YMBOL
D
ESCRIPTION
D
EFAULT
V
ALUE
(B
IN
)
相關PDF資料
PDF描述
XRT75L02 TWO CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER
XRT75L02IV TWO CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER
XRT75L03D THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
XRT75L04D FOUR CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
XRT75L04DIV FOUR CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
相關代理商/技術參數
參數描述
XRT75L00DIV-F 功能描述:外圍驅動器與原件 - PCI 1-Ch DS3, E3, SONET RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
XRT75L00DIVTR 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/SONET DE-SYNCH RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75L00DIVTR-F 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/SONET DE-SYNCH RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75L00ES 功能描述:時鐘合成器/抖動清除器 1CH T3/E3/STS1 LIU+JA 3.3V RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75L00IV 功能描述:外圍驅動器與原件 - PCI 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray