參數資料
型號: XRT75L00DIV
廠商: EXAR CORP
元件分類: 數字傳輸電路
英文描述: E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
中文描述: DATACOM, PCM TRANSCEIVER, PQFP52
封裝: 10 X 10 MM, TQFP-52
文件頁數: 49/92頁
文件大?。?/td> 894K
代理商: XRT75L00DIV
XRT75L00D
REV. 1.0.2
E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
44
8.2.1
In this mode, the transmitter outputs (TTIP and TRING) are connected internally to the receiver inputs (RTIP
and RRING) as shown in Figure 26. Data and clock are output at RCLK, RPOS and RNEG pins for the
corresponding transceiver. Analog loopback exercises most of the functional blocks of the device including the
jitter attenuator which can be selected in either the transmit or receive path.
XRT75L00D can be configured in Analog Loopback either in Hardware mode via the LLB and RLB pins or in
Host mode via LLB and RLB bits in the channel control registers.
ANALOG LOOPBACK:
N
OTES
:
1.
2.
In the Analog loopback mode, data is also output via TTIP and TRING pins.
Signals on the RTIP and RRING pins are ignored during analog loopback.
8.2.2
The Digital Loopback function is available either in Hardware mode or Host mode. When the Digital Loopback
is selected, the transmit clock (TxClk) and transmit data inputs (TPDATA & TNDATA) are looped back and
output onto the RxClk, RPOS and RNEG pins as shown in Figure 27. The data presented on TxClk, TPDATA
and TNDATA are not output on the TTIP and TRING pins.This provides the capability to configure the
protection card (in redundancy applications) in Digital Loopback mode without affecting the traffic on the
primary card.
N
OTE
:
Signals on the RTIP and RRING pins are ignored during digital loopback.
DIGITAL LOOPBACK:
F
IGURE
26. A
NALOG
L
OOPBACK
TRING
TTIP
RRING
RTIP
RPOS
RNEG
RCLK
TNDATA
TCLK
TPDATA
HDB3/B3ZS
1
ENCODER
HDB3/B3ZS
1
DECODER
J
A
J
A
TIMING
CONTROL
DATA &
CLOCK
RECOVERY
1
if enabled
2
if enabled and selected in either Receive or Transmit path
Tx
Rx
相關PDF資料
PDF描述
XRT75L02 TWO CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER
XRT75L02IV TWO CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER
XRT75L03D THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
XRT75L04D FOUR CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
XRT75L04DIV FOUR CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
相關代理商/技術參數
參數描述
XRT75L00DIV-F 功能描述:外圍驅動器與原件 - PCI 1-Ch DS3, E3, SONET RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
XRT75L00DIVTR 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/SONET DE-SYNCH RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75L00DIVTR-F 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/SONET DE-SYNCH RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75L00ES 功能描述:時鐘合成器/抖動清除器 1CH T3/E3/STS1 LIU+JA 3.3V RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75L00IV 功能描述:外圍驅動器與原件 - PCI 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray