參數資料
型號： XRT79L74IB
廠商： EXAR CORP
元件分類： 數字傳輸電路
英文描述： 4 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC
中文描述： ATM NETWORK INTERFACE, PBGA456
封裝： 27 X 27 MM, 1 MM PITCH, PLASTIC, BGA-456
文件頁數： 45/70頁
文件大?。?/td> 547K
代理商： XRT79L74IB
PRELIMINARY
XRT79L74
REV. P1.0.0
4 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC
43
AC12
AC16
AC8
AC20
RRING1
RRING2
RRING3
RRING4
I
I
I
I
Receive Input - Negative Polarity Signal:
These input pins, along the RTIPn input pins, function as the Receive DS3/E3
Line input signal receiver for the XRT79L74.
The user is expected to connect these signals and the RTIPn input signals to a
1:1 transformer.
Whenever the RTIP/RRING input pins are receiving a positive-polarity pulse
within the incoming DS3 or E3 line signal, then these input pins will be pulsed to
a "lower-voltage" than the RTIP input pins.
Conversely, whenever the RTIP/RRING input pins are receiving a negative-polar-
ity pulse within the incoming DS3 or E3 line signal, then these input pins will be
pulsed to a "higher-voltage" than the RTIP input pins.
K2
G26
L3
H25
CLKOUT1
CLKOUT2
CLKOUT3
CLKOUT4
O
O
O
O
SFM Synthesizer/Clock Recovery PLL Reference Clock Output:
The exact source of this output signal depends upon whether the XRT79L74
device has been configured to operate in the SFM (Single-Frequency Mode)
Mode, or not, as described below.If the XRT79L74 device is configured to oper-
ate in the SFM ModeIf the XRT79L74 device has been configured to operate in
the SFM Mode, then the CLKOUT output pin (if enabled) will output a
44.736MHz clock signal (if the XRT79L74 device is configured to operate in the
DS3 Mode) or a 34.368MHz clock signal (if the XRT79L74 device is configured to
operate in the E3 Mode.
N
OTE
:
1.In this case, the 44.736MHz or 33.368MHz clock (that is output via the
CLKOUT signal) will ultimately be derived from the 12.288MHz clock
signal that is being applied to the DS3CLK/SFMCLK input pin.
N
OTE
:
2.This output pin is only active if Bit 6 (SFM Clock Out Enable), within the
LIU Channel Control Register (Address = 0x1306) has been set to "1".
If the XRT79L74 device is NOT configured to operate in the SFM ModeIf the
XRT79L74 device has NOT been configured to operate in the SFM Mode, then
frequencies of the CLKOUT output signal will be as follows.
If the XRT79L74 device has been configured to operate in the DS3 Mode, then
the XRT79L74 device will simply output a buffered version of the signal that is
being applied to the DS3CLK/SFMCLK input pin (which should be a
44.736MHz clock signal).
If the XRT79L74 device has been configured to operate in the E3 Mode, then
the XRT79L74 device will simply output a buffered version of the signal that is
being applied to the E3CLK input pin (which should be a 34.368MHz clock
signal).
N
OTE
:
This output pin is only if Bit 6 (SFM Clock Out Enable), within the "LIU
Channel Control" Register (Address = 0x1306) has been set to "1".
P
IN
#
N
AME
TYPE
D
ESCRIPTION
相關PDF資料
PDF描述
XRT8000ID Clock Synchronizer/Adapter for Communications
XRT8000 Clock Synchronizer/Adapter for Communications(用于通訊的時鐘同步設備/調整器)
XRT8001 WAN Clock for T1 and E1 Systems
XRT8001ID WAN Clock for T1 and E1 Systems
XRT8001IP WAN Clock for T1 and E1 Systems
相關代理商/技術參數
參數描述
XRT8000 制造商:EXAR 制造商全稱:EXAR 功能描述:Clock Synchronizer/Adapter for Communications
XRT8000_06 制造商:EXAR 制造商全稱:EXAR 功能描述:Clock Synchronizer/Adapter for Communications
XRT8000D 制造商:EXAR 制造商全稱:EXAR 功能描述:CLOCK SYNCHRONIZER/ADAPTER FOR COMMUNICATIONS
XRT8000ES 功能描述:鎖相環 - PLL WAN CLOCK RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray
XRT8000ID 制造商:EXAR 制造商全稱:EXAR 功能描述:Clock Synchronizer/Adapter for Communications
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*