
PRODUCT SPECIFICATION
REVISION: ECR/ECN INFORMATION:
SHEET No.
EC No:
MG2007-0056
3
DATE:
2006 / 11 / 09
TITLE:
PRODUCT SPECIFICATION
HyperJack
TM 1000 PoE Module
85586 Series
4 of 58
DOCUMENT NUMBER:
CREATED / REVISED BY:
CHECKED BY:
APPROVED
PS-85586-001
S.Steinke
J.Hoennige
A. Vogt
TEMPLATE FILENAME:_PRODUCT_SPEC_X[SIZE_A4](V.1).DOC
1.3.
Features
Fully shielded RJ-45 connector with multiple ports (2x4 ports, 2x6 ports)
Integrated Ethernet magnetics with Bob Smith termination with isolation capacitor
Compatible with a variety of Gigabit Ethernet transceiver ICs (PHYs)
Compliant with IEEE 802.3ab standard and FCC68 dimension requirements
Compliant to Power over Ethernet IEEE 802.3af Standard
Dielectric isolation of 2250V DC (see page 20 for 1500V AC test setup)
ESD protection of PoE controller (air discharge
± 7kV (8KV),
loaded cable discharge with
± 2KV, discharge to shell 25KV)
Integrated opto-couplers provide module isolation, no external isolation of the PoE or I
2C
interface required
Two bi-color LED positions per port
Fully compatible Molex RJ-45 connector series without PoE functionality available (additional
rear-shield pin position required):
With this feature it is possible to build a cost saving NON-PoE Version using the same PCB
simply by mounting the appropriate NON-PoE connector version. (See appropriate Sales-
Drawing).
400KHz IC control interface.
Discovery, classification and real-time voltage and current measurements
Status information per port of the entire process along with parametric values of discovery,
classification and measurement results are accessible in read registers
Multi-point resistor discovery
AC or DC Disconnect
Thermal Management capabilities
Selectable Operation Modes:
Auto Mode (IEEE 802.3af Discovery, Classification, Power and DC disconnect without
external control)
Power Management Mode (All functions controlled externally using I
C bus)
Advanced Functionality available in Power Management Mode
Legacy detection of non-standard PDs
Power Management (system and port levels)
External Module Addressing allows control of up to four PoE Modules with a single I
C bus
Controlled current ramp power-up/down for EMI reduction
Fault detection:
Over/Undervoltage and Current faults
Over-temp protection and measurement per Port
Port Off Overvoltage Detection
Watchdog timers for communication and oscillator
Comprehensive Power Management Software available