- 您現在的位置：買賣IC網 > PDF目錄376998 > DSM2190F4V (意法半導體) 16-bit fixed point DSP with Flash PDF資料下載
參數資料
| 型號： | DSM2190F4V |
| 廠商： | 意法半導體 |
| 元件分類： | 數字信號處理 |
| 英文描述： | 16-bit fixed point DSP with Flash |
| 中文描述： | 具有閃存的 16 位定點 DSP |
| 文件頁數： | 16/61頁 |
| 文件大?。?/td> | 530K |
| 代理商： | DSM2190F4V |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁
DSM2190F4
16/61
DETAILED OPERATION
Figure 5 shows major functional areas of the de-
vice:
I
Flash Memories
I
PLDs (DPLD, CPLD, Page Register)
I
DSP Bus Interface (Address, Data, Control)
I
I/O Ports
I
Runtime Control Registers
I
JTAG ISP Interface
The following describes these functions in more
detail.
Flash Memories
The Main Flash memory array is divided into eight
equal 32K byte sectors. The Secondary Flash
memory array is divided into four equal 8K byte
sectors. Each sector is selected by the DPLD can
be separately protected from program and erase
cycles. This configuration is specified by using PS-
Dsoft Express
TM
.
Memory Sector Select Signals.
The DPLD gen-
erates the Select signals for all the internal memo-
ry blocks (see Figure 14). Each of the twelve
sectors of the Flash memories has a select signal
(FS0-FS7, or CSBOOT0-CSBOOT3) which con-
tains up to three product terms. Having three prod-
uct terms for each select signal allows a given
sector to be mapped into multiple areas of system
memory if needed.
Ready/Busy (PC3).
This signal can be used to
output the Ready/
Busy
status of the device. The
output on Ready/
Busy
is a 0 (Busy) when either
Flash memory array is being written, or
when ei-
ther Flash memory array is being erased. The out-
put is a 1 (Ready) when no Write or Erase cycle is
in progress. This signal may be polled by the DSP
or used as a DSP interrupt to indicate when an
erase or program cycle is complete.
Memory Operation.
The Flash memories are ac-
cessed through the DSP Address, Data, and Con-
trol Bus Interface.
DSPs and MCUs cannot write to Flash memory as
it would an SRAM device. Flash memory must first
be “unlocked” with a special sequence of byte
write operations to invoke an internal algorithm,
then a single data byte is written to the Flash mem-
ory array, then programming status is checked by
a byte read operation or by checking the Ready/
Busy
pin (PC3). Table 5 lists all of the special in-
struction sequences to program (write) data to the
Flash memory arrays, erase the arrays, and check
for different types of status from the arrays. These
instruction sequences are different combinations
of individual byte write and byte read operations.
IMPORTANT: The DSP may not read and execute
code from the same Flash memory array for which
it is directing an instruction sequence. Or more
simply stated, the DSP may not read code the
same Flash array that is writing or erasing. In-
stead, the DSP must execute code from an alter-
nate memory (like its own internal SRAM or a
different Flash array) while sending instructions to
a given Flash array. Since the two Flash memory
arrays inside the DSM device are completely inde-
pendent, the DSP may read code from one array
while sending instructions to the other.
After a Flash memory array is programmed (writ-
ten) it will go to “Read Array” mode, then the DSP
can read from Flash memory just as if would from
any 8-bit ROM or SRAM device.
相關PDF資料 |
PDF描述 |
|---|---|
| DSM2190F4V-15K6 | 16-bit fixed point DSP with Flash |
| DSM2190F4V-15T6 | 16-bit fixed point DSP with Flash |
| DSM3MA | GENERAL-USE RECTIFIER DIODE |
| DSP-A1092 | NATURAL SOUND AV AMPLIFIRE |
| DSP101 | DSP-Compatible Sampling Single/Dual ANALOG-TO-DIGITAL CONVERTERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSM2190F4V-15K6 | 功能描述:SPLD - 簡單可編程邏輯器件 3.3V 16M 150ns RoHS:否 制造商:Texas Instruments 邏輯系列:TICPAL22V10Z 大電池數量:10 最大工作頻率:66 MHz 延遲時間:25 ns 工作電源電壓:4.75 V to 5.25 V 電源電流:100 uA 最大工作溫度:+ 75 C 最小工作溫度:0 C 安裝風格:Through Hole 封裝 / 箱體:DIP-24 |
| DSM2190F4V-15T6 | 功能描述:SPLD - 簡單可編程邏輯器件 3.3V 16M 150ns RoHS:否 制造商:Texas Instruments 邏輯系列:TICPAL22V10Z 大電池數量:10 最大工作頻率:66 MHz 延遲時間:25 ns 工作電源電壓:4.75 V to 5.25 V 電源電流:100 uA 最大工作溫度:+ 75 C 最小工作溫度:0 C 安裝風格:Through Hole 封裝 / 箱體:DIP-24 |
| DSM-22LA | 制造商:Tenma 功能描述:Dual Digital Satellite Meter |
| DSM2C250 | 制造商:Molex 功能描述:REED SWITCH W/NC 3P M/MP 5M |
| DSM2C500 | 制造商:Molex 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。