- 您現在的位置：買賣IC網 > PDF目錄67672 > GT-48207 (Galileo Technology Services, LLC) Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高級交換式 10+10/100 BaseX以太網控制器) PDF資料下載
參數資料
| 型號： | GT-48207 |
| 廠商： | Galileo Technology Services, LLC |
| 英文描述： | Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高級交換式 10+10/100 BaseX以太網控制器) |
| 中文描述： | 先進的交換式以太網控制器的10 10/100 BaseX（高級交換式10 10/100 BaseX以太網控制器） |
| 文件頁數： | 77/135頁 |
| 文件大?。?/td> | 1619K |
| 代理商： | GT-48207 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁當前第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁
GT-482xx Switched Ethernet Controllers for 10+10/100 BaseX
GALI
LEO
TECHNOLOGY
CONFI
D
ENTI
AL
--
DO
NOT
REPRODUCE
46
Revision 1.2
IPG is programmable in the Serial Parameters register.
9.9
Partition Mode
A port enters Partition Mode when more than 32 consecutive collisions are seen on the port. When in Partition
Mode, the port continues to transmit but does not receive. The corresponding bit in the Status register is set when
a port is partitioned. A port is returned to normal operation mode when a good packet is seen on the wire.
9.9.1
Enabling Partition Mode
Partition is enabled (for all ports) by setting the enable bit in the GT-482xx Control Register. The default value is
Partition disabled for all ports. You must have a CPU in the system to enable partition mode; there is no pin strap-
ping option.
9.9.2
Entering Partition State
When Partition is enabled, a port will enter Partition state when either of the following two situations occur:
The port detects a collision on every one of 32 consecutive retransmit attempts of the same packet.
The port detects a single collision which occurs for more than 2048 bit times (i.e. most likely to occur in
AUI mode).
While in Partition state:
If the interrupt is not masked, the GT-482xx will issue an interrupt to the CPU upon entering Partition
state, and will set the partition bit of that port in the Status register.
The port will continue to transmit its pending packet, regardless of the collision detection, and will not fol-
low the usual Backoff Algorithm. A more aggressive Backoff Algorithm is in progress which is similar to
the Backoff Algorithm when Limit4 is activated. Additional packets pending for transmission are transmit-
ted, while ignoring the internal collision indication. This frees the port's transmit buffers which would oth-
erwise be filled up at the expense of the other ports' buffers. The assumption is that Partition is a system
failure situation (bad connector/cable/station), thus losing the transmitted packets is a small price to pay
versus the cost of halting the switch by filling up all of its buffers.
The Partition Indication is available via the LED interface (both the status led - blinking twice, and a dedi-
cated led - on constantly).
9.9.3
Exiting from Partition State
The port will exit from Partition state at the end of a successful packet transmission. A successful packet transmis-
sion will be declared, provided no collisions were detected on the first 512 bits of the transmission. If the interrupt
is not masked, the GT-482xx issues an interrupt to the CPU upon exiting from Partition state, and clears the parti-
tion bit of that port in the Status register.
9.10
802.1q VLAN Tagging Support
The GT-482xx has the ability to receive and transmit Ethernet frames up to 1536 bytes in length, thereby accom-
modating the IEEE 802.1q standard VLAN tagging bytes (four extra bytes or more.) This feature is enabled/dis-
abled by bit 13 in the Port Control register. The default is to disable this feature. Bytes longer than 1536 are
discarded as over-size frames.
9.11
Back Pressure
Back-pressure support in the 10Mbps ports is identical to the support for the 100Mbps ports, described previously.
9.12
Flow Control
Flow control support in the 10Mbps ports is identical to the support for the 100Mbps ports, described previously.
相關PDF資料 |
PDF描述 |
|---|---|
| GT-48208 | Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高級交換式 10+10/100 BaseX以太網控制器) |
| GT-48212 | Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高級交換式 10+10/100 BaseX以太網控制器) |
| GT-64010A | System Controller with PCI Interface for R4XXX/ R5000 Family CPUs(帶PCI接口用于R4XXX/ R5000 系列 CPUs的系統控制器) |
| GT-64012 | Secondary Cache Controller For the MIPS R4600/4650/4700/5000,(用于MIPS R4600/4650/4700/5000處理器的二級高速緩存控制器) |
| GT-64111 | System Controller for RC4640, RM523X and VR4300 CPUs(用于RC4640, RM523X和 VR4300 CPUs的系統控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GT48212-A6-PBB1C000 | 制造商:Marvell 功能描述: |
| GT48212-A6-PBB-C000 | 制造商:Marvell 功能描述:12 PORT E + 2 PORT FE SWITCH (MANAGED) - Trays |
| GT48300-A1-BBE1C083 | 制造商:Marvell 功能描述:Marvell GT48300-A1-BBE1C083 |
| GT48300-A1-BBE-C000 | 制造商:Marvell 功能描述:Marvell GT48300-A1-BBE-C000 |
| GT48300-A1-BBE-C08 | 制造商:Marvell 功能描述:MVLGT48300-A1-BBE-C083 4 PORT 83MHZ G.LI |
發布緊急采購，3分鐘左右您將得到回復。