參數資料
型號： IS43R16800A-6
廠商： Integrated Silicon Solution, Inc.
英文描述： 8Meg x 16 128-MBIT DDR SDRAM
中文描述： 8Meg × 16的128 - Mbit DDR SDRAM內存
文件頁數： 10/47頁
文件大?。?/td> 473K
代理商： IS43R16800A-6
10
Integrated Silicon Solution, Inc. — 1-800-379-4774
Rev. 00A
04/04/06
ISSI
IS43R16800A-6
FUNCTIONAL DESCRIPTION
The 128Mbit DDR SDRAM is a high-speed CMOS
device with four banks that operate at 2.5V. Each
32Mbit bank is organized as 4,096 rows of 512 columns
for the x16 option. Pre-fetch architecture allows Read
and Write accesses to be double-data rate and burst
oriented. Accesses start at a selected column location
and continue every half-clock cycle for a programmed
number of times. The Read or Write operation begins
with an Active command to transmit the selected bank
and row (A0-A11 bits are sampled). This is followed by
a Read or Write command to sample the address bits
again to determine the first column to access. When
access to the memory is not necessary, the device can
be put into a Power Down mode in which current
consumption is minimized. Prior to normal operation,
the device must be initialized in a defined procedure to
function properly. The following sections describe the
steps of initialization, the mode register definitions,
command descriptions, and device operation.
INITIALIZATION
The DDR SDRAM must be powered-on and initialized in
a series of defined steps for proper operation. First,
power is applied to VDD, and then to VDDQ. After
these have reached stable values, VREF and V
TT
are
ramped up. If this sequence is not followed, latch-up
could occur and cause damage to the device. The
input CKE must be asserted and held to a LVCMOS
Low level during this time to prevent unwanted com-
mands from being executed. The outputs I/O and DQS
remain in high impedance until driven during a normal
operation. Once VDD, VDDQ, V
TT
, VREF, and CKE are
stable values, the clock inputs can begin to be applied.
For a time period of at least 200μs, valid CK and
CK
cycles must be applied prior to any command being
issued to the device. CKE needs to then be raised to
SSTL 2 logic High and issue a NOP or Deselect
command to initialize the internal logic of the DRAM.
Next, a Pre-charge All command is given to the device,
followed by a NOP/Deselect command on each clock
cycle for at least tRP. The Load Extended Mode
Register should be issued to enable DLL, followed by
another series of NOP/Deselect commands for at least
tMRD. After this time, the Load Mode Register com-
mand should be issued to reset the DLL, again followed
by a series of NOP or Deselect commands for at least
tMRD. (Note: whenever the DLL is reset, 200 clock
cycles must occur prior to any Read command.) The
Pre-charge command is then issued, with NOP/
Deselect commands for at least tRP. Next, two Auto-
Refresh commands are issued, each followed by NOP/
Deselect commands for at least tRFC. At this point,
the JEDEC specification recommends that a DDR
SDRAM receive another Load Mode Register command
to clear the DLL, with NOP/Deselect commands for at
least tMRD. The device is now ready to receive a valid
command for normal operation.
POWER-UP SEQUENCE AFTER CKE GOES HIGH
相關PDF資料
PDF描述
IS43R16800A-6T 8Meg x 16 128-MBIT DDR SDRAM
IS43R16800A-6TL 8Meg x 16 128-MBIT DDR SDRAM
IS43R16800A1 8Meg x 16 128-MBIT DDR SDRAM
IS43R16800A1-5TL 8Meg x 16 128-MBIT DDR SDRAM
IS43R32400A 4Meg x 32 128-MBIT DDR SDRAM
相關代理商/技術參數
參數描述
IS43R16800A-6T 制造商:ISSI 制造商全稱:Integrated Silicon Solution, Inc 功能描述:8Meg x 16 128-MBIT DDR SDRAM
IS43R16800A-6TL 制造商:ISSI 制造商全稱:Integrated Silicon Solution, Inc 功能描述:8Meg x 16 128-MBIT DDR SDRAM
IS43R16800C-5TL 功能描述:動態隨機存取存儲器 128M 8Mx16 200MHz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS43R16800C-5TL-TR 功能描述:動態隨機存取存儲器 128M 8Mx16 200MHz RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS43R16800CC-5TL 功能描述:動態隨機存取存儲器 128M (8Mx16) 200MHz DDR 2.5v RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*